into redhat.com:/garz/repo/net-drivers-2.5

* Previous patch wiped NAPI support, adding it back here.  But,
  with a twist: this one doesn't disable/enable interrupts each
  time we enter/leave polling.  (It's EXPERIMENTAL).

* Corrected indentation from previous patches

* Fixed controller wake-up through ASF

* Added Interrupt Throttle Rate tuning support

* Added method to flush Tx FIFO after link disconnect; the hardware
  hangs on to Tx skb's that were in flight prior to link loss

* Miscellaneous whitespace changes

* Changed "Compaq" branding to "HP"

* Optimized E1000_*_REG macros

* Completely clean Tx descriptor to avoid potential dirty descriptor
  fetching (rare, but possible)

* ISR cleanup; performing single PCI read

* Removed modulus math; decreases CPU utilization, especially on PPC64
  [anton@samba.org]

* Added MII support

* Added support for 82541 and 82547 gigabit ethernet adapters

* Fixed IRQ registration bug; IRQ now registered after resources are
  acquired

* Setting speed/duplex is now it's own routine
* Update ETHTOOL_GEEPROM routine to use new eeprom size variable

* Version, copyright, changelog and MAINTAINERS updates

* Documentation/networking/e1000.txt updates

This is the patch to support NEC PC-9800 subarchitecture
against 2.5.65-ac1. (9/14)

C-bus(PC98's legacy bus like ISA) network cards support.
Change IO port and IRQ assign.
Add NE2000 compatible driver for PC-9800.
  PCI netwwork card works fine without patch.

Regards,
Osamu Tomita

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Check if ASF is enabled in EEPROM, and if so, enable
  PME wakeup when suspending.

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Bug fix: read wrong byte in EEPROM when offset is odd number
* Bug fix: memory leak in ETHTOOL_GSTRINGS
  [Oleg Drokin <green@linuxhacker.ru]

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Validate updates to MAC address as valid ethernet address.

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Bug fix on e100_close when repeating hot remove/hot add
  from team.  Basically need to disable interurpts and
  unregister handler before shutting h/w down.
* Need to mask only the relevant bits in the interrupt
  status register

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Honor WOL settings in EEPROM: only advertise WOL magic
  packet if in EEPROM.

On Thu, 20 Mar 2003, Scott Feldman wrote:


* ICH5 support: chipset integrated LAN (8255x)
* PHY loopback diags is broken on all ICHs

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Bug fix when changing to non-autoneg, device may lose
  link with some switches, so try to recover link by
  forcing PHY.

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Get rid of all of the strong marketing brand strings
  and replace with simple pci_device_id table.  pci.ids
  should be the master list for device ID/strings.

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Bug fix on setting up Tx csum

On Thu, 20 Mar 2003, Scott Feldman wrote:


* clean up #includes

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Add support for VLAN hw offload

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Spelling mistakes

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Update version, copyright year, changelog

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Update Documentation/networking/e100.txt

On Thu, 20 Mar 2003, Scott Feldman wrote:


* Back this patch out - we'll add it later.  I was working against
  2.5.64 when this was checked into 2.5.65, so it messed up
  my patches.

Patch from Bob Miller <rem@osdl.org>

The get_disk() function should check the return value from kobject_get()
before passing it to to_disk().  This patch fixes this error.

(Acked by Pat)

Patch from Andreas Gruenbacher <agruen@suse.de>

In both 2.5 and 2.4, the fs/nfsd/vfs.c:nfsd_symlink() function calls down to
notify_change().  If notify_change fails for some reason, the error code is
not converted to an nfs no-the-wire error code as is should.  The attached
patches fix that (one for 2.4, the other for 2.5).

Patch from Martin J. Bligh and Dave Hansen

People with ordinary PCs are accidentally turning on NUMA support, and people
with NUMA machines are finding the NUMA option mysteriously disappearing.
This patch sets the defaults to sane things for everyone, and only allows you
to turn on NUMA with both SMP and 64Gb support on (it's useful for the
distros on non-Summit boxes, but not on their UP kernels ;-)).

I've also moved it below the highmem options, as it logically depends on
them, so this makes more sense.  For those searching for NUMA support on
*real* NUMA machine, Dave has provided some guiding comments to show them
what they messed up (it's totally non-obvious).  Hopefully this will stop
people's recent unfortunate foot-wounds (I think UP machines were defaulting
to NUMA on ...  oops).

This makes sysrq facilities available to remote users.

Writing a 'C' to /proc/sysrq-trigger receives the same treatment as typing
sysrq-C on the local keyboard.

Patch from Dave Hansen <haveblue@us.ibm.com>

Adds some commentary to these newly-introduced macros.

Patch from John Levon <levon@movementarian.org>

wli got an oops from this. The callbacks call mod_timer so the timer had
better be setup by then