Skip to content

L
linux
Switch branch/tag
  1. 01 Sep, 2006 10 commits
    • Andrew Morton's avatar
      [PATCH] x86: increase MAX_MP_BUSSES on default arch · a9aa141c
      Andrew Morton authored 
      Vitezslav Samel <samel@mail.cz> reports that an HP DL380 g4 fails using the
default arch due to the ISA bus having an ID of 32.

It would have worked OK with the generic arch - for some reason the default
arch doesn't support as many busses.

So bump that up to support 256 busses, but leave it at 32 if we're building a
tiny system to save a bit of memory.

Cc: Vitezslav Samel <samel@mail.cz>
Acked-by: default avatarAndi Kleen <ak@muc.de>
Signed-off-by: default avatarAndrew Morton <akpm@osdl.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@osdl.org>
      a9aa141c
    • Bill Huey (hui's avatar
      [PATCH] xtensa: ptrace: EXIT_ZOMBIE fix · d742eae8
      Bill Huey (hui authored 
      We're testing the wrong task_struct field.
Acked-by: default avatarChris Zankel <chris@zankel.net>
Signed-off-by: default avatarAndrew Morton <akpm@osdl.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@osdl.org>
      d742eae8
    • Shailabh Nagar's avatar
      [PATCH] task delay accounting fixes · 35df17c5
      Shailabh Nagar authored 
      Cleanup allocation and freeing of tsk->delays used by delay accounting.
This solves two problems reported for delay accounting:

1. oops in __delayacct_blkio_ticks
http://www.uwsg.indiana.edu/hypermail/linux/kernel/0608.2/1844.html

Currently tsk->delays is getting freed too early in task exit which can
cause a NULL tsk->delays to get accessed via reading of /proc/<tgid>/stats.
 The patch fixes this problem by freeing tsk->delays closer to when
task_struct itself is freed up.  As a result, it also eliminates the use of
tsk->delays_lock which was only being used (inadequately) to safeguard
access to tsk->delays while a task was exiting.

2. Possible memory leak in kernel/delayacct.c
http://www.uwsg.indiana.edu/hypermail/linux/kernel/0608.2/1389.html

The patch cleans up tsk->delays allocations after a bad fork which was
missing earlier.

The patch has been tested to fix the problems listed above and stress
tested with rapid calls to delay accounting's taskstats command interface
(which is the other path that can access the same data, besides the /proc
interface causing the oops above).
Signed-off-by: default avatarShailabh Nagar <nagar@watson.ibm.com>
Cc: Balbir Singh <balbir@in.ibm.com>
Signed-off-by: default avatarAndrew Morton <akpm@osdl.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@osdl.org>
      35df17c5
    • john stultz's avatar
      [PATCH] Fix faulty HPET clocksource usage (fix for bug #7062) · 30f3174d
      john stultz authored 
      Apparently some systems export valid HPET addresses, but hpet_enable()
fails.  Then when the HPET clocksource starts up, it only checks for a
valid HPET address, and the result is a system where time does not advance.

See http://bugme.osdl.org/show_bug.cgi?id=7062 for details.

This patch just makes sure we better check that the HPET is functional
before registering the HPET clocksource.
Signed-off-by: default avatarJohn Stultz <johnstul@us.ibm.com>
Signed-off-by: default avatarAndrew Morton <akpm@osdl.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@osdl.org>
      30f3174d
    • Paul Fulghum's avatar
      [PATCH] synclink_gt: fix receive tty error handling · 202af6d5
      Paul Fulghum authored 
      Fix receive tty error handling in synclink_gt driver.  Adrian reported
compiler warning for incorrect bit test against char variable.  I
determined these and other device specific error bits were incorrectly
defined.
Signed-off-by: default avatarPaul Fulghum <paulkf@microgate.com>
Signed-off-by: default avatarAndrew Morton <akpm@osdl.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@osdl.org>
      202af6d5
    • NeilBrown's avatar
      [PATCH] md: Fix issues with referencing rdev in md/raid1 · ddac7c7e
      NeilBrown authored 
      We need to be careful when referencing mirrors[i].rdev.  It can disappear
under us at various times.

So:
  fix a couple of problem places.
  comment a couple of non-problem places
  move an 'atomic_add' which deferences rdev down a little
    way to some where where it is sure to not be NULL.
Signed-off-by: default avatarNeil Brown <neilb@suse.de>
Signed-off-by: default avatarAndrew Morton <akpm@osdl.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@osdl.org>
      ddac7c7e
    • Christoph Lameter's avatar
      [PATCH] ZVC: Scale thresholds depending on the size of the system · df9ecaba
      Christoph Lameter authored 
      The ZVC counter update threshold is currently set to a fixed value of 32.
This patch sets up the threshold depending on the number of processors and
the sizes of the zones in the system.

