- 20 Jul, 2010 5 commits
-
-
Yi Zou authored
The FCoE protocol stack may hold a lock when this gets called. Signed-off-by:
Yi Zou <yi.zou@intel.com> Signed-off-by:
Jeff Kirsher <jeffrey.t.kirsher@intel.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Yi Zou authored
When FCoE is disabled, there is a race condition that FCoE offload is turned off but the FCoE protocol driver is still queuing I/O thinking offload support still exists. This patch toggles off corresponding FCoE netdev feature flags and notify the FCoE stack first, allowing FCoE protocol stack driver to update its flags upon NETDEV_FEAT_CHANGE so no I/O will be using offload. Also, indicate FCoE offload flags in vlan_features in ixgbe_probe once and do not toggle them in ixgbe_fcoe_enable/disable so when FCoE is created on the VLAN interface, vlan_transfer_features() would properly update the VLAN netdev features flag and notify the FCoE protocol driver for NETDEV_FEAT_CHANGE. Signed-off-by:
Ross Brattain <ross.b.brattain@intel.com> Signed-off-by:
-
Alexander Duyck authored
This change removes UDP from the supported protocols for RSS hashing. The reason for removing this protocol is because IP fragmentation was causing a network flow to be broken into two streams, one for fragmented, and one for non-fragmented and this in turn was causing out-of-order issues. Signed-off-by:
Alexander Duyck <alexander.h.duyck@intel.com> Acked-by:
Don Skidmore <donald.c.skidmore@intel.com> Signed-off-by:
-
John Fastabend authored
Set the DPF bit when PFC is enabled. This will discard PFC frames so they do not get passed up the stack. The DPF bit is set for flow control, but not priority flow control this brings pfc inline with fc. Signed-off-by:
John Fastabend <john.r.fastabend@intel.com> Signed-off-by:
-
Alexander Duyck authored
This change makes it possible to limit the number of descriptors down to 48 per ring. The reason for this change is to address a variation on hardware errata 10 for 82546GB in which descriptors will be lost if more than 32 descriptors are fetched and the PCI-X MRBC is 512. Signed-off-by:
Emil Tantilov <emil.s.tantilov@intel.com> Signed-off-by:
-
- 19 Jul, 2010 16 commits
-
-
Andrew Morton authored
drivers/net/82596.c: In function 'i596_open': drivers/net/82596.c:1044: warning: label 'err_irq_dev' defined but not used Caused by "82596: free resources on error" Signed-off-by:
Andrew Morton <akpm@linux-foundation.org> Signed-off-by:
-
David S. Miller authored
As reported by Andrew: drivers/net/ks8842.c: In function 'ks8842_handle_rx': drivers/net/ks8842.c:428: warning: 'status' may be used uninitialized in this function Just use the 32-bit status for all reads, and delete the useless cast to 'int' when reading a u16 into 'len'. Reported-by:
-
Eric Dumazet authored
Use modern this_cpu_xxx() api, saving few bytes on x86 Signed-off-by:
Eric Dumazet <eric.dumazet@gmail.com> Signed-off-by:
-
Catalin Marinas authored
On SMP systems, the SMSC911x registers may be accessed by multiple CPUs and this seems to put the chip in an inconsistent state. The patch adds spinlocks to the smsc911x_reg_read, smsc911x_reg_write, smsc911x_rx_readfifo and smsc911x_tx_writefifo functions. Signed-off-by:
Catalin Marinas <catalin.marinas@arm.com> Signed-off-by:
-
Eric Dumazet authored
drivers/net/bonding/bond_main.c:179:12: warning: ‘disable_netpoll’ defined but not used Signed-off-by:
-
Christoph Egger authored
ARCH_PNX010X doesn't exist in Kconfig, therefore removing all references for it from the source code/Kconfig. Signed-off-by:
Christoph Egger <siccegge@cs.fau.de> Signed-off-by:
-
Shreyas Bhatewara authored
Respect the interrupt type set in VM configuration. When interrupt type is not auto, do not ignore the interrupt type set from VM configuration. Signed-off-by:
Shreyas Bhatewara <sbhatewara@vmware.com> Signed-off-by:
-
Shreyas Bhatewara authored
Hold rtnl_lock to get the right link state. While asynchronously resetting the device, hold rtnl_lock to get the right value from netif_running. If a reset is scheduled, and the device goes thru close and open, it may happen that reset and open may run in parallel. Holding rtnl_lock will avoid this. Signed-off-by:
