- 24 Nov, 2010 18 commits
-
-
Sascha Hauer authored
There's no point showing this option to the user. The correct value will be selected anyway. Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Sascha Hauer authored
This patch adds a Kconfig option for the avic irq controller and lets the SoCs that need it select this option. Also, as we have two irq controllers for i.MX, irq.c is not appropriate anymore, so rename it to avic.c Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Sascha Hauer authored
PHYS_OFFSET may become a variable once the runtime PHYS_OFFSET patch is merged, so use MX51_PHYS_OFFSET for boot_params. Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Fabio Estevam authored
Add support for esdhc on mx51_3ds board. Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com> Acked-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Arnaud Patard (Rtp) authored
Commit "ARM: i.MX IOMUX-V3 replace struct pad_desc with bitmapped cookie" (b705cb4d42e95a4a43a8945571c8613e71526c3d) introduced a typo which was preventing my efikamx to boot. This patch is fixing that. Signed-off-by: Arnaud Patard <arnaud.patard@rtp-net.org> Tested-by: Fabio Estevam <fabio.estevam@freescale.com> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Arnaud Patard (Rtp) authored
The efikamx board is using a gpio to reset the board so add support for it Signed-off-by: Arnaud Patard <arnaud.patard@rtp-net.org> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Arnaud Patard (Rtp) authored
On efikamx, uboot is stored on a nor spi flash. Add support for it Signed-off-by: Arnaud Patard <arnaud.patard@rtp-net.org> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Arnaud Patard (Rtp) authored
s/NO_PAD_CTRL/MX51_GPIO_PAD_CTRL/ Signed-off-by: Arnaud Patard <arnaud.patard@rtp-net.org> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Arnaud Patard (Rtp) authored
This patch adds support for power key button of the efika mx. It's connected on GPIO 2 31. Signed-off-by: Arnaud Patard <arnaud.patard@rtp-net.org> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Arnaud Patard (Rtp) authored
The efika mx a 3 leds (1 blue, 1 red, 1 green) connected on GPIOS 3 13/14/15. Also, some special care is done for default trigger of blue led for mmc as the mmc host used is different between hw revisions Signed-off-by: Arnaud Patard <arnaud.patard@rtp-net.org> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Arnaud Patard (Rtp) authored
Add definitions for configuring CSI1_{H,V}SYNC as GPIO Signed-off-by: Arnaud Patard <arