- 25 Nov, 2010 1 commit
-
-
Wey-Yi Guy authored
was not used, remove it Signed-off-by:Wey-Yi Guy <wey-yi.w.guy@intel.com>
-
- 24 Nov, 2010 31 commits
-
-
Felix Fietkau authored
It is no longer used anywhere Signed-off-by:
Felix Fietkau <nbd@openwrt.org> Signed-off-by:
John W. Linville <linville@tuxdriver.com>
-
Rajkumar Manoharan authored
Categorize AR7010 & AR9287 devices based on driver_info of usb_device_id, instead of PIDs. This avoids per-device cases and minimize code changes for new device addition. Signed-off-by:
Rajkumar Manoharan <rmanoharan@atheros.com> Signed-off-by:
-
Rajkumar Manoharan authored
AR9287 devices (PCI/USB) use different eeprom start location to read nvram. New devices might endup with same devid. So use driver_info to set offset, instead of devid. driver_info is valid for HTC devices alone which is filled in usb_device_id. Signed-off-by:
-
Rajkumar Manoharan authored
Added driver_info to identify AR7010, R9287 HTC devices. Signed-off-by:
-
Rajkumar Manoharan authored
The driver_info stores the device category information which is used to load appropriate device firmware, select firmware offset and eeprom starting location. The driver_info is accessed across ath9k_htc and ath9k_hw. Hence placed under common structure. Signed-off-by:
-
Wey-Yi Guy authored
For 6000g2b and up, adding advance power management support for better power consumption Signed-off-by:
-
Wey-Yi Guy authored
If shadow register is enable, modify the power management command to inform uCode Signed-off-by:
-
Wey-Yi Guy authored
Check the BT PSPoll flag when fill PM command to uCode Signed-off-by:
-
Wey-Yi Guy authored
Adding additional power management option available for the device. Signed-off-by:
-
Wey-Yi Guy authored
Bit 7 of BT config flag is used to enable/disable PSPoll sync. Make the name to match it. Signed-off-by:
-
Johannes Berg authored
For drivers that have accurate TX status reporting we can report the number of consecutive lost packets to userspace using the new cfg80211 CQM event. The threshold is fixed right now, this may need to be improved in the future. Signed-off-by:
Johannes Berg <johannes.berg@intel.com> Signed-off-by:
-
Johannes Berg authored
This adds the ability for drivers to use CQM events to notify about packet loss for specific stations (which could be the AP for the managed mode case). Since the threshold might be determined by the driver (it isn't passed in right now) it will be passed out of the driver to userspace in the event. Signed-off-by:
-
Bruno Randolf authored
Signed-off-by:
Bruno Randolf <br1@einfach.org> Signed-off-by:
-
Luis R. Rodriguez authored
This should help with latency issues which can happen when using aggregation. Cc: Felix Fietkau <nbd@openwrt.org> Cc: Matt Smith <matt.smith@atheros.com> Cc: Senthil Balasubramanian <senthilkumar@atheros.com> Signed-off-by:
Luis R. Rodriguez <lrodriguez@atheros.com> Signed-off-by:
-
Luis R. Rodriguez authored
This should help with latency issues which can happen when using aggregation. Cc: Matt Smith <matt.smith@atheros.com> Cc: Senthil Balasubramanian <senthilkumar@atheros.com> Signed-off-by:
-
Felix Fietkau authored
Since nullfunc frames are transmitted as unicast frames, they're more reliable than the broadcast probe requests, so we need fewer retries to figure out whether the AP is really gone. Signed-off-by:
-
Felix Fietkau authored
nullfunc frames are better for connection monitoring, because probe requests are answered even if the AP has already dropped the connection, whereas nullfunc frames from an unassociated station will trigger a disassoc/deauth frame from the AP (WLAN_REASON_CLASS3_FRAME_FROM_NONASSOC_STA), which allows the station to reconnect immediately instead of waiting until it attempts to transmit the next unicast frame. This only works on hardware with reliable tx ACK reporting, any other hardware needs to fall back to the probe request method. Signed-off-by:
-
Felix Fietkau authored
- store the multicast rate as an index instead of the rate value (reduces cpu overhead in a hotpath) - validate the rate values (must match a bitrate in at least one sband) Signed-off-by:
-
Felix Fietkau authored
