- 11 Feb, 2011 7 commits
-
-
Jarkko Nikula authored
It is safe to use sleeping gpio in snd_soc_jack_gpio_detect as it is not called from interrupt context. This avoids WARN_ON from __gpio_get_value if sleeping gpio is registered for jack. Signed-off-by:
Jarkko Nikula <jhnikula@gmail.com> Acked-by:
Liam Girdwood <lrg@slimlogic.co.uk> Signed-off-by:
Mark Brown <broonie@opensource.wolfsonmicro.com>
-
Vinod Koul authored
This patch modifies the mfld_machine to use the new jack apis for adding the voltage zones for jack type detection. It also modifed TI sn95031 codec driver to use these new apis Signed-off-by:
Vinod Koul <vinod.koul@intel.com> Signed-off-by:
Harsha Priya <priya.harsha@intel.com> Acked-by:
-
Mark Brown authored
-
Mark Brown authored
This makes no real difference compared to the write sequencer sequence that was previously used but can run without a clock being provided. Also remove the write sequencer support code as this was the last use of it. Signed-off-by:
-
Mark Brown authored
The write sequencer sequencer sequence takes longer than is desirable as it brings up a full playback path which is not required at this point. Open coding the sequence cuts the startup time by two thirds. Signed-off-by:
-
Mark Brown authored
Signed-off-by:
-
Janusz Krzysztofik authored
Content of the CX20442's snd_soc_codec_driver.reg_cache_default pointed area, introduced with my recent NULL pointer dereferece fix (commit f019ee5f), occured wrong after further testing, more thorough than just booting successfully. There are two problems with it: 1) It should read (1 << CX20442_TELOUT) | (1 << CX20442_MIC), not CX20442_TELOUT | CX20442_MIC. 2) While correctly matching actual codec hardware state on boot when fixed per 1), a few more code modifications would still be required to reflect that state not only into register cache, but also force them into DAPM pins state, otherwise an inconsitency occures which may prevent further codec state changes from being applied correctly. As a result, the phone stops ringing after reboot, until someone picks up the handset for the first time. Revert that reg_cache_default content to a working, previous de facto default value of 0, in hope this change can still be accepted as an rc cycle fix. Created and tested against linux-2.6.38-rc4 Signed-off-by:
Janusz Krzysztofik <jkrzyszt@tis.icnet.pl> Acked-by:
-
- 10 Feb, 2011 1 commit
-
-
Mark Brown authored
Explicitly cache the DC servo offsets for digital paths in the driver, allowing them to be preserved over suspend and resume, and ensure that we recalibrate analogue outputs paths when they are in use so that we cover any changes in the input offset. Signed-off-by:
-
- 09 Feb, 2011 17 commits
-
-
Vinod Koul authored
This patch adds soc-jack support for adding voltage zones and for detecting jack type Signed-off-by:
-
Mark Brown authored
-
Mark Brown authored
ASoC generally uses the register defaults for everything, but in some cases the hardware will default to enabling some of the DAPM widgets (clocks for example). Ensure that DAPM knows about the actual widget state at initialisation by reading the enable bits after instantiating the widgets so they don't get left enabled needlessly. Signed-off-by:
-
Mark Brown authored
The WM8903 register map does not mute the DAC by default at startup so we need to explicitly do so. Signed-off-by:
-
Mark Brown authored
Signed-off-by:
-
Mark Brown authored
This simplfies the code and slightly reduces the startup time. Signed-off-by:
-
Mark Brown authored
Signed-off-by:
-
Mark Brown authored
Signed-off-by:
-
Mark Brown authored
It causes noisy -codecs to appear in things like .codec_name. Signed-off-by:
Stephen Warren <swarren@nvidia.com> Acked-by:
-
Vaibhav Bedia authored
This patch modifies the Davinci i2s and mcasp drivers to make use of ioremap() instead of IO_ADDRESS() Signed-off-by:
Vaibhav Bedia <vaibhav.bedia@ti.com> Acked-by:
-
Vaibhav Bedia authored
In case of any error in probe() function, clk_disable() and clk_put() should be called if clk_enable() and clk_get() went through. Signed-off-by:
-
Vaibhav Bedia authored
This patch modifies the Davinci i2s and mcasp drivers to make use of the resource_size() helper function for readability. Signed-off-by:
