Signed-off-by: Borislav Petkov <petkov@uni-muenster.de>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Hello,
this is a small patch of the USB ftdi_sio driver against linux-2.6.8.1.
I only added a new vendor and product id for the RM-CANview,
a CAN fieldbus interface:
http://www.rmcan.com/site/en/products/gateways/usb/index.htm

Thanks
Heinz
Signed-off-by: Heinz-Juergen Oertel <oe@port.de>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Also, as the full patch isn't going in, can you please apply this tiny
part of it? Somehow the header descriptor was omitted from the CDC ACM
driver, but it's present on my phone (thus giving me the "ignoring extra
header" error when it's plugged in) and in the CDC spec (section 5.2.3.1).
Signed-off-by: Alex Kanavin <ak@sensi.org>
Signed-Off-By: Oliver Neukum <oliver@neukum.name>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

The following patch changes the 0x059f/0xa601/0x0200 per the report from
  Torsten Eriksson. It adds comments to the uncommented entry and
changes the subclass.
Signed-off-by: Phil Dibowitz <phil@ipom.com>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Here's another USB mass storage device that incorrectly reports the total
number of disk blocks.  Please apply.
Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

This removes a duplicate entry and fixes order. Trivial.
Signed-off-by: Phil Dibowitz <phil@ipom.com>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Here's a patch to remove the three Genesys disk entries in
unusual_devs.

They don't appear to be needed anymore because:
1. The inquiries now request the right amount of data
2. MODE_XLATE, according to Alan, isn't used in 2.6
Signed-off-by: Phil Dibowitz <phil@ipom.com>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

This removes the 0a16/8888/0100 unusual_devs entry for an IBM USB
Storag key. It does not appear to be needed and caused issues for
Buddha Henry <spanishbuddha@hotmail.com>, who has tested with this
patch and his device works properly.
Signed-off-by: Phil Dibowitz <phil@ipom.com>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

The following is needed for Winward Music Disk. I narrowed the range of
the original patch which was sent by Stephan Walter.


From: Stephan Walter <stephan.walter@epfl.ch>
Signed-off-by: Phil Dibowitz <phil@ipom.com>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Stephan Fuhrmann sent in the entry for a device needing the new RESIDUE
flag. Here is an appropriate tested patch.


From: Stephan Fuhrmann <atomenergie@t-online.de>
Signed-off-by: Phil Dibowitz <phil@ipom.com>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

There are several cameras (1300s and 1400s) with the same bcdDevice
number (1000). Most of them are 8070 devices, but some of them are UFI
devices (similar to 8070 devices but don't clear the sense data after
an INQUIRY or REQUEST SENSE). Furthermore if the devices that truely
do act like 8070 devices are overridden to be UFI, they find more than
one LUN. Specifiying UFI and SINGLE_LUN seems to satisfy all kinds of
devices that claim device number 1000.


From: Pavel Machek <pavel@ucw.cz>
Signed-off-by: Phil Dibowitz <phil@ipom.com>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

 - Don't free pages with kfree()
 - Clean up debugging messages
 - Print name of firmware file loaded.
Signed-off-by: Duncan Sands <baldrick@free.fr>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Reduce size of struct udsl_control to make it fit in skb->cb, by
dropping the cell_header and generating it later instead of storing
it.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: Duncan Sands <baldrick@free.fr>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

into kroah.com:/home/greg/linux/BK/usb-2.6

Fixes a data corruption issue. Because of a typo in the driver, IO packets
were wrongly shared by the IOCTL path. This caused the whole IO command
to be replaced by an incoming IOCTL command.

ACPI still explodes on my old PII and stops it booting.

Anyway, it is oopsing in drivers/acpi/scan.c line 207 where element
(which is NULL) gets dereferenced.

The ACPI bios on this thing has always seemed to be pretty broken, but
this at least allows the 'power' button to continue to work (the only
reason why I want ACPI).

As spotted by one of our Fedora users, we sometimes
oops during shutdown (http://www.roberthancock.com/kerneloops.png)
because disable_IO_APIC() wants to call find_isa_irq_pin(),
which we threw away during init.
Signed-off-by: Dave Jones <davej@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

into ppc970.osdl.org:/home/torvalds/v2.6/linux

"lapic" is available to force enabling the LAPIC
in the event you know more than your BIOS vendor.
http://bugzilla.kernel.org/show_bug.cgi?id=3238

This is made possible by the previous resource allocation ordering
patch.

Now that we run the pre-existing PCI resource discovery _before_
ACPI resources have been added, we should not "insert" the resources
into any existing tree. If they clash with existing resources, we
should re-allocate them (later, when we have the full resource map).

This re-orders the PCI and ACPI IO resource assignment as suggested by
Linus.

With this patch, now the sequence of reserving resources is:
 1. PCI claim BAR
 2. ACPI reserve motherboard resources
 3. PNP reserve motherboard resources
 4. PCI allocate resources for uninitialized PCI devices

This way the kernel allocates new PCI resources after it has full
knowledge of the resource state, and at the same time allows ACPI and
PnP to be run _after_ we've filled in our knowledge about pre-allocated
resources. 

The way it is done is to make the last phase of the original PCI assign
resources code to be an 'fs_initcall', along with the ACPI and PnP
initializations.
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

From: Jens Axboe <axboe@suse.de>

The blacklist stuff is broken. When set_using_dma() calls into
->ide_dma_check(), it returns __ide_dma_off() for a blacklisted drive.
This of course succeeds, returning success to the caller of ->ide_dma_check().
Not so good... It then uncondtionally calls ->ide_dma_on(), which turns on
DMA for the drive.

This moves the check to __ide_dma_on() so we also catch the buggy
->ide_dma_check() defined by various chipset drivers.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

Doing so apparently breaks every Dell on Earth.
http://bugzilla.kernel.org/show_bug.cgi?id=3238

FB_NEOMAGIC needs FB_MODE_HELPER (for vesa_modes).

Reported by Michel Angelo da Silva Pereira.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

Patch from Sascha Hauer

This patch supports the Hynix developer boards h7201 and h7202 for the
HMS30C7201 and HMS30C7202 CPUs.

Changes to previous patch:
- reorganized file structure. We now have common.c which shares stuff
  common to all h720x processors and cpu-h720[12].c files for the cpu
  specific stuff
- fixed timer handling for timers 1/2
- cleaned up h720x register definitions and splitted in files specific
  to each cpu and one generic part

Signed-off-by: Thomas Gleixner
Signed-off-by: Robert Schwebel
Signed-off-by: Sascha Hauer

This fixes the "Ignoring changed section attributes" warning by commenting
out the attributes appended by gcc.

The previous 'fix' created a section '.text,#alloc' (literally), which I
guess was not intended.
Signed-off-by: Clemens Buchacher <drizzd@aon.at>
Signed-off-by: William Irwin <wli@holomorphy.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Since get_cpu_ptr() went away, we probably shouldn't tease developers by
telling them to use it in the comments.
Signed-off-by: Jonathan Corbet <corbet@lwn.net>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

The cpu mask fix-ups in 2.6.8 broke SMP kernels booting on a DP264.
Instead of not setting the DIM for cpus that did not exit, the patch
inadvertently doesn't set the DIM for CPUs that do exist.  Thus no device
interrupts get to the cpu.
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

qeth network driver changes:
 - Unlock queue in qeth_do_sent_packet if there is no empty buffer
   in packing state.
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>