-
Eric Dumazet authored
Since struct netdev_queue tx_bytes/tx_packets/tx_dropped are already protected by _xmit_lock, its easy to convert these fields to u64 instead of unsigned long. This completes 64bit stats for devices using them (vlan, macvlan, ...) Strictly, we could avoid the locking in dev_txq_stats_fold() on 64bit arches, but its slow path and we prefer keep it simple. Signed-off-by:
-
Eric Dumazet authored
After commit ad1afb00 (vlan_dev: VLAN 0 should be treated as "no vlan tag" (802.1p packet)), bond_inet6addr_event() might be called with a NULL bond->vlgrp pointer, and a non empty bond->vlan_list. vlan_group_get_device() is dereferencing a NULL pointer. Signed-off-by:
-
Tobias Klauser authored
The memory for the private data is allocated using kzalloc in alloc_etherdev (or alloc_netdev_mq respectively) so there is no need to set it to 0 again. Signed-off-by:
Tobias Klauser <tklauser@distanz.ch> Signed-off-by:
-
David S. Miller authored
Signed-off-by: -
Richard Cochran authored
This patch adds a new networking option to allow hardware time stamps from PHY devices. When enabled, likely candidates among incoming and outgoing network packets are offered to the PHY driver for possible time stamping. When accepted by the PHY driver, incoming packets are deferred for later delivery by the driver. The patch also adds phylib driver methods for the SIOCSHWTSTAMP ioctl and callbacks for transmit and receive time stamping. Drivers may optionally implement these functions. Signed-off-by:
Richard Cochran <richard.cochran@omicron.at> Signed-off-by:
-
Richard Cochran authored
Certain kinds of hardware time stamping units in both MACs and PHYs have the limitation that they can only time stamp PTP packets. Drivers for such hardware are left with the task of correctly matching skbs to time stamps. This patch adds a BPF that drivers can use to classify PTP packets when needed. Signed-off-by:
-
Richard Cochran authored
The phy_mii_ioctl() function unnecessarily throws away the original ifreq. We need access to the ifreq in order to support PHYs that can perform hardware time stamping. Two maverick drivers filter the ioctl commands passed to phy_mii_ioctl(). This is unnecessary since phylib will check the command in any case. Signed-off-by:
-
Richard Cochran authored
This patch adds a hook for transmit time stamps. The transmit hook allows a software fallback for transmit time stamps, for MACs lacking time stamping hardware. Using the hook will still require adding an inline function call to each MAC driver. Signed-off-by:
-
- 18 Jul, 2010 8 commits
-
-
Pedro Garcia authored
- Without the 8021q module loaded in the kernel, all 802.1p packets (VLAN 0 but QoS tagging) are silently discarded (as expected, as the protocol is not loaded). - Without this patch in 8021q module, these packets are forwarded to the module, but they are discarded also if VLAN 0 is not configured, which should not be the default behaviour, as VLAN 0 is not really a VLANed packet but a 802.1p packet. Defining VLAN 0 makes it almost impossible to communicate with mixed 802.1p and non 802.1p devices on the same network due to arp table issues. - Changed logic to skip vlan specific code in vlan_skb_recv if VLAN is 0 and we have not defined a VLAN with ID 0, but we accept the packet with the encapsulated proto and pass it later to netif_rx. - In the vlan device event handler, added some logic to add VLAN 0 to HW filter in devices that support it (this prevented any traffic in VLAN 0 to reach the stack in e1000e with HW filter under 2.6.35, and probably also with other HW filtered cards, so we fix it here). - In the vlan unregister logic, prevent the elimination of VLAN 0 in devices with HW filter. - The default behaviour is to ignore the VLAN 0 tagging and accept the packet as if it was not tagged, but we can still define a VLAN 0 if desired (so it is backwards compatible). Signed-off-by:
Pedro Garcia <pedro.netdev@dondevamos.com> Signed-off-by:
-
Tetsuo Handa authored
MAX_SOCK_ADDR is no longer used because commit 230b1839 "net: Use standard structures for generic socket address structures." replaced "char address[MAX_SOCK_ADDR];" with "struct sockaddr_storage address;". Signed-off-by:
Tetsuo Handa <penguin-kernel@I-love.SAKURA.ne.jp> Signed-off-by:
-
Dan Carpenter authored
probe_irq_off() returns the first irq found or if two irqs are found then it returns the negative of the first irq found. We can cast dev->irq to an int so that the test for negative values works. Signed-off-by:
Dan Carpenter <error27@gmail.com> Signed-off-by:
-
Kulikov Vasiliy authored
'gap' is unsigned, so this code is wrong: gap = -new_head; ... if (gap > 0) { ... } Make 'gap' signed. The semantic patch that finds this problem (many false-positive results): (http://coccinelle.lip6.fr/) // <smpl> @ r1 @ identifier f; @@ int f(...) { ... } @@ identifier r1.f; type T; unsigned T x; @@ *x = f(...) ... *x > 0 Signed-off-by:Kulikov Vasiliy <segooon@gmail.com> Signed-off-by:
-
Amit Kumar Salecha authored
pci_get_domain_bus_and_slot: caller must decrement the reference count by calling pci_dev_put(). Signed-off-by:
Amit Kumar Salecha <amit.salecha@qlogic.com> Signed-off-by:
-
Shreyas Bhatewara authored
This change initializes the state of link at the time when driver is loaded. The ethtool output for 'link detected' and 'link speed' is thus valid even before the interface is brought up. Signed-off-by:
-
Stanislaw Gruszka authored
Use DMA API as PCI equivalents will be deprecated. This change also allow to allocate with GFP_KERNEL in some places. Signed-off-by:
Stanislaw Gruszka <sgruszka@redhat.com> Acked-by:
Michael Chan <mchan@broadcom.com> Signed-off-by:
-
Stanislaw Gruszka authored
Signed-off-by:
-
- 16 Jul, 2010 11 commits
-
-
Casey Leedom authored
Fix SGE resource resource deallocation bug. Forgot to increment the RXQ and TXQ cursors in the loop ... Signed-off-by:
Casey Leedom <leedom@chelsio.com> Signed-off-by:
-
Ronghua Zang authored
A new bit map 'intrCtrl' is introduced in the DriverShared area. The driver should update VMXNET3_IC_DISABLE_ALL bit before writing IMR. Signed-off-by:
Ronghua Zang <ronghua@vmware.com> Signed-off-by:
-
Shreyas Bhatewara authored
Fix LRO feature update. Signed-off-by:
-
Eric Dumazet authored
Correct comment stating sizeof(struct tcp_skb_cb) is 36 or 40, since its 44 bytes, since commit 951dbc8a ([IPV6]: Move nextheader offset to the IP6CB). Signed-off-by:
-
Jon Mason authored
Version update Signed-off-by:
Jon Mason <jon.mason@exar.com> Signed-off-by:
Sreenivasa Honnur <sreenivasa.honnur@exar.com> Signed-off-by:
Ramkrishna Vepa <ramkrishna.vepa@exar.com> Signed-off-by:
-
Jon Mason authored
Update and correct maintainers information Signed-off-by:
-
Jon Mason authored
Update copyright information to reflect the Exar purchase of Neterion Signed-off-by:
-
Jon Mason authored
NETIF_F_LLTX and it's usage of local transmit locks are depricated in favor of using the netdev queue's transmit lock. Remove the local lock and all references to it, and use the netdev queue transmit lock in the transmit completion handler. Signed-off-by:
-
Jon Mason authored
Fix error in multicast flag check, add calls to restore the status of multicast and promiscuous mode settings after change_mtu, and style cleanups to shorten the function calls by using a temporary variable. Signed-off-by:
-
Jon Mason authored
Remove queue_state references, as they are no longer necessary. Also, The driver needs to start/stop the queue regardless of which type of steering is enabled. Remove checks for TX_MULTIQ_STEERING only and start/stop for all steering types. Signed-off-by:
-
Kulikov Vasiliy authored
ipv6_skip_exthdr() can return error code that is below zero. 'offset' is unsigned, so it makes no sense. ipv6_skip_exthdr() returns 'int' so we can painlessly change type of offset to int. Signed-off-by:
Stephen Hemminger <shemminger@vyatta.com> Signed-off-by:
-
