1. 26 Jan, 2013 4 commits
  2. 23 Jan, 2013 23 commits
  3. 22 Jan, 2013 13 commits
    • David S. Miller's avatar
      Merge branch 'legacy-isa-delete' of git://git.kernel.org/pub/scm/linux/kernel/git/paulg/linux · 930d52c0
      David S. Miller authored
      Paul Gortmaker says:
      
      ====================
      The Ethernet-HowTo was maintained for roughly 10 years, from 1993 to 2003.
      Fortunately sane hardware probing and auto detection (via PCI and ISA/PnP)
      largely made the document a relic of the past, hence it being abandoned
      a decade ago.
      
      However, there is one last useful thing that we can extract from the
      effort made in maintaining that document.  We can use it to guide us
      with respect to what rare, experimental and/or super ancient 10Mbit
      ISA drivers don't make sense to maintain in-tree anymore.
      
      Nobody will argue that ISA is obsolete.  Availability went away at about
      the time Pentium3 motherboards moved from 500MHz Slot1/SECC processors
      to the green 500MHz Socket 370 Pentium3 chips, at the turn of the century.
      
      In theory, it is possible that someone could still be running one of these
      12+ year old P3 machines and want 3.9+ bleeding edge kernels (but unlikely).
      In light of the above (remote) possibility, we can defer the removal of some
      ISA network drivers that were highly popular and well tested.  Typically
      that means the stuff more from the mid to late '90s, some with ISA PnP
      support, like the 3c509, the wd/SMC 8390 based stuff, PCnet/lance etc.
      
      But a lot of other drivers, typically from the early 1990s were for rare
      hardware, and experimental (to the point of requiring a cron job that would
      do a test ping, and then ifconfig down/up and/or a rmmod/insmod!).  And
      some of these drivers (znet, and lp486e to name two) are physically tied
      to platforms with on motherboard ethernet -- of 486 machines that date
      from the early 1990s and can only have single digit amounts of memory.
      
      What I'd like to achieve here with this series, is to get rid of those old
      drivers that are no longer being used.  In an earlier discussion where
      I'd proposed deleting a single driver, Alan suggested we instead dump
      all the historical stuff in one go, to make it "...immediately obvious
      where the break point is..."[1] and that it was "perfectly reasonable it
      (and a pile of other ISA cards) ought to be shown the door"[2].  So that
      is the goal here - make a clear line in the sand where the really ancient
      stuff finally gets kicked to the curb.
      
      Two old parallel port drivers are considered for removal here as well,
      since in early 386/486 ISA machines, the parallel port was typically found
      with the UARTS on the multi-I/O ISA controller card.  These drivers also date
      from the early 1990's; parallel ports are no longer found on modern boards,
      and their performance was not even capable of 10% of 10Mbit bandwidth.
      
      Allow me a preemptive justification against the inevitable comments from
      well meaning bystanders who suggest "why not just leave all this alone?".
      Dead drivers cost us all if they are left in tree.  If you think that
      is false, then please first consider:
      
      -every time you type "git status", you are checking to see if modifications
       have been made by you to all that dead code.
      
      -every time you type "git grep <regex>" you are searching through files
       which contain that dead code that simply does not interest you.
      
      -every time you build a "allyesconfig" and an "allmodconfig" (don't tell
       me you skip this step before submitting your changes to a maintainer),
       you waste CPU cycles building this dead code.
      
      -every time there is a tree wide API change, or cleanup, or file relocation,
       we pay the cost of updating dead code, or moving dead code.
      
      -daily regression tests (take linux-next as the most transparent
       example) spend time building (and possibly running) this dead code.
      
      -hard working people who regularly run auditing tools looking for lurking
       bugs (sparse/coverity/smatch/coccinelle) are wasting time checking for,
       and fixing bugs in this dead code.
      
      This last one is key.  Please take a look at the git history for the
      files that are proposed for removal here.  Look at the git history for
      any one of them ("git whatchanged --follow drivers/net/.../driver.c")
      Mentally sort the changes into two bins -- (1) the robotic tree-wide
      changes, and (2) the "look I found a real run-time bug while using this"
      category.  You will see that category #2 is essentially empty.
      
      Further to that, realize that drivers don't simply disappear.  We are
      not operating in the binary-only distribution space like other OS.  All
      these drivers remain in the git history forever.  If a person is an
      enthusiast for extreme legacy hardware, they are probably already
      customizing their kernel source and building it themselves to support
      such systems.  Also keep in mind that they could still build the 3.8
      kernel exactly as-is, and run it (or a 3.8.x stable variant of it) for
      several more years if they were really determined to cling to these old
      experimental ISA drivers for some reason.
      
      In summary, I hope that folks can be pragmatic about this, and not
      get swept up in nostalgia.  Ask yourself whether it is realistic to
      expect a person would have a genuine use case where they would
      need to build a 3.9+ modern kernel and install it on some legacy hardware
      that has no option but to absolutely _require_ one of the drivers
      that are deleted here.
      
      The following series was created with --irreversible-delete for
      ease of review (it skips showing the content of files that are
      deleted); however the complete patches can be pulled as per below.
      ====================
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      930d52c0
    • YOSHIFUJI Hideaki / 吉藤英明's avatar
    • YOSHIFUJI Hideaki / 吉藤英明's avatar
    • YOSHIFUJI Hideaki / 吉藤英明's avatar
    • YOSHIFUJI Hideaki / 吉藤英明's avatar
    • YOSHIFUJI Hideaki / 吉藤英明's avatar
      neigh: Keep neighbour cache entries if number of them is small enough. · 2724680b
      YOSHIFUJI Hideaki / 吉藤英明 authored
      Since we have removed NCE (Neighbour Cache Entry) reference from
      routing entries, the only refcnt holders of an NCE are its timer
      (if running) and its owner table, in usual cases.  As a result,
      neigh_periodic_work() purges NCEs over and over again even for
      gateways.
      
