- 22 Jul, 2008 40 commits
-
-
Francois Romieu authored
Compile-tested only. Signed-off-by:
Francois Romieu <romieu@fr.zoreil.com> Signed-off-by:
Jeff Kirsher <jeffrey.t.kirsher@intel.com> Signed-off-by:
Jeff Garzik <jgarzik@redhat.com>
-
Jeff Kirsher authored
The email linux-nics@intel.com is no longer available, remove all references. Signed-off-by:
-
Joe Perches authored
Signed-off-by:
Joe Perches <joe@perches.com> Signed-off-by:
Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by:
-
Joe Perches authored
Redefine DPRINTK macro using do while(0) __FUNCTION__ to __func__ structs {} on separate lines Surround negative constants with () Signed-off-by: -
Joe Perches authored
Signed-off-by:
-
Joe Perches authored
Signed-off-by:
-
Joe Perches authored
Use struct e1000_hw *hw = adapter->hw; where necessary Change macros E1000_READ_REG and E1000_WRITE_REG to er32 and ew32 Signed-off-by:
-
Joe Perches authored
Signed-off-by:
-
Christoph Lameter authored
An | in an if statement to check a bit? I think this needs to be a &. As a result of this typo meth will always operate in promiscuous mode. Signed-off-by:
Christoph Lameter <cl@linux-foundation.org> Signed-off-by:
-
Jie Yang authored
Full patch for the Atheros L1E Gigabit Ethernet driver. Supportring AR8121, AR8113 and AR8114 Signed-off-by: Jie Yang <jie.yang @atheros.com> Signed-off-by: -
Jesse Brandeburg authored
The ixgbe driver was untested with device ID 8086:10c8 but still advertises support. Currently if this device is present in the system when the driver is loaded, the system will panic. Remove this device ID until full support can be tested with available hardware. This patch is necessary for 2.6.24, 2.6.25 and 2.6.26 Signed-off-by:
Jesse Brandeburg <jesse.brandeburg@intel.com> Signed-off-by:
-
Dave Jones authored
Signed-off-by:
Dave Jones <davej@redhat.com> Signed-off-by:
-
Dave Jones authored
The OQO model 2 has an RTL8139 from Atheros that doesn't like MMIO. It fails on modprobe, with a 'PCI Bus error' message. Force it to always use polled IO. Signed-off-by:
-
Dave Jones authored
This is needed to support devices that only work with PIO without penalising devices that work fine with MMIO in distro kernels. It also allows us to eventually use PIO as a fallback when setting up MMIO fails. Signed-off-by:
-
Wang Jian authored
MII_M1111_HWCFG_FIBER_COPPER_RES is a bit of MII_M1111_PHY_EXT_SR, not MII_M1111_PHY_EXT_CR. Signed-off-by:
Wang Jian <lark@linux.net.cn> Signed-off-by:
-
Wang Jian authored
The 27.15 bit (MII_M1111_HWCFG_FIBER_COPPER_AUTO) is disable bit. When set to 1, copper/fiber auto selection is disabled. The current code to enable but actually disable auto selection. Signed-off-by:
-
Harvey Harrison authored
Signed-off-by:
Harvey Harrison <harvey.harrison@gmail.com> Signed-off-by:
-
Harvey Harrison authored
drivers/net/igb/igb_main.c:388:20: warning: Using plain integer as NULL pointer Signed-off-by:
-
Ben Dooks authored
Remove magic numbers for items that we already have defined in the register header file. Signed-off-by:
Ben Dooks <ben-linux@fluff.org> Signed-off-by:
-
Ursula Braun authored
Signed-off-by:
Ursula Braun <ursula.braun@de.ibm.com> Signed-off-by:
-
Peter Tiedemann authored
Cc: Martin Schwidefsky <schwidefsky@de.ibm.com> Signed-off-by:
Peter Tiedemann <ptiedem@de.ibm.com> Signed-off-by:
-
Andy Richter authored
Cc: Martin Schwidefsky <schwidefska@de.ibm.com> Cc: Heiko Carstens <heiko.carstens@de.ibm.com> Signed-off-by:
Andy Richter <richtera@us.ibm.com> Signed-off-by:
-
Dhananjay Phadke authored
Change driver version to 4.0.0. Netxen firmwares as old as v3.4.216 are supported. Signed-off-by:
Dhananjay Phadke <dhananjay@netxen.com> Signed-off-by:
-
Dhananjay Phadke authored
Enable tso6 and ipv6 checksum, interrupt coalescing for NX3031. Signed-off-by:
-
Dhananjay Phadke authored
NX3031 supports cut-through operation where ingress packets are directly dma'ed into host buffers to reduce latency. This requires larger dma buffers (2kb) and different alignemnt. The buffer posting logic is changed a bit. The free rx buffers are maintained in linked list, since the received reference handles can be out of order. However rx descriptors are still posted sequentially, indexed by producer. Signed-off-by:
-
Dhananjay Phadke authored
MAC addr, multicast filters, mtu are set through firmware commands in firmware v4.0.0+ because of virtualization of physical ports. Link status is also read from registers allocated by firmware for each virtual port. Signed-off-by:
-
Dhananjay Phadke authored
Contains rx and tx ring context management and certain firmware commands for netxen firmware v4.0.0+. This patch gathers all HW context management code into netxen_nic_ctx.c. Signed-off-by:
-
Dhananjay Phadke authored
It had only couple of functions which are moved to main.c Signed-off-by:
-
Dhananjay Phadke authored
Add initialization code in pci probe for new chip and retain compatibility with old revisions. Signed-off-by:
-
Dhananjay Phadke authored
New revision of netxen chip has 2MB PCI memory. Older chips had 128MB addressable PCI memory. To retain compatibility, this patch adds function pointers based on pci bar0 size. Signed-off-by:
-
Dhananjay Phadke authored
Add macros for new chip revision and board configurations. Signed-off-by:
-
Dhananjay Phadke authored
Enable multicast address filtering capabilities in the hardware. Upto 16 multicast addresses can be programmed for each physical port. Support "allmulti" mode, if enabled. Signed-off-by:
-
Dhananjay Phadke authored
o Reduce access to global arrays in data path. o Remove duplicate/unused variables, unecessary alignment constraints. o Use correct pci_dev instead of fallback device for consistent allocations. o Disable ethtool set_eeprom functionality for now, it was only used for flashing firmware. Signed-off-by:
-
Ingo Molnar authored
various drivers were using the wrong APIs: drivers/built-in.o: In function `hp_probe1': hp.c:(.init.text+0xa280): undefined reference to `NS8390_init' fixed via: cd drivers/net/; sed -i 's/NS8390_/NS8390p_/g' \ $(grep -l NS8390_ $(grep 8390p.o Makefile | cut -d' ' -f3 | \ sed 's/.o$/.c/g')) Signed-off-by:Ingo Molnar <mingo@elte.hu> Signed-off-by:
-
Brice Goglin authored
Switch to ioremap_wc(). We keep the MTRR code since ioremap_wc() will use UC_MINUS when falling back to uncachable, and thus let the MTRR WC take precedence. Also rename the error path better. Signed-off-by:
Brice Goglin <brice@myri.com> Signed-off-by:
-
Brice Goglin authored
Remove the wcfifo since it never gave any performance improvement. Signed-off-by:
-
Wang Chen authored
IFF_PROMISC flag shouldn't be set or cleared by drivers, because whether device be promisc mode is decided by how many upper layer callers being referenced to it. And the promisc changing feature of de4x5 ioctl is developer debug feature, we can remove it now. Signed-off-by:
Wang Chen <wangchen@cn.fujitsu.com> Acked-by:
Grant Grundler <grundler@parisc-linux.org> Signed-off-by:
-
frank.blaschka@de.ibm.com authored
Adrian Bunk reports this build error: CC drivers/s390/net/qeth_l3_main.o /home/bunk/linux/kernel-2.6/git/linux-2.6/drivers/s390/net/qeth_l3_main.c: In function 'qeth_l3_hard_start_xmit': /home/bunk/linux/kernel-2.6/git/linux-2.6/drivers/s390/net/qeth_l3_main.c: 2654: error: implicit declaration of function 'VLAN_TX_SKB_CB' /home/bunk/linux/kernel-2.6/git/linux-2.6/drivers/s390/net/qeth_l3_main.c: 2654: error: invalid type argument of '->' (have 'int') make[3]: *** [drivers/s390/net/qeth_l3_main.o] Error 1 The intention of the driver appears to be to invalidate the VLAN tag. Change it to set skb->vlan_tci to zero, which has the same effect. Signed-off-by:
Patrick McHardy <kaber@trash.net> Signed-off-by:
Frank Blaschka <frank.blaschka@de.ibm.com> Signed-off-by:
-
Laurent Pinchart authored
The mdio_port, mdio_bit, mdc_port and mdc_bit fields in the fs_mii_bb_platform_info structure are left-overs from the move to the Phy Abstraction Layer subsystem. They are not used anymore and can be safely removed. Signed-off-by:
Laurent Pinchart <laurentp@cse-semaphore.com> Signed-off-by:
-
Jeff Garzik authored
Merge branch 'r8169-davem' of git://git.kernel.org/pub/scm/linux/kernel/git/romieu/netdev-2.6 into upstream-fixes
-
