- 21 Nov, 2007 4 commits
-
-
Mike Frysinger authored
Signed-off-by:
Mike Frysinger <michael.frysinger@analog.com> Signed-off-by:
Bryan Wu <bryan.wu@analog.com>
-
Mike Frysinger authored
Signed-off-by:
-
Sonic Zhang authored
Config EBIU flash mode properly. EBIU_MODE EBIU_FCTL EBIU_MBSCTL register should be configurd to Flash mode. Signed-off-by:
Sonic Zhang <sonic.zhang@analog.com> Signed-off-by:
-
Cliff Cai authored
Signed-off-by:
Cliff Cai <cliff.cai@analog.com> Signed-off-by:
-
- 17 Nov, 2007 6 commits
-
-
Robin Getz authored
Signed-off-by:
Robin Getz <robin.getz@analog.com> Signed-off-by:
-
Bernd Schmidt authored
Revert this patch: move the init sections to the end of memory, so that after they are free, run time memory is all continugous - this should help decrease memory fragementation. When doing this, we also pack some of the other sections a little closer together, to make sure we don't waste memory. To make this happen, we need to rename the .data.init_task section to .init_task.data, so it doesn't get picked up by the linker script glob. Since it causes the kernel not to boot up with mtd filesystems. Signed-off-by:
Bernd Schmidt <bernd.schmidt@analog.com> Signed-off-by:
-
Jie Zhang authored
Signed-off-by:
Jie Zhang <jie.zhang@analog.com> Signed-off-by:
-
Michael Hennerich authored
Signed-off-by:
Michael Hennerich <michael.hennerich@analog.com> Signed-off-by:
-
Robin Getz authored
Signed-off-by:
-
Michael Hennerich authored
/* * CPUs often take a performance hit when accessing unaligned memory * locations. The actual performance hit varies, it can be small if the * hardware handles it or large if we have to take an exception and fix * it * in software. * * Since an ethernet header is 14 bytes network drivers often end up * with * the IP header at an unaligned offset. The IP header can be aligned by * shifting the start of the packet by 2 bytes. Drivers should do this * with: * * skb_reserve(NET_IP_ALIGN); * * The downside to this alignment of the IP header is that the DMA is * now * unaligned. On some architectures the cost of an unaligned DMA is high * and this cost outweighs the gains made by aligning the IP header. * * Since this trade off varies between architectures, we allow * NET_IP_ALIGN * to be overridden. */ This new function insl_16 allows to read form 32-bit IO and writes to 16-bit aligned memory. This is useful in above described scenario - In particular with the AXIS AX88180 Gigabit Ethernet MAC. Once the device is in 32-bit mode, reads from the RX FIFO always decrements 4bytes. While on the other side the destination address in SDRAM is always 16-bit aligned. If we use skb_reserve(0) the receive buffer is 32-bit aligned but later we hit a unaligned exception in the IP code. Signed-off-by:
-
- 23 Nov, 2007 1 commit
-
-
Mike Frysinger authored
If you need a 64 bit divide in the kernel, use asm/div64.h. Revert the addition of udivdi3. Cc: Bernd Schmidt <bernd.schmidt@analog.com> Signed-off-by:
-
- 17 Nov, 2007 4 commits
-
-
Mike Frysinger authored
Signed-off-by:
-
Adrian Bunk authored
The only user of get_wchan I was able to find is the proc fs - and proc can't be built modular. Signed-off-by:
Adrian Bunk <bunk@kernel.org> Signed-off-by:
-
Adrian Bunk authored
The only user is the a.out support. It was therefore removed prior to the blackfin merge from all architectures not supporting a.out. Currently, Blackfin doesn't suppport a.out. Signed-off-by:
-
Robert P. J. Day authored
i'm *reasonably* confident that this is a typo that should be fixed. Signed-off-by:
Robert P. J. Day <rpjday@crashcourse.ca> Signed-off-by:
-
- 15 Nov, 2007 5 commits
-
-
Michael Hennerich authored
Blackfin arch: Dont use cs_change_per_word, since the AD7877 driver doesnt require it anymore; fix bus numbers, fix typos Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Blackfin arch: change get_bf537_ether_addr() to bfin_get_ether_addr() since this is not BF537 specific and to better match other Blackfin-specific conventions Signed-off-by:
-
- 22 Nov, 2007 1 commit
-
-
Mike Frysinger authored
Blackfin arch: sharing the board-specific MAC function does not make sense so move it into board-specific files Signed-off-by:
-
- 15 Nov, 2007 5 commits
-
-
Mike Frysinger authored
VDSP has double fault on core a/b inverted for BF561 -- bit 11 is core a while bit 12 is core b Signed-off-by:
-
Mike Frysinger authored
since we have this always turned on now and dont want it off (and hasnt been an option in a while) Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Robin Getz authored
move the init sections to the end of memory, so that after they are free, run time memory is all continugous - this should help decrease memory fragementation. When doing this, we also pack some of the other sections a little closer together, to make sure we don't waste memory. To make this happen, we need to rename the .data.init_task section to .init_task.data, so it doesn't get picked up by the linker script glob. Signed-off-by:
-
- 21 Nov, 2007 1 commit
-
-
Mike Frysinger authored
Signed-off-by:
-
- 23 Nov, 2007 1 commit
-
-
Mike Frysinger authored
Signed-off-by:
-
- 15 Nov, 2007 3 commits
-
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
- 12 Nov, 2007 1 commit
-
-
Mike Frysinger authored
Blackfin arch: add a compatible DOUBLE_FAULT define to enable resets on double faults in either core Signed-off-by:
-
- 15 Nov, 2007 3 commits
-
-
Mike Frysinger authored
Signed-off-by:
-
Javier Herrero authored
Signed-off-by:
Javier Herrero <jherrero@hvsistemas.es> Signed-off-by:
-
Robin Getz authored
https://blackfin.uclinux.org/gf/project/uclinux-dist/tracker/?action=TrackerItemEdit&tracker_item_id=1685 Ensure that cache/protection is turned back on when we get a fault, and ensure that the initial population of the CPLB tables are correct - that kernel is locked in CPLB tables Signed-off-by:
-
- 12 Nov, 2007 4 commits
-
-
Michael Hennerich authored
Signed-off-by:
-
Bryan Wu authored
Remove some sort of bloaty code, try to get these pin_req arrays built at compile-time - move this static things to the blackfin board file - add pin_req array to struct bfin5xx_spi_master - tested on BF537/BF548 with SPI flash Signed-off-by: -
Robin Getz authored
Signed-off-by:
-
Robin Getz authored
We currently do not. Also make it easier to handle cplb violations - in traps.c Signed-off-by:
-
- 17 Nov, 2007 1 commit
-
-
git://git.kernel.org/pub/scm/linux/kernel/git/x86/linux-2.6-x86Linus Torvalds authored
* 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/x86/linux-2.6-x86: x86: simplify "make ARCH=x86" and fix kconfig all.config x86: reboot fixup for wrap2c board x86: check boundary in count setup resource x86: fix reboot with no keyboard attached x86: add hpet sanity checks x86: on x86_64, correct reading of PC RTC when update in progress in time_64.c x86: fix freeze in x86_64 RTC update code in time_64.c ntp: fix typo that makes sync_cmos_clock erratic Remove x86 merge artifact from top Makefile x86: fixup cpu_info array conversion x86: show cpuinfo only for online CPUs x86: fix cpu-hotplug regression x86: ignore the sys_getcpu() tcache parameter x86: voyager use correct header file name x86: fix smp init sections x86: fix voyager_cat_init section x86: fix bogus memcpy in es7000_check_dsdt()
-
