We'll need the link e.g. for decrypt, and shouldn't be
looking it up all the time later, so track it in the RX
data.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

For drivers using software encryption for multicast TX, such
as mac80211_hwsim, mac80211 needs to duplicate the multicast
frames on each link, if MLO is enabled. Do this, but don't
just make it dependent on the key but provide a separate flag
for drivers to opt out of this.

This is not very efficient, I expect that drivers will do it
in firmware/hardware or at least with DMA engine assistence,
so this is mostly for hwsim.

To make this work, also implement the SNS11 sequence number
space that an AP MLD shall have, and modify the API to the
__ieee80211_subif_start_xmit() function to always require the
link ID bits to be set.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

There are a couple of new things that should be possible
with MLO:
 * selecting the link to transmit to a station by link ID,
   which a previous patch added to the nl80211 API
 * selecting the link by frequency, similarly
 * allowing transmittion to an MLD without specifying any
   channel or link ID, with MLD addresses

Enable these use cases. Also fix the address comparison
in client mode to use the AP (MLD) address.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

Allow optionally specifying the link ID to transmit on,
which can be done instead of the link frequency, on an
MLD addressed frame. Both can also be omitted in which
case the frame must be MLD addressed and link selection
(and address translation) will be done on lower layers.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

For frames received on an MLD, report the link ID to
userspace.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

If given by the underlying driver, report the link ID for
MLO in NL80211_CMD_FRAME.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

When the low level driver reports hardware timestamps for frame
TX status or frame RX, pass the timestamps to cfg80211.
Signed-off-by: Avraham Stern <avraham.stern@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

Add hardware timestamps to management frame RX info.
This shall be used by drivers that support hardware timestamping for
Timing measurement and Fine timing measurement action frames RX.
Signed-off-by: Avraham Stern <avraham.stern@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

The functions for reporting rx management take many arguments.
Collect all the arguments into a struct, which also make it easier
to add more arguments if needed.
Signed-off-by: Avraham Stern <avraham.stern@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

Add a function for reporting TX status with hardware timestamps. This
function shall be used for reporting the TX status of Timing
measurement and Fine timing measurement action frames by devices that
support reporting hardware timestamps.
Signed-off-by: Avraham Stern <avraham.stern@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

Add attributes for reporting hardware timestamps for management frames
RX and TX. These attributes will be used for reporting hardware
timestamps for Timing measurement and Fine Timing Measurement action
frames, which will allow userspace applications to measure the path
delay between devices and sync clocks.

For TX, these attributes are used for reporting the frame RX time and
the ack TX time. For TX, they are used for reporting the frame TX time
and the ack RX time.
Signed-off-by: Avraham Stern <avraham.stern@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

Add helper functions for detection timing measurement
and fine timing measurement frames.
Signed-off-by: Avraham Stern <avraham.stern@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

For wmediumd/virtio, handle both the RX channel for links,
as well as the link addresses when links are added/removed.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

When inserting a link STA, make sure it doesn't exist first
and add lockdep assertions that we cannot modify the hash
table without holding the sta_mtx, so this check is really
correct.

Also return without hashing if the driver failed, and warn
if the hashing fails, which shouldn't happen due to the
check described above.

Fixes: cb71f1d1 ("wifi: mac80211: add sta link addition/removal")
Fixes: ba6ddab9 ("wifi: mac80211: maintain link-sta hash table")
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

We need to copy the address to both the private and public
portion of the link_sta (the private one is needed for the
hash table). Fix this.

Fixes: bbe90107 ("wifi: mac80211: mlme: refactor link station setup")
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

Clarify the link ID behaviour in control port TX, we need it
to select the link to transmit on for both MLD and non-MLD
receivers, but select the link address as the SA only if the
receiver is not an MLD.

Fixes: 67207bab ("wifi: cfg80211/mac80211: Support control port TX from specific link")
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

If the frame is going to be dropped anyway because
ieee80211_lookup_ra_sta() returned an error (and
even though it's a bit racy, it will likely continue
to do so), return the error out instead of just
silently dropping the frame.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

We always need the MLD address and link ID to add or
modify the link STA, so require it in the API.

Fixes: 577e5b8c ("wifi: cfg80211: add API to add/modify/remove a link station")
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

Add more sanity checks to the API handling, we shouldn't
be able to create a station without links, nor should we
be able to add a link to a station that wasn't created as
an MLD with links in the first place.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

There are two issues here: we unhash the link stations only
directly before freeing the station they belong to, and we
also don't unhash all the links correctly in all cases. Fix
these issues.

Fixes: ba6ddab9 ("wifi: mac80211: maintain link-sta hash table")
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

When modifying a link station, validate that the link address
doesn't change, except the first time the link is created.

Fixes: b95eb7f0 ("wifi: cfg80211/mac80211: separate link params from station params")
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

At this point, we've already changed link_id to be zero for
a non-MLO connection, so use the 'mlo' variable rather than
link ID to determine the MLO status of the station.

Fixes: bd363ee5 ("wifi: mac80211: mlme: set sta.mlo correctly")
Fixes: 81151ce4 ("wifi: mac80211: support MLO authentication/association with one link")
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

If there's a non-MLO client, the A2 must be set to the BSSID
of the link since no translation will happen in lower layers
and it's needed that way for encryption.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

There are two issues here: we need to do the translation
even in case mac80211 selected a link, and we should only
translate the A3 if it's the BSSID. Fix both.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

We should only translate addr3 here if it's the BSSID.

Fixes: 42fb9148 ("wifi: mac80211: do link->MLD address translation on RX")
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

If we have a non-MLD STA on an AP MLD, we crash while
adding the station. Fix that, in this case we need to
use the STA's address also on the link data structure.

Fixes: f36fe0a2 ("wifi: mac80211: fix up link station creation/insertion")
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

In my previous changes here, I neglected to take the old
conn_flags into account that might still be present from
the authentication, and thus ieee80211_setup_assoc_link()
can misbehave, as well as the override calculation being
wrong. Fix that by ORing in the old flags.

Fixes: 1845c1d4 ("wifi: mac80211: mlme: refactor assoc link setup")
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

In a few places we need to use the AP (MLD) address, not the
deflink BSSID, the link address translation will happen later.

To make that work properly for fast-xmit, set up the ap_addr
in the vif.cfg earlier.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

Delete the redundant word 'the'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220710043405.38304-1-yuanjilin@cdjrlc.com

Delete the redundant word 'the'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220710043007.33288-1-yuanjilin@cdjrlc.com

Delete the redundant word 'not'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220710042546.28504-1-yuanjilin@cdjrlc.com

Delete the redundant words 'in' and 'scan'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220710042040.22456-1-yuanjilin@cdjrlc.com

Delete the redundant words 'is' and 'with'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220710041442.16177-1-yuanjilin@cdjrlc.com

Delete the redundant word 'the'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220710041005.10950-1-yuanjilin@cdjrlc.com

Delete the redundant words 'to' and 'if'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220709135316.41425-1-yuanjilin@cdjrlc.com

Delete the redundant word 'the'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220709134701.36081-1-yuanjilin@cdjrlc.com

Delete the redundant word 'the'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220709134207.30856-1-yuanjilin@cdjrlc.com

Delete the redundant words 'this' and 'and'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220709133618.25958-1-yuanjilin@cdjrlc.com

Delete the redundant word 'early'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220709133119.21076-1-yuanjilin@cdjrlc.com

Delete the redundant word 'long'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/20220709132637.16717-1-yuanjilin@cdjrlc.com