- 05 Jun, 2009 26 commits
-
-
Mike Frysinger authored
The uclinux_ram_mtdinfo, uclinux_romfs, and uclinux_point symbols do not need to be visible outside of this module, so mark them static. Signed-off-by:
Mike Frysinger <vapier@gentoo.org> CC: Greg Ungerer <gerg@uclinux.org> CC: uclinux-dev@uclinux.org CC: linux-mtd@lists.infradead.org Signed-off-by:
Artem Bityutskiy <Artem.Bityutskiy@nokia.com> Signed-off-by:
David Woodhouse <David.Woodhouse@intel.com>
-
Mike Frysinger authored
There isn't any benefit to building the uClinux MTD map as a module as the rootfs it requires in order to actually be usable is appended to the kernel image, not the module. No known system builds it this way either, so change the option to "bool". Signed-off-by:
-
Mike Frysinger authored
Due to a processor anomaly (05000263 to be exact), most Blackfin parts cannot keep the embedded filesystem image directly after the kernel in RAM. Instead, the filesystem needs to be relocated to the end of memory. As such, we need to tweak the map addr/size during boot for Blackfin systems. This can be done in any early arch/board init code. Signed-off-by:
-
Cliff Cai authored
The DMAs have different bit sizes on BF52x and BF54x. From the PHRM: "The 16-bit DMA Access Bus (DAB) connects the DMA controller to the on-chip peripherals, PPI, SPI, Ethernet MAC, the SPORTs, NFC, HOSTDP and the UARTs." 32-bit DMA won't work for BF52x. Signed-off-by:
Cliff Cai <cliff.cai@analog.com> Signed-off-by:
Bryan Wu <cooloney@kernel.org> Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Simon Polette authored
Just add a new on-flash-bbt module parameter. Signed-off-by:
Simon Polette <spolette@adetelgroup.com> Signed-off-by:
-
Vladimir Barinov authored
- Add support for 2KiB page size flashes - Fix page address access for large pages - Detect oob layout at runtime - handle pagesize_2k variable - Fix oob16 layout: reserve location 5 of oob area since it's used for bbt Signed-off-by:
Vladimir Barinov <vova.barinov@gmail.com> Signed-off-by:
-
H Hartley Sweeten authored
Add optional callback to allow platform to initialize partitions. Static partitions on a nand device could vary depending on the size of the device. This patch allows an optional platform callback to be used to setup this partition information at runtime. Scan order is: 1) chip.part_probe_types 2) chip.set_parts 3) chip.partitions 4) full mtd device (fallback for no partitions) Some of the existing nand drivers could possibly be replaced by the plat_nand driver by using this patch. These include autcpu12.c and ts7250.c drivers. Signed-off-by:
H Hartley Sweeten <hsweeten@visionengravers.com> Signed-off-by:
Andrew Morton <akpm@linux-foundation.org> Signed-off-by:
-
H Hartley Sweeten authored
Add optional probe and remove callbacks to the plat_nand driver. Some platforms may require additional setup, such as configuring the memory controller, before the nand device can be accessed. This patch provides an optional callback to handle this setup as well as a callback to teardown the setup. Signed-off-by:
Alexander Clouter <alex@digriz.org.uk> Signed-off-by:
-
Shane McDonald authored
The RAMROOT function was a successful but non-portable attempt to append the root filesystem to the end of the kernel image. The preferred and portable solution is to use an initramfs instead. The only user of this function was the msp71xx configuration in the MIPS architecture; as the use of the RAMROOT has been removed from that configuration, there are no more users, so this code can be removed. Signed-off-by:
Shane McDonald <mcdonald.shane@gmail.com> Signed-off-by:
-
Mika Korhonen authored
Add missing __devexit_p wrapper and no more mark shutdown with __devexit. Fixes build in configurations where devexit functions get discarded. Signed-off-by:
Mika Korhonen <mika.j.korhonen@gmail.com> Signed-off-by:
-
Lennert Buytenhek authored
Signed-off-by:
Lennert Buytenhek <buytenh@wantstofly.org> Signed-off-by:
-
Daniel Ribeiro authored
This patch allows otpinfo for CFI >= 1.0 and burst read for CFI >= 1.1. references: 1.0: http://www.datasheetcatalog.org/datasheets2/81/816884_1.pdf 1.1: http://milkymist.org/doc/MT28F640J3.pdf http://www.delorie.com/agenda/specs/29066709.pdfSigned-off-by:
Daniel Ribeiro <drwyrm@gmail.com> Acked-by:
Nicolas Pitre <nico@cam.org> Signed-off-by:
-
Daniel Ribeiro authored
This chip reports CFI 1.3, but the CFI PRI is like CFI 1.1. Add a quirk to pass probe on this chip. This patch depends on "MTD: CFI 1.0 and CFI 1.1" Signed-off-by:
-
Alexander Clouter authored
This patch adds (write|read)_buf callbacks to plat_nand. The NAND on the TS-7800 provisioned by the FPGA allows readw() and readl() to be used which gives a 2.5x speed up. To be able to use this from the plat_nand driver a hook for read_buf (and also write_buf whilst we are in there) need to be made available. This patch adds the hook. Signed-off-by:
-
Michał Mirosław authored
Add SST39SF040 chip (like SST39SF020A but bigger - 4Mbit). Signed-off-by:
Michał Mirosław <mirq-linux@rere.qmqm.pl> Signed-off-by:
-
David Brownell authored
Remove some legacy code from the davinci_nand driver, which made cmdlinepart ignore the the MTD ID passed to it. Boards can have multiple NAND chips, and some do (like the DM357 EVM), so this dated hack is undesirable. Correct labels are like "davinci_nand.0" (for chipselect 0). Signed-off-by:
David Brownell <dbrownell@users.sourceforge.net> Signed-off-by:
-
Adrian Hunter authored
In addition to adding the Numonyx manufacturer code, this patch also ensures 'sync. write' is disabled when reading identification data - something that the Numonyx chip objects to, but the Samsung chip seems to ignore. Signed-off-by:
Adrian Hunter <adrian.hunter@nokia.com> Signed-off-by:
-
Matthieu CASTET authored
this patch add m45pe10 [1] chip support to the m25p80 driver. [1] http://www.numonyx.com/Documents/Datasheets/M45PE10.pdfSigned-off-by:
Matthieu CASTET <matthieu.castet@parrot.com> Signed-off-by:
-
Magnus Lilja authored
Make sure to pass the same dev_id data to free_irq() that was used when calling request_irq(), otherwise we get a warning about freeing an already free IRQ. Signed-off-by:
Magnus Lilja <lilja.magnus@gmail.com> Signed-off-by:
-
Vimal Singh authored
Type of 'byte_addr' needes to be 'unsigned int' for 512 byte ECC support. Signed-off-by:
Vimal Singh <vimalsingh@ti.com> Signed-off-by:
-
David Brownell authored
Minimal support for the 4-bit ECC engine found on DM355, DM365, DA830/OMAP-L137, and similar recent DaVinci-family chips. This is limited to small-page flash for now; there are some page layout issues for large page chips. Note that most boards using this engine (like the DM355 EVM) include 2GiB large page chips. Sanity tested on DM355 EVM after swapping the socketed NAND for a small-page one. Signed-off-by:
-
David Brownell authored
Make the DaVinci NAND driver require platform_data with board-specific configuration. We can't actually do any kind of sane job of configuring it otherwise. Also fix the comment about picking the "best" ECC mode. We can't do those any more; that relied on knowing what kind of CPU we're using (they don't all support 4-bit ECC), and current policy is that drivers not have cpu_is_*() checks. Signed-off-by:
-
David Brownell authored
Resolve issue noted by Sneha: when computing oobavail from the list of free areas in the OOB, don't assume there will always be an unused slot at the end. With ECC_HW_SYNDROME and 4KiB page chips, it's fairly likely there *won't* be one. Signed-off-by:
-
Artem Bityutskiy authored
This file does not define any kernel-userspace API, all it does it defines few helpers for userspace. Instead, userspace should have a private copy of this file. The main (if not the only) user is the mtd-utils package, but it already has a private copy of this file. This patch also removes references to 'jffs2-user.h' from 'Kbuild' and MAINTAINERS' files. Signed-off-by:
-
Thomas Chou authored
With CONFIG_HOTPLUG=n, the following eror occurred during link: local symbol 0: discarded in section `.devexit.text' from drivers/built-in.o It was caused by improper section reference. The __devexit_p() should be added to the .remove function. Signed-off-by:
Thomas Chou <thomas@wytron.com.tw> Signed-off-by:
-
- 29 May, 2009 9 commits
-
-
David Woodhouse authored
Signed-off-by: -
Kevin Cernekee authored
Remove all references to MTD ioctls from fs/compat_ioctl.c and let them all be handled by mtd_compat_ioctl(). Signed-off-by:
Kevin Cernekee <kpc.mtd@gmail.com> Signed-off-by:
-
Kevin Cernekee authored
Signed-off-by:
-
Kevin Cernekee authored
1) Move the MEMREADOOB/MEMWRITEOOB compat_ioctl wrappers from fs/compat_ioctl.c into mtdchar.c . Original request was here: http://lkml.org/lkml/2009/4/1/295 2) Add missing COMPATIBLE_IOCTL lines, so that mtd-utils does not error out when running in 64/32 compatibility mode. LKML-Reference: <200904011650.22928.arnd@arndb.de> Signed-off-by:
-
Kevin Cernekee authored
New MEMERASE/MEMREADOOB/MEMWRITEOOB ioctls are needed in order to support 64-bit offsets into large NAND flash devices. Signed-off-by:
-
Kevin Cernekee authored
Signed-off-by:
-
David Woodhouse authored
As pointed out by Kay Sievers, the name size limit is gone from the driver-core, and BUS_ID_SIZE is obsolescent. Rather than just papering over the problem by replacing the mtdname array size with an arbitrary '20 + 2', fix the problem properly and handle arbitrary name sizes. Signed-off-by: -
Catalin Marinas authored
This patch adds MTD concatenation support to integrator-flash.c for platforms with more than one block of flash memory (e.g. RealView PB11MPCore). The implementation is based on the sa1100-flash.c one. Signed-off-by:
Catalin Marinas <catalin.marinas@arm.com> Acked-by:
Russell King <rmk+kernel@arm.linux.org.uk> Signed-off-by:
-
David Woodhouse authored
We'll fix it up again, but for now I don't think anyone really cares. Signed-off-by:
-
- 26 May, 2009 5 commits
-
-
David Woodhouse authored
This breaks the dilnetpc map driver, but it could be fixed not to use that option. We want to simplify the partition handling, and this is a step towards that. Remove superfluous 'index' field from private struct mtd_part too, while we're at it. Signed-off-by: -
David Woodhouse authored
Signed-off-by: -
David Woodhouse authored
Now the MTD core will do this for us, we don't need to hook it up from the board drivers. Shame we can't do shutdown from the class too... Signed-off-by: -
David Woodhouse authored
This is intended to suspend/resume the _chip_, while we leave board drivers to handle their own suspend/resume for the controller. Signed-off-by: -
David Woodhouse authored
Signed-off-by:
-