Check the connection by probing the AP (either using nullfunc or a probe request). If nullfunc probing is supported and the assoc is no longer valid, the AP will send a disassoc/deauth immediately. Signed-off-by:
-
Felix Fietkau authored
Instead of using a fixed 2 second timeout, calculate beacon loss interval from the advertised beacon interval and a frame count. With this beacon loss happens after N (default 7) consecutive frames are missed which for a typical setup (100TU beacon interval) is ~700ms (or ~1/3 previous). Signed-off-by:
Sam Leffler <sleffler@chromium.org> Signed-off-by:
-
Felix Fietkau authored
Signed-off-by:
Paul Stewart <pstew@google.com> Signed-off-by:
-
Rafał Miłecki authored
Remove some typos, warnings, initialize some values to follow wl's code path. Signed-off-by:
Rafał Miłecki <zajec5@gmail.com> Signed-off-by:
-
Rafał Miłecki authored
Signed-off-by:
-
Rafał Miłecki authored
Signed-off-by:
-
Rafał Miłecki authored
Signed-off-by:
-
Rafał Miłecki authored
Signed-off-by:
-
Rafał Miłecki authored
Signed-off-by:
-
Rafał Miłecki authored
Additional comment by Larry Finger <Larry.Finger@lwfinger.net>: This change deserves a bit more explanation. You might include something like "These tables came from reverse engineering the 5.10.56.46 version of the Broadcom driver. Trace comparisons between b43 and the current Broadcom driver (5.10.120.0) show byte reversals for the PHY register writes." Signed-off-by:
-
Joe Perches authored
No change in output for pr_<level> prefixes. netdev_<level> output is different, arguably improved. Signed-off-by:
Joe Perches <joe@perches.com> Signed-off-by:
-
-
John W. Linville authored
This reverts commit 86107fd1. This patch inadvertantly changed the userland ABI. Signed-off-by:
-
- 23 Nov, 2010 1 commit
-
-
Guennadi Liakhovetski authored
Fix unbalanced call to sdio_release_host() on the error path. Signed-off-by:
Guennadi Liakhovetski <g.liakhovetski@gmx.de> Acked-by:
Larry Finger <Larry.Finger@lwfinger.net> Cc: stable@kernel.org Signed-off-by:
-
- 22 Nov, 2010 7 commits
-
-
Felix Fietkau authored
wireless-testing commit a05b5d45 ath9k: add support for reading eeprom from platform data on PCI devices This change moved the initialization of the AH_USE_EEPROM flag from ath9k_hw to ath9k. This needs to be added to ath9k_htc as well Signed-off-by:
-
Felix Fietkau authored
Under load, a large number of frames can produce decryption errors, even when no key cache update is being done. Performing a key search for every single frame in an A-MPDU improves reliability. Signed-off-by:
-
Joe Perches authored
Mark arrays const that are unmodified after initializations. text data bss dec hex filename 19291 56 4136 23483 5bbb drivers/net/wireless/zd1211rw/zd_chip.o.old 19291 56 4136 23483 5bbb drivers/net/wireless/zd1211rw/zd_chip.o.new Signed-off-by:
-
Joe Perches authored
Using static const generally increases object text and decreases data size. It also generally decreases overall object size. text data bss dec hex filename 40197 56 8336 48589 bdcd drivers/net/wireless/rt2x00/rt2800lib.o.new 40205 56 8336 48597 bdd5 drivers/net/wireless/rt2x00/rt2800lib.o.old Signed-off-by:
Gertjan van Wingerde <gwingerde@gmail.com> Signed-off-by:
-
Joe Perches authored
Using static const generally increases object text and decreases data size. It also generally decreases overall object size. text data bss dec hex filename 41757 2205 9896 53858 d262 drivers/net/wireless/rndis_wlan.o.old 41653 2205 9880 53738 d1ea drivers/net/wireless/rndis_wlan.o.new Changed functions rndis_set_oid and set_bssid to take const *'s. Signed-off-by:
-
Joe Perches authored
Using static const generally increases object text and decreases data size. It also generally decreases overall object size. text data bss dec hex filename 42607 3581 8536 54724 d5c4 drivers/net/wireless/ray_cs.o.new 42603 3585 8536 54724 d5c4 drivers/net/wireless/ray_cs.o.old Signed-off-by:
-
Joe Perches authored
Using static const generally increases object text and decreases data size. It also generally decreases overall object size. text data bss dec hex filename 3650 56 704 4410 113a drivers/net/wireless/libertas/rx.o.new 3695 56 704 4455 1167 drivers/net/wireless/libertas/rx.o.old 27328 964 5240 33532 82fc drivers/net/wireless/libertas/cfg.o.new 27328 964 5240 33532 82fc drivers/net/wireless/libertas/cfg.o.old Signed-off-by:
-
