- 09 Mar, 2013 9 commits
-
-
Kukjin Kim authored
Conflicts: arch/arm/mach-exynos/mach-exynos4-dt.c
-
Kukjin Kim authored
-
Thomas Abraham authored
Move the multi core timer (mct) driver to from mach-exynos to drivers/clocksource and update the Kconfig and makefiles. Cc: Changhwan Youn <chaos.youn@samsung.com> Signed-off-by:
Thomas Abraham <thomas.abraham@linaro.org> Reviewed-by:
Stephen Warren <swarren@nvidia.com> Signed-off-by:
Kukjin Kim <kgene.kim@samsung.com>
-
Thomas Abraham authored
With device tree support enabled for MCT controller, the staticio-remapping of the MCT controller address space is removed for Exynos5 platforms (which supports only device tree based boot). Cc: Changhwan Youn <chaos.youn@samsung.com> Signed-off-by:
-
Thomas Abraham authored
Add MCT device tree node for Exynos4210, Exynos4212, Exynos4412 and Exynos5250. Cc: Changhwan Youn <chaos.youn@samsung.com> Signed-off-by:
-
Thomas Abraham authored
Add entries to __clksrc_of_table so that Exynos MCT controller is discoverable using call to clocksource_of_init. With this change, it would be appropriate to rename the function 'exynos4_timer_init' as 'mct_init' since it aptly describes this function. Additionally, the 'init_time' callback of all machine descriptors for exynos platforms that were previously set to 'exynos4_timer_init' are now set to either 'mct_init' or 'clocksource_of_init'. Cc: Changhwan Youn <chaos.youn@samsung.com> Signed-off-by:
-
Thomas Abraham authored
Allow the MCT controller base address and interrupts to be obtained from device tree and remove unused static definitions of these. The non-dt support for Exynos5250 is removed but retained for Exynos4210 based platforms. Cc: Changhwan Youn <chaos.youn@samsung.com> Signed-off-by:
-
Thomas Abraham authored
Instead of using soc_is_xxx macro at more than one place in the MCT controller driver to decide the MCT interrpt number to be setup, populate a table of known MCT global and local timer interrupts and use the values in table to setup the MCT interrupts. This also helps in adding device tree support for MCT controller driver by allowing the driver to retrieve interrupt numbers from device tree and populating them into this table, thereby supporting both legacy and dt functionality to co-exist. Cc: Changhwan Youn <chaos.youn@samsung.com> Signed-off-by:
-
Thomas Abraham authored
All the MCT register read/writes use a fixed remapped address S5P_VA_SYSTIMER. With device tree support for MCT controller, it is possible to remove the static remap of the MCT controller address space and do the remap during the initialization of the MCT controller with the physical address obtained from the device tree. So in preparation of adding device tree support for MCT controller, add a new register base address variable that will hold the remapped MCT controller base address and convert all MCT register read/writes to use this new variable as the base address instead of the fixed S5P_VA_SYSTIMER. While at it, the MCT register offset and bit mask definitions are moved into the MCT controller driver file since there are no other consumers of these definitions. Cc: Changhwan Youn <chaos.youn@samsung.com> Signed-off-by:
-
- 07 Mar, 2013 26 commits
-
-
Abhilash Kesavan authored
The exynos5250 based chromebooks have a max77686 pmic on i2c channel 0. Add support for the pmic in the common cros5250 dts file. Tested after enabling cpufreq support for exynos5250 SoC and varying the arm frequency/voltage using the userspace governer. Signed-off-by:
Abhilash Kesavan <a.kesavan@samsung.com> Acked-by:
Doug Anderson <dianders@chromium.org> Signed-off-by:
-
Sachin Kamat authored
Signed-off-by:
Sachin Kamat <sachin.kamat@linaro.org> Signed-off-by:
-
Prasanna Kumar authored
This patch adds device tree nodes for MFC and G-scaler power domains of exynos5250.It binds these power-domain nodes to repsective device tree nodes It also adds support to enable PM generic domains for exynos5250. Signed-off-by:
