Stop handing garbage to userspace in the case where a weird server clears the
 acl bit in the getattr return (despite the fact that they've already claimed
 acl support.)
Signed-off-by: J. Bruce Fields <bfields@citi.umich.edu>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 This patch stops the release_pipe() funtion from being called
 twice by invalidating the ops pointer in the rpc_inode
 when rpc_pipe_release() is called.
Signed-off-by: Steve Dickson <steved@redhat.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 Storing a pointer to the struct rpc_task in the nfs_seqid is broken
 since the nfs_seqid may be freed well after the task has been destroyed.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 If someone tries to rename a directory onto an empty directory, we
 currently fail and return EBUSY.
 This patch ensures that we try the rename if both source and target
 are directories, and that we fail with a correct error of EISDIR if
 the source is not a directory.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 We currently fail Connectathon test 6.10 in the case of 32-bit locks due
 to incorrect error checking.
 Also add support for l->l_len < 0 to 64-bit locks.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 If the server is in the unconfirmed OPEN state for a given open owner
 and receives a second OPEN for the same open owner, it will cancel the
 state of the first request and set up an OPEN_CONFIRM for the second.

 This can cause a race that is discussed in rfc3530 on page 181.

 The following patch allows the client to recover by retrying the
 original open request.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 Unless of course the open fails due to permission issues.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 This will allow nfs_permission() to perform additional optimizations when
 walking the path, by folding the ACCESS(MAY_EXEC) call on the directory
 into the lookup revalidation.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 Since it appears that some servers don't...
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 Make NFSv4 return the fully initialized file pointer with the
 stateid that it created in the lookup w/intent.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 This is needed by NFSv4 for atomicity reasons: our open command is in
 fact a lookup+open, so we need to be able to propagate open context
 information from lookup() into the resulting struct file's
 private_data field.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 ...and fix a memory corruption bug due to improper use of memcpy() on
 a struct file_lock.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 Currently we fail to do so if the process was signalled.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 We no longer need to worry about collisions between close() and the state
 recovery code, since the new close will automatically recheck the
 file state once it is done waiting on its sequence slot.

 Ditto for the nfs4_proc_locku() procedure.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 OPEN, CLOSE, etc no longer need these semaphores to ensure ordering of
 requests.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 Once the state_owner and lock_owner semaphores get removed, it will be
 possible for other OPEN requests to reopen the same file if they have
 lower sequence ids than our CLOSE call.
 This patch ensures that we recheck the file state once
 nfs_wait_on_sequence() has completed waiting.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 NFSv4 file state-changing functions such as OPEN, CLOSE, LOCK,... are all
 labelled with "sequence identifiers" in order to prevent the server from
 reordering RPC requests, as this could cause its file state to
 become out of sync with the client.

 Currently the NFS client code enforces this ordering locally using
 semaphores to restrict access to structures until the RPC call is done.
 This, of course, only works with synchronous RPC calls, since the
 user process must first grab the semaphore.
 By dropping semaphores, and instead teaching the RPC engine to hold
 the RPC calls until they are ready to be sent, we can extend this
 process to work nicely with asynchronous RPC calls too.

 This patch adds a new list called "rpc_sequence" that defines the order
 of the RPC calls to be sent. We add one such list for each state_owner.
 When an RPC call is ready to be sent, it checks if it is top of the
 rpc_sequence list. If so, it proceeds. If not, it goes back to sleep,
 and loops until it hits top of the list.
 Once the RPC call has completed, it can then bump the sequence id counter,
 and remove itself from the rpc_sequence list, and then wake up the next
 sleeper.

 Note that the state_owner sequence ids and lock_owner sequence ids are
 all indexed to the same rpc_sequence list, so OPEN, LOCK,... requests
 are all ordered w.r.t. each other.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 Currently, call_encode will cause the entire RPC call to abort if it returns
 an error. This is unnecessarily rigid, and gets in the way of attempts
 to allow the NFSv4 layer to order RPC calls that carry sequence ids.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

 After a server crash/reboot, rebinding should always retry, otherwise
 requests on "hard" mounts will fail when they shouldn't.

