This patch removes attempts to clear halts on a control endpoint (think
about it for a minute if you don't see why this is pointless....) and also
adds return-code checks for all places where halts are cleared.

This _should_ be just redundant code, but recent tests suggest that this
is, in fact, not the case.  People should _heavily_ test this patch.  I'm
going to pause here for a while (in the patch stream) until we've got this
sorted out -- initial results on my test setup seem to show some problems
still remain.  Where those problems are (HCD or usb-storage) remains to be
seen.

This patch fixes up some minor compilation problems.

This patch converts all uses of page_addres() to the sg_address() macro.
This will make backporting to 2.4 easier, as well as eliminate lots of
redundant code.

This patch removes tests of urb->status for EINPROGRESS.  As was pointed
out, that's not such a good idea, for a variety of reasons.

In the process, a semaphore became useless.

Here's a very simple patch that can go into the source tree right away.
It just fixes some occurrences of the scsi result code GOOD to GOOD << 1
in isd200.c.

Linus, please apply.  This defines wait_task_inactive() to be a no-op
on UP machines, and removes the #ifdef CONFIG_SMP which surrounds
current calls.

This also fixes compile on UP which was broken by the addition of a
call to wait_task_inactive in fs/exec.c which was not protected by an
#ifdef.

- Remove defunct active_list/inactive_list declarations (wli)

- Update an obsolete comment (wli)

- "mm/slab.c contains one leftover from the initial version with
  'unsigned short' bufctl entries.  The attached patch replaces '2'
  with the correct sizeof [which is now 4]" - Manfred Spraul

- BUG checks for vfree/vunmap being called in interrupt context
  (because they take irq-unsafe spinlocks, I guess?) - davej

- Simplify some coding in one_highpage_init() (Christoph Hellwig).

From Christoph Hellwig, also present in 2.4.

Create an arch-independent `dump_stack()' function.  So we don't need to do

#ifdef CONFIG_X86
	show_stack(0);		/* No prototype in scope! */
#endif

any more.

The whole dump_stack() implementation is delegated to the architecture.
If it doesn't provide one, there is a default do-nothing library
function.

- Remove the temp /proc/meminfo stats

- Make the mmu_gather_t be 2048 bytes again

- Removed unused variable (Oleg Nesterov)

If a GFP_NOFS allocation is made when the ZONE_NORMAL inactive list is
full of dirty or under-writeback pages, there is nothing the caller can
do to force some page reclaim.  The caller ends up getting oom-killed.

- In mempool_alloc(), don't try to perform page reclaim again.  Just
  go to sleep and wait for some elements to be returned to the pool.

- In try_to_free_pages(): perform a single, short scan of the LRU and
  if that doesn't work, fail the allocation.  GFP_NOFS allocators know
  how to handle that.

read_pages() is dropping the page refcount before running ->readpage().
Which just happens to work, because the page is in pagecache and
locked.

But it breaks under some unconventional things which reiser4 is doing,
and it's better/safer/saner this way anyway.

Patch from Jani Monoses <jani@iv.ro>

"This turns the remaining parts of ext3 to EXT3_SB and turns the
 latter from a macro to inline function which returns the generic_sbp
 field of u.

 linux/fs.h is not touched by this patch though.

 Intermezzo's three uses of ext3_sb are also not changed."

The patch adds a "Mapped" field to /proc/meminfo - tha amount of memory
which is mapped into pagetables.

This is a useful statistic to monitor when testing and observing the
vitual memory system.

From Hugh Dickins.  Fix a leak in the /proc/meminfo:ReverseMaps
accounting.

Rohit Seth's ia32 huge tlb pages patch.

Anton Blanchard took a look at this today; he seemed happy
with it and said he could borrow bits.

The /proc/meminfo:Buffers statistic is quite useful - it tells us
how effective we are being at caching filesystem metadata.

For example, increases in this figure are a measure of success of the
slablru and buffer_head-limitation patches.

The patch resurrects buffermem accounting.  The metric is calculated
on-demand, via a walk of the blockdev hashtable.

zap_page_range and truncate are the two main latency problems
in the VM/VFS.  The radix-tree-based truncate grinds that into
the dust, but no algorithmic fixes for pagetable takedown have
presented themselves...

Patch from Robert Love.

Attached patch implements a low latency version of "zap_page_range()".

Calls with even moderately large page ranges result in very long lock
held times and consequently very long periods of non-preemptibility.
This function is in my list of the top 3 worst offenders.  It is gross.