Prasanna Kumar <prasanna.ps@samsung.com> Signed-off-by:
-
Vivek Gautam authored
Adding OHCI device tree node for Exynos5250 along with the device base address. Signed-off-by:
Vivek Gautam <gautam.vivek@samsung.com> Acked-by:
Jingoo Han <jg1.han@samsung.com> Acked-by:
Grant Likely <grant.likely@secretlab.ca> Signed-off-by:
-
Vivek Gautam authored
Adding EHCI device tree node for Exynos5250 along with the device base adress and gpio line for vbus. Signed-off-by:
-
Jingoo Han authored
Add device tree node for DP controller in EXYNOS5250 and enable the instance for the SMDK5250 board. Signed-off-by:
Ajay Kumar <ajaykumar.rs@samsung.com> Signed-off-by:
-
Jingoo Han authored
Use AUXDATA to set the device names for DP controller instance discovered from device tree. Signed-off-by:
-
Sachin Kamat authored
Signed-off-by:
-
Sachin Kamat authored
Signed-off-by:
-
Sachin Kamat authored
Signed-off-by:
-
Sachin Kamat authored
Signed-off-by:
-
Sachin Kamat authored
Signed-off-by:
-
Sachin Kamat authored
Signed-off-by:
-
Sachin Kamat authored
Signed-off-by:
Sylwester Nawrocki <s.nawrocki@samsung.com> Tested-by:
-
Sachin Kamat authored
Added an example for bindings for illustration and clarity. Cc: devicetree-discuss@lists.ozlabs.org Cc: Arun Kumar K <arun.kk@samsung.com> Signed-off-by:
-
Dongjin Kim authored
This patch enables RTC device node defined in exynos4.dtsi for exynos4412-odroidx. Signed-off-by:
Dongjin Kim <tobetter@gmail.com> Signed-off-by:
-
Dongjin Kim authored
This fixes the property of dw-mshc-sdr-timing and dw-mshc-ddr-timing as per its current binding, it only has two cells. Signed-off-by:
-
Girish K S authored
Arndale is a low cost board based on the Samsung Exynos5250 SoC. This patch adds initial device tree support for this board. Reviewed-by:
Alim Akhtar <alim.akhtar@samsung.com> Signed-off-by:
Girish K S <ks.giri@samsung.com> Signed-off-by:
Tushar Behera <tushar.behera@linaro.org> Signed-off-by:
-
Kukjin Kim authored
This patch adds timer node and re-organizes cpu node for exynos5440. Acked-by:
Thomas Abraham <thomas.ab@samsung.com> Signed-off-by:
-
Giridhar Maruthy authored
This patch removes disabled status from I2C node for exynos5440-ssdk5440, and fixes the incorrect compatible property value of i2c for exynos5440. Signed-off-by:
Giridhar Maruthy <giridhar.m@samsung.com> Signed-off-by:
-
Giridhar Maruthy authored
Signed-off-by:
-
Giridhar Maruthy authored
Signed-off-by:
-
Sachin Kamat authored
Added sdhci node for exynos4412-origen. Signed-off-by:
Tomasz Figa <t.figa@samsung.com> Signed-off-by:
-
Sachin Kamat authored
Added vmmc regulator node in exynos4412-origen.dts file. Signed-off-by:
-
Dongjin Kim authored
Add initial DT for Hardkernel's ODROID-X board based on EXYNOS4412 SoC. This patch including adds the node to support fixed voltage for peripherals like LED, ethernet controller, and this patch adds GPIO connected LEDS on ODROID-X board and configure its properties like following: LED1: use 'heartbeat' trigger, blinking while the board is running. LED2: use 'mmc0' trigger, on when mmc0 is accessing. And adds the device node to support eMMC storage on SDCARD4 ports, controlled by MSHC. Signed-off-by:
Olof Johansson <olof@lixom.net> [kgene.kim@samsung.com: squashed into one commit as per Olof's comment] Signed-off-by:
-
Thomas Abraham authored
Add a minimal board dts file for EXYNOS4412 based Insignal Origen board. Signed-off-by:
-
- 05 Mar, 2013 5 commits
-
-
Romain Naour authored
Signed-off-by:
Naour Romain <romain.naour@openwide.fr> Reviewed-by:
Tomasz Figa <tomasz.figa@gmail.com> Reviewed-by:
Heiko Stuebner <heiko@sntech.de> Signed-off-by:
-
Romain Naour authored
Signed-off-by:
-
Romain Naour authored
Signed-off-by:
-
Romain Naour authored
Signed-off-by:
-
Romain Naour authored
Signed-off-by:
-
