1. 28 Jun, 2007 21 commits
  2. 25 Jun, 2007 18 commits
  3. 14 Jun, 2007 1 commit
    • David Gibson's avatar
      [POWERPC] Fix problems with device tree representation of TSI-1xx bridges · e58ca3de
      David Gibson authored
      This fixes some problems with the way the some things
      represented in the device tree for the Holly and Taiga boards.  This
      means changes both to the dts files, and to the code which
      instantiates the tsi108 ethernet platform devices based on the device
      tree.
      
      	- First, and most importantly, the ethernet PHYs are given
      with an identical 'reg' property.  This reg currently encodes the
      accessible register used to initiate mdio interaction with the PHYs,
      rather than a meaningful address on the parent bus (mdio in this
      case), which is incorrect.  Instead we give the address of these
      registers as 'reg' in the mdio node itself, and encode the ID of each
      phy in their 'reg' propertyies.
      	- Currently the platform device constructor enables a
      workaround in the tsi108 ethernet driver based on the compatible
      property of the PHY.  This is incorrect, because the workaround in
      question is necessary due to the board's wiring of the PHY, not the
      model of PHY itself.  This patch alters the constructor to instead
      enable the workaround based on a new special property in the PHY node.
      	- The compatible properties on a number of nodes in the device
      tree are insufficiently precise.  In particular the PHYs give only
      "bcm54xx", which is broken, since there are many bcm54xx PHY models,
      and they have differences which matter.  The mdio had a compatible
      property of "tsi-ethernet" identical to the ethernet MAC nodes, which
      doesn't make sense.  The ethernet, i2c, bridge and PCI nodes were
      given only as "tsi-*" which is somewhat inprecise, we replace with
      "tsi108-*" in the case of Taiga (which has a TSI108 bridge), and
      "tsi109-*", "tsi108-*" in the case of Holly (which has a TSI109
      bridge).
      	- We remove some "model" properties from the ethernets on
      Taiga board which were neither useful nor adequately precise.
      	- On Holly we change to using a dtc label instead of a full
      path to reference the MPIC node, which makes the dts a little more
      readable.
      Signed-off-by: default avatarDavid Gibson <david@gibson.dropbear.id.au>
      Signed-off-by: default avatarPaul Mackerras <paulus@samba.org>
      e58ca3de