This new version reimplements zap_page_range() as a loop over
ZAP_BLOCK_SIZE chunks.  After each iteration, if a reschedule is
pending, we drop page_table_lock and automagically preempt.  Note we can
not blindly drop the locks and reschedule (e.g. for the non-preempt
case) since there is a possibility to enter this codepath holding other
locks.

... I am sure you are familar with all this, its the same deal as your
low-latency work.  This patch implements the "cond_resched_lock()" as we
discussed sometime back.  I think this solution should be acceptable to
you and Linus.

There are other misc. cleanups, too.

This new zap_page_range() yields latency too-low-to-benchmark: <<1ms.

into home.transmeta.com:/home/torvalds/v2.5/linux

This gets rid of ide_request/free_irq, ide_get/release_lock,
ide_check/request/release_region etc.

There is a perfectly good one in drivers/ide/ide-iops.c now.

and add exit_group to the syscall table.

into samba.org:/home/paulus/kernel/for-linus-ppc

The broadcast SIGKILL kept pending in the new thread as well, and killed
it prematurely ...

This implements one of the last missing POSIX threading details - exec()
semantics.  Previous kernels had code that tried to handle it, but that
code had a number of disadvantages:

 - it only worked if the exec()-ing thread was the thread group leader,
   creating an assymetry. This does not work if the thread group leader
   has exited already.

 - it was racy: it sent a SIGKILL to every thread in the group but did not
   wait for them to actually process the SIGKILL. It did a yield() but
   that is not enough. All 'other' threads have to finish processing
   before we can continue with the exec().

This adds the same logic, but extended with the following enhancements:

 - works from non-leader threads just as much as the thread group leader.

 - waits for all other threads to exit before continuing with the exec().

 - reuses the PID of the group.

It would perhaps be a more generic approach to add a new syscall,
sys_ungroup() - which would do largely what de_thread() does in this
patch.

But it's not really needed now - posix_spawn() is currently implemented
via starting a non-CLONE_THREAD helper thread that does a sys_exec().
There's no API currently that needs a direct exec() from a thread - but
it could be created (such as pthread_exec_np()).  It would have the
advantage of not having to go through a helper thread, but the
difference is minimal.

This fixes one more exit-time resource accounting issue - and it's also
a speedup and a thread-tree (to-be thread-aware pstree) visual
improvement.

In the current code we reparent detached threads to the init thread.
This worked but was not very nice in ps output: threads showed up as
being related to init.  There was also a resource-accounting issue, upon
exit they update their parent's (ie.  init's) rusage fields -
effectively losing these statistics.  Eg.  'time' under-reports CPU
usage if the threaded app is Ctrl-C-ed prematurely.

The solution is to reparent threads to the group leader - this is now
very easy since we have p->group_leader cached and it's also valid all
the time.  It's also somewhat faster for applications that use
CLONE_THREAD but do not use the CLONE_DETACHED feature.

This fixes a number of bugs that broke ptrace:

 - wait4 must not inhibit TASK_STOPPED processes even for thread group
   leaders.

 - do_notify_parent() should not delay the notification of parents if
   the thread in question is ptraced.

strace now works as expected for CLONE_THREAD applications as well.

This optimizes sys_exit_group() to only take the siglock if it's a true
thread group.  Boots & works fine.

This fixes three resource accounting related bugs introduced by detached
threads:

 - the 'child CPU usage' fields were updated in wait4 until now - this was
   slightly buggy for a number of reasons, eg. if the exit_code writout
   faults then it's possible to trigger this code multiple times.

 - those threads that do not go through wait4 were not properly accounted.

 - sched_exit() was incorrectly assuming that current == parent. In the
   detached case p->parent is the real parent.

with this patch applied things like 'time' work again for new-style
threaded apps.

This fixes a clone-flags bug noticed by Roland McGrath.  The current
CLONE_DETACHED & CLONE_THREAD forcing code did things in the wrong
order, which makes it possible to force an oops the following way:

        main () { syscall(120, 0x00400000); }

instead of changing the order of CLONE_SIGHAND and CLONE_THREAD flag
forcing (which would fix the bug), the proper approach is to fail with
-EINVAL if invalid combinations of clone flags are detected.  This
change does not affect existing applications.

the attached patch (against BK-curr) fixes a sys_wait4() bug noticed by
Ulrich Drepper. The kernel would not block properly if there are eligible
children delayed due to the new delayed thread-group-leader logic. The
solution is to introduce a new type of 'eligible child' type - and skip
over delayed children but set the wait4 flag nevertheless.

The libpthreads testcase that failed due to it now it works fine.

into samba.org:/home/paulus/kernel/for-linus-ppc

into samba.org:/home/paulus/kernel/for-linus-ppc