-
Vinod Koul authored
This patch adds support to read the mic bias voltage when a jack is inserted. It uses ADC to measure. Signed-off-by:
-
Vinod Koul authored
This patch adds support for registering jack interupt and registering jack with core Signed-off-by:
-
Vinod Koul authored
This patch adds support for jack detection and reporting in the codec It however is not fully functional as it doesn't measure adc to figure out what got inserted which will be added later Signed-off-by:
-
Stephen Warren authored
Signed-off-by:
-
Stephen Warren authored
Signed-off-by:
-
- 08 Feb, 2011 2 commits
-
-
Dan Carpenter authored
The patch c358e640 "ASoC: soc-cache: Add trace event for snd_soc_cache_sync()" introduced a dereference of "codec->cache_ops" before we had checked it for NULL. I pulled the check forward, and then pulled everything in an indent level. Signed-off-by:
Dan Carpenter <error27@gmail.com> Acked-by:
-
Alexander Sverdlin authored
Move Chip Select control out of the CODEC code for CS4271. Signed-off-by:
Alexander Sverdlin <subaparts@yandex.ru> Reviewed-by:
H Hartley Sweeten <hsweeten@visionengravers.com> Acked-by:
-
- 07 Feb, 2011 2 commits
-
-
Lars-Peter Clausen authored
The wm8753 codec supports switching between different DAI modes. The current drivers tries to implement this by changing the DAI driver at runtime. But to properly work this would require support from the ASoC core. So this patch takes a different approch on how the DAI mode switching is implemented. The only difference, from a driver point of view, between the different DAI modes is how to program the DAI format to the hardware. So what this patch is, it stores the current format for each DAI in the drivers private struct and when the DAI mode is changed the format gets simply reprogrammed according to the new DAI mode. Futhermore this patch restricts the changing of the DAI format to when the codec is inactive. Signed-off-by:
Lars-Peter Clausen <lars@metafoo.de> Acked-by:
-
Vinod Koul authored
Enabling medfield asoc driver causes compliation error when intel_sst is not selected ERROR: "register_sst_card" [sound/soc/mid-x86/snd-soc-sst-platform.ko] undefined! This patch puts proper dependency to elimate build error Signed-off-by:
Andrew Morton <akpm@linux-foundation.org> Signed-off-by:
-
- 04 Feb, 2011 1 commit
-
-
Mika Westerberg authored
Signed-off-by:
Mika Westerberg <mika.westerberg@iki.fi> Signed-off-by:
-
- 03 Feb, 2011 5 commits
-
-
Mark Brown authored
-
Mark Brown authored
On WM8994 revision D and earlier ensure optimal sequencing with simultaneous usage of AIF1 and AIF2 by tying the signals together so if paths through both are connected the streams are started simultaneously. Signed-off-by:
-
Mark Brown authored
Due to the different routing for AIF1 and AIF2 we weren't using a single widget to represent the ADCDAT signal. For consistency add one. Signed-off-by:
-
Vaibhav Bedia authored
McASP1 is used on the DA830/OMAP-L137 platform for the codec. This is different from the DA850/OMAP-L138 platform which uses McASP0. This is fixed by adding a new snd_soc_dai_link struct. Signed-off-by:
-
Mark Brown authored
Signed-off-by:
-
- 02 Feb, 2011 5 commits
-
-
Mark Brown authored
-
Janusz Krzysztofik authored
The .card member of the snd_soc_pcm_runtime structure pointed to by the snd_soc_dai_link.init() argument used to be initialized before the function being called. This has changed, probably unintentionally, after recent refactorings. Since the function implementations are free to make use of this pointer, move its assignment back before the function is called to avoid NULL pointer dereferences. Created and tested on Amstrad Delta againts linux-2.6.38-rc2 Signed-off-by:
-
Dimitris Papastamos authored
For some codecs with large register maps, it was not possible to dump all registers via the codec_reg file but only up to PAGE_SIZE bytes. This patch fixes this problem. Signed-off-by:
Dimitris Papastamos <dp@opensource.wolfsonmicro.com> Acked-by:
-
Sven Neumann authored
Signed-off-by:
Sven Neumann <s.neumann@raumfeld.com> Acked-by:
-
Mark Brown authored
Signed-off-by:
-
