From: Randy Hron <rwhron@earthlink.net>

From: Randy Hron <rwhron@earthlink.net>

From: Randy Hron <rwhron@earthlink.net>

From: Randy Hron <rwhron@earthlink.net>

From: Randy Hron <rwhron@earthlink.net>

Replace macro with inline and get some type checking.

I finally found some time to hack the depca driver, in basically the
same way I did with the de4x5 driver. The patch is quite big (shuffles
a lot of code around, removes lots of global variables), mainly in
order to use the driver model on every bus supported by this driver.

I also removed the probing from Space.c, so the usual warning about
device renumbering applies.

Tested on alpha (DE422, EISA) and i386 (two DE201, ISA), built-in and
modular. The MCA part is completly untested, since I lack the hardware
(no, I do not own every single piece of junk hardware out
there... ;-).

into laptop.osdl.org:/home/torvalds/v2.5/linux

into laptop.osdl.org:/home/torvalds/v2.5/linux

Drop support for old param struct method, and clean up code.

Fix the AMBA kmi driver which got broken when the name field was
removed from struct device.  Change the name used to claim resources
to "kmi-pl050".  Fix resume method.

Patch from Nicolas Pitre

We were mixing some data and code in the processor support assembly
files.  Place the correct objects into their respective sections.

This renames all 48 (800K-ish of) ARM default configuration files,
as required by Sam's latest default configuration file system.

into laptop.osdl.org:/home/torvalds/v2.5/linux

into laptop.osdl.org:/home/torvalds/v2.5/linux

into kernel.bkbits.net:/home/lord/xfs-2.6

values in jiffies like everybody else

SGI Modid: 2.5.x-xfs:slinx:158665a

makes the just the inode look dirty, and not the inode and the data.

SGI Modid: 2.5.x-xfs:slinx:158670a

into penguin.americas.sgi.com:/src/lord/bitkeeper/xfs-2.6

SGI Modid: 2.5.x-xfs:slinx:158642a

The VIDC/FIDC controls could have been left at 1 from a previous call to
one of the scaling routines. Make sure we set them back to 0 to avoid
writing garbage into the scaling registers.

We were 'slightly' off in our calculations. This increased settling
time might actually increase the stability of some setups.

Very silly bug spotted by Ducrot Bruno

By mistake the keycode for right control in scancode set 3
was the same as that for right alt. This fixes that.

From: Nick Piggin <piggin@cyberone.com.au>

This should be the last piece to ensure correct barrier handling for AS
and DL?

into laptop.osdl.org:/home/torvalds/v2.5/linux