 Test plan:
 Run a lock-intensive workload against a server while rebooting the server
 repeatedly.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

Reported by: Bob Tracy <rct@gherkin.frus.com>

 "...I've got a Toshiba notebook (730XCDT -- Pentium 150MMX) for which
  I'm using the Vesa FB driver.  When the machine has been idle for some
  time and the driver attempts to powerdown the display, rather than the
  display going blank, it goes gray with several strange lines.  When I
  hit the "shift" key or other-wise wake up the display, the old video
  state is not fully restored..."

vesafb recently added a blank method which has only 2 states, powerup and
powerdown.  The powerdown state is used for all blanking levels, but in his
case, powerdown does not work correctly for higher levels of display
powersaving. Thus, for intermediate power levels, use software blanking,
and use only hardware blanking for an explicit powerdown.
Signed-off-by: Antonino Daplas <adaplas@pol.net>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This still leaves driver and architecture-specific subdirectories alone,
but gets rid of the bulk of the "generic" generated files that we should
ignore.
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Patch from Kenneth Tan

The get_irqnr_and_base subroutine of ixp4xx does not take interrupt 0 condition into account properly. We should not perform "subs" here. The Z flag will be set when interrupt 0 occur, which resulting "movne r1, sp" in the caller routine (irq_handler) not being executed.

When interrupt 0 occur:
o if CONFIG_CPU_IXP46X is not set, "subs" will set the Z flag and return
o if CONFIG_CPU_IXP46X is set, codes in upper interrupt handling will be trigerred. But since this is not supper interrupt, the "cmp" in the upper interrupt handling portion will set the Z flag and return
Signed-off-by: Kenneth Tan <chong.yin.tan@intel.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Kenneth Tan

The cpu_is_ixp465 macro in include/asm-arm/arch-ixp4xx/hardware.h is always returning 0 because #ifdef CONFIG_CPU_IXP465 is always false.
Signed-off-by: Kenneth Tan <chong.yin.tan@intel.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Nicolas Pitre
Signed-off-by: Nicolas Pitre <nico@cam.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Patch from Ben Dooks

Check that the device we are looking at is really
a platform device before trying to cast it to one
to find out the platform bus number.

Thanks to RMK for pointing this out.
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

The following build error happens with 2.6.14-rc4 when CONFIG_KALLSYMS is
not defined.  The error message in a fragment of the output was:

  CC      arch/i386/lib/usercopy.o
  AR      arch/i386/lib/lib.a
/bin/sh: line 1: +@: command not found
make[3]: warning: jobserver unavailable: using -j1.  Add `+' to parent make rule.
  CHK     include/linux/compile.h
Signed-off-by: Mark Rustad <mrustad@mac.com>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

lock_kiocb() was introduced to serialize retrying and cancellation.  In the
process of doing so it tried to sleep waiting for KIF_LOCKED while holding
the ctx_lock spinlock.  Recent fixes have ensured that multiple concurrent
retries won't be attempted for a given iocb.  Cancel has other problems and
has no significant in-tree users that have been complaining about it.  So
for the immediate future we'll revert sleeping with the lock held and will
address proper cancellation and retry serialization in the future.
Signed-off-by: Zach Brown <zach.brown@oracle.com>
Acked-by: Benjamin LaHaise <bcrl@kvack.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Only signal completion after marking request slot as free, otherwise other
processor can free request structure before we finish using it.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Fix -EIO on /proc/acpi/events after suspends.  This actually breaks
suspending by power button in many setups.
Signed-off-by: Pavel Machek <pavel@suse.cz>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Since Revision 1.10 was released the n_r3964 module wasn't able to receive any
data.  The reason for that behavior is because there were some wrong calls of
mod_timer(...) in the function receive_char (...).  This patch should fix this
problem and was successfully tested with talking to some kuka industrial
robots.
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Currently you do not get all the map entries on nommu systems because the
start function doesn't index into the list using the value of "pos".
Signed-off-by: David McCullough <davidm@snapgear.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This makes call_rcu() keep track of how many events there are on the RCU
list, and cause a reschedule event when the list gets too long.

This helps keep RCU event lists down.
Signed-off-by: Linus Torvalds <torvalds@osdl.org>