Musb can't work since the marco name has been changed.
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Steven Miao <realmz6@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Add pint suspend and resume if defined BFIN_GPIO_PINT.
Signed-off-by: Steven Miao <realmz6@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

save and restore pint sec CTL
save and restore pint registers
add pint suspend and resume when suspend to mem
Signed-off-by: Steven Miao <realmz6@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Scott Jiang <scott.jiang.linux@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Scott Jiang <scott.jiang.linux@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Steven Miao <realmz6@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Pass wake up source mask and wakeup source polarity to deepsleep and
hibernate.
Signed-off-by: Steven Miao <realmz6@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Steven Miao <realmz6@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Steven Miao <realmz6@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Set .probe_type = "map_rom" for norflash so that xip_test can run
correctly.
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Otherwise, the compiler may optimize assemble code into 8bit access instruction
when target register is 8 bit width.
Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Scott Jiang <scott.jiang.linux@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Add irq_set_wake to bfin_sec_irqchip, drivers like stmmac need it.
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Scott Jiang <scott.jiang.linux@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Steven Miao <realmz6@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Steven Miao <realmz6@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Add add deepsleep for bf60x.
1. Call DMC init functions to enter and exit DDR self refresh mode.
2. Wait till CGU PLL is locked after wake up and exit DDR self refresh mode.
3. Make asessembly function enter_deepsleep comply with C funtion ABI in
order to call other C functions.
4. Switch kernel stack by register EX_SCRATCH_REG.
Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Steven Miao <realmz6@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

ROM range of bf60x is above 0xb0000000.
Signed-off-by: Bob Liu <lliubbo@gmail.com>

So that user can set the clocks through menuconfig.
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Steven Miao <realmz6@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Steven Miao <realmz6@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Otherwise, chained sg list may be missed.
Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

We need larger DMA region to support HD video.
Signed-off-by: Scott Jiang <scott.jiang.linux@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

Extend chip select number supported by spi master as well
because we can accept SPISEL1-SPISEL7 and all GPIO.
Signed-off-by: Scott Jiang <scott.jiang.linux@gmail.com>
Signed-off-by: Bob Liu <lliubbo@gmail.com>

The SYSTEM_SUSPEND_DISK system state is never used, so drop it.
Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

Merge emailed kgdb dmesg fixups patches from Anton Vorontsov:
 "The dmesg command appears to be broken after the printk rework.  The
  old logic in the kdb code makes no sense in terms of current
  printk/logging storage format, and KDB simply hangs forever upon
  entering 'dmesg' command.

  The first patch revives the command by switching to kmsg_dumper
  iterator.  As a side-effect, the code is now much more simpler.

  A few changes were needed in the printk.c: we needed unlocked variant
  of the kmsg_dumper iterator, but these can surely wait for 3.6.

  It's probably too late even for the first patch to go to 3.5, but I'll
  try to convince otherwise.  :-) Here we go:

   - The current code is broken for sure, and has no hope to work at
     all.  It is a regression
   - The new code works for me, and probably works for everyone else;
   - If it compiles (and I urge everyone to compile-test it on your
     setup), it hardly can make things worse."

* Merge emailed patches from Anton Vorontsov: (4 commits)
  kdb: Switch to nolock variants of kmsg_dump functions
  printk: Implement some unlocked kmsg_dump functions
  printk: Remove kdb_syslog_data
  kdb: Revive dmesg command

The locked variants are prone to deadlocks (suppose we got to the
debugger w/ the logbuf lock held), so let's switch to nolock variants.
Signed-off-by: Anton Vorontsov <anton.vorontsov@linaro.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

If used from KDB, the locked variants are prone to deadlocks (suppose we
got to the debugger w/ the logbuf lock held).

So, we have to implement a few routines that grab no logbuf lock.

Yet we don't need these functions in modules, so we don't export them.
Signed-off-by: Anton Vorontsov <anton.vorontsov@linaro.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

The function is no longer needed, so remove it.
Signed-off-by: Anton Vorontsov <anton.vorontsov@linaro.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

The kgdb dmesg command is broken after the printk rework.  The old logic
in kdb code makes no sense in terms of current printk/logging storage
format, and KDB simply hangs forever.

This patch revives the command by switching to kmsg_dumper iterator.

The code is now much more simpler and shorter.
Signed-off-by: Anton Vorontsov <anton.vorontsov@linaro.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

Pull late MIPS fixes from Ralf Baechle:
 "This fixes a number of lose ends in the MIPS code and various bug
  fixes.

  Aside of dropping some patch that should not be in this pull request
  everything has sat in -next for quite a while and there are no known
  issues.

  The biggest patch in this patch set moves the allocation of an array
  that is aliased to a function (for runtime generated code) to
  assembler code.  This avoids an issue with certain toolchains when
  building for microMIPS."

* 'upstream' of git://git.linux-mips.org/pub/scm/ralf/upstream-linus: (35 commits)
  MIPS: PCI: Move fixups from __init to __devinit.
  MIPS: Fix bug.h MIPS build regression
  MIPS: sync-r4k: remove redundant irq operation
  MIPS: smp: Warn on too early irq enable
  MIPS: call set_cpu_online() on cpu being brought up with irq disabled
  MIPS: call ->smp_finish() a little late
  MIPS: Yosemite: delay irq enable to ->smp_finish()
  MIPS: SMTC: delay irq enable to ->smp_finish()
  MIPS: BMIPS: delay irq enable to ->smp_finish()
  MIPS: Octeon: delay enable irq to ->smp_finish()
  MIPS: Oprofile: Fix build as a module.
  MIPS: BCM63XX: Fix BCM6368 IPSec clock bit
  MIPS: perf: Fix build error caused by unused counters_per_cpu_to_total()
  MIPS: Fix Magic SysRq L kernel crash.
  MIPS: BMIPS: Fix duplicate header inclusion.
  mips: mark const init data with __initconst instead of __initdata
  MIPS: cmpxchg.h: Add missing include
  MIPS: Malta may also be equipped with MIPS64 R2 processors.
  MIPS: Fix typo multipy -> multiply
  MIPS: Cavium: Fix duplicate ARCH_SPARSEMEM_ENABLE in kconfig.
  ...

Pull device-mapper discard fixes from Alasdair G Kergon:
  - avoid a crash in dm-raid1 when discards coincide with mirror
    recovery;
  - avoid discarding shared data that's still needed in dm-thin;
  - don't guarantee that discarded blocks will be wiped in dm-raid1.

* tag 'dm-3.5-fixes-2' of git://git.kernel.org/pub/scm/linux/kernel/git/agk/linux-dm:
  dm raid1: set discard_zeroes_data_unsupported
  dm thin: do not send discards to shared blocks
  dm raid1: fix crash with mirror recovery and discard