      It does not make sense to purge entries, if number of them is
      very small, so keep them.  The minimum number of entries to keep
      is specified by gc_thresh1.
      Signed-off-by: default avatarYOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      2724680b
    • Nicolas Dichtel's avatar
      ipmr: fix sparse warning when testing origin or group · 360eb5da
      Nicolas Dichtel authored
      mfc_mcastgrp and mfc_origin are __be32, thus we need to convert INADDR_ANY.
      Because INADDR_ANY is 0, this patch just fix sparse warnings.
      Reported-by: default avatarFengguang Wu <fengguang.wu@intel.com>
      Signed-off-by: default avatarNicolas Dichtel <nicolas.dichtel@6wind.com>
      Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
      360eb5da
    • Paul Gortmaker's avatar
      drivers/net: delete old x86 variant of the seeq8005 driver · 463d413c
      Paul Gortmaker authored
      The last update to the Ethernet HowTo (over 10 years ago) listed this:
      
       ------------------------
         SEEQ 8005
      
         Status: Obsolete, Driver Name: seeq8005
      
         There is little information about the card included in the driver,
         and hence little information to be put here. If you have a question,
         you are probably best trying to e-mail the driver author as listed
         in the source.
      
         It was marked obsolete as of the 2.4 series kernels.
       ------------------------
      
      If it was obsolete over a decade ago, the situation can not have
      improved with the passage of time, so let us act on that.  Even with
      today's improved search engines, I was unable to locate any real
      meaningful information on the ISA implementation of this rare chip.
      
      There are ARM and SGI variants of the driver in tree, but they do
      not depend on the original x86 driver source or header file.  We
      leave those non-x86 drivers to be deleted by the arch maintainers
      when they decide to expire those legacy platforms as a whole.
      Signed-off-by: default avatarPaul Gortmaker <paul.gortmaker@windriver.com>
      463d413c
    • Paul Gortmaker's avatar
      drivers/net: delete Digital EtherWorks-3 support. · 0ffd89e4
      Paul Gortmaker authored
      This is another one that makes sense to target for obsolescence, since
      it (a)appeared pre-1995, and (b)was rather rare, and (c)did not
      really have any statistically significant active linux user base.
      
      Removing this ISA 10Mbit driver support is unlikely to be even noticed
      by the user base of 3.9+ linux kernels, especially when the documentation
      clearly indicates the vintage with this text:
      
      	 "...designed to  work with all kernels > 1.1.33"
      Signed-off-by: default avatarPaul Gortmaker <paul.gortmaker@windriver.com>
      0ffd89e4
    • Paul Gortmaker's avatar
      drivers/net: delete old DEC depca ISA drivers support. · 1f1c7a5c
      Paul Gortmaker authored
      These are old ISA 10Mbit cards from the 1st 1/2 of the 1990s and
      required manual jumper settings in order to configure them.  Here
      we remove them on the premise that they are no longer used in any
      modern 3.9+ kernels.
      Signed-off-by: default avatarPaul Gortmaker <paul.gortmaker@windriver.com>
      1f1c7a5c
    • Paul Gortmaker's avatar
      drivers/net: delete the really obsolete 8390 based 10Mbit ISA drivers · fce3cd45
      Paul Gortmaker authored
      This is an area I know all too well, after being author of several 8390
      drivers, and maintainer of all 8390 drivers during a large part of their
      active lifecycle.
      
      To that end, I can say this with a reasonable degree of confidence.
      The drivers deleted here represent the earliest (as in early 1990)
      hardware and/or rare hardware.  The remaining hardware not deleted
      here is the more modern/sane of the lot, with ISA-PnP and jumperless
      "soft configuration" like the wd and smc cards had.
      
      The original ne2000 driver (ne.c) gets a pass at this time since
      AT/LANTIC based cards that could be both ne2000 or wd-like (with
      shared memory) and with jumperless configuration were made in the
      mid to late 1990's, and performed reasonably well for their era.
      Signed-off-by: default avatarPaul Gortmaker <paul.gortmaker@windriver.com>
      fce3cd45
    • Paul Gortmaker's avatar
      drivers/net: delete old fujitsu based eth16i driver · bb37f122
      Paul Gortmaker authored
      This is another driver for relatively rare 10Mbit hardware that
      originated in the early 1990's.  So we select it for removal at
      this point in time as well.
      
      Cc: Mika Kuoppala <miku@iki.fi>
      Signed-off-by: default avatarPaul Gortmaker <paul.gortmaker@windriver.com>
      bb37f122
    • Paul Gortmaker's avatar
      drivers/net: delete at1700 ISA 10Mbit driver · 13a80cb8
      Paul Gortmaker authored
      These Fujitsu MB86965 based ISA 10Mbit cards were another of the
      relatively rare cards dating from the early 1990s that for one reason
      or another didn't seem to get a lot of use in linux.  So we retire it
      now with a reasonable degree of confidence that it won't impact anyone.
      Signed-off-by: default avatarPaul Gortmaker <paul.gortmaker@windriver.com>
      13a80cb8