With the current threshold of 32, I was able to observe slight contention
when more than 130-140 processors concurrently updated the counters.  The
contention vanished when I either increased the threshold to 64 or used
Andrew's idea of overstepping the interval (see ZVC overstep patch).

However, we saw contention again at 220-230 processors.  So we need higher
values for larger systems.

But the current default is already a bit of an overkill for smaller
systems.  Some systems have tiny zones where precision matters.  For
example i386 and x86_64 have 16M DMA zones and either 900M ZONE_NORMAL or
ZONE_DMA32.  These are even present on SMP and NUMA systems.

The patch here sets up a threshold based on the number of processors in the
system and the size of the zone that these counters are used for.  The
threshold should grow logarithmically, so we use fls() as an easy
approximation.

Results of tests on a system with 1024 processors (4TB RAM)

The following output is from a test allocating 1GB of memory concurrently
on each processor (Forking the process.  So contention on mmap_sem and the
pte locks is not a factor):

                       X                   MIN
TYPE:               CPUS       WALL       WALL        SYS     USER     TOTCPU
fork                   1      0.552      0.552      0.540    0.012      0.552
fork                   4      0.552      0.548      2.164    0.036      2.200
fork                  16      0.564      0.548      8.812    0.164      8.976
fork                 128      0.580      0.572     72.204    1.208     73.412
fork                 256      1.300      0.660    310.400    2.160    312.560
fork                 512      3.512      0.696   1526.836    4.816   1531.652
fork                1020     20.024      0.700  17243.176    6.688  17249.863

So a threshold of 32 is fine up to 128 processors. At 256 processors contention
becomes a factor.

Overstepping the counter (earlier patch) improves the numbers a bit:

fork                   4      0.552      0.548      2.164    0.040      2.204
fork                  16      0.552      0.548      8.640    0.148      8.788
fork                 128      0.556      0.548     69.676    0.956     70.632
fork                 256      0.876      0.636    212.468    2.108    214.576
fork                 512      2.276      0.672    997.324    4.260   1001.584
fork                1020     13.564      0.680  11586.436    6.088  11592.523

Still contention at 512 and 1020. Contention at 1020 is down by a third.
256 still has a slight bit of contention.

After this patch the counter threshold will be set to 125 which reduces
contention significantly:

fork                 128      0.560      0.548     69.776    0.932     70.708
fork                 256      0.636      0.556    143.460    2.036    145.496
fork                 512      0.640      0.548    284.244    4.236    288.480
fork                1020      1.500      0.588   1326.152    8.892   1335.044

[akpm@osdl.org: !SMP build fix]
Signed-off-by: default avatarChristoph Lameter <clameter@sgi.com>
Signed-off-by: default avatarAndrew Morton <akpm@osdl.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@osdl.org>
      df9ecaba
    • Christoph Lameter's avatar
      [PATCH] ZVC: Overstep counters · a302eb4e
      Christoph Lameter authored 
      Increments and decrements are usually grouped rather than mixed.  We can
optimize the inc and dec functions for that case.

Increment and decrement the counters by 50% more than the threshold in
those cases and set the differential accordingly.  This decreases the need
to update the atomic counters.

The idea came originally from Andrew Morton.  The overstepping alone was
sufficient to address the contention issue found when updating the global
and the per zone counters from 160 processors.

Also remove some code in dec_zone_page_state.
Signed-off-by: default avatarChristoph Lameter <clameter@sgi.com>
Signed-off-by: default avatarAndrew Morton <akpm@osdl.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@osdl.org>
      a302eb4e
    • Linus Torvalds's avatar
      Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/roland/infiniband · b63fe1ba
      Linus Torvalds authored 
      * 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/roland/infiniband:
  IB/mthca: Use IRQ safe locks to protect allocation bitmaps
      b63fe1ba
    • Roland Dreier's avatar
      IB/mthca: Use IRQ safe locks to protect allocation bitmaps · 5a4e6dcc
      Roland Dreier authored 
      It is supposed to be OK to call mthca_create_ah() and mthca_destroy_ah()
from any context.  However, for mem-full HCAs, these functions use the
mthca_alloc() and mthca_free() bitmap helpers, and those helpers use
non-IRQ-safe spin_lock() internally.  Lockdep correctly warns that
this could lead to a deadlock.  Fix this by changing mthca_alloc() and
mthca_free() to use spin_lock_irqsave().
Signed-off-by: default avatarRoland Dreier <rolandd@cisco.com>
      5a4e6dcc
  3. 31 Aug, 2006 10 commits
  5. 30 Aug, 2006 20 commits
GitLab Nexedi Edition | About GitLab | About Nexedi | 沪ICP备2021021310号-2 | 沪ICP备2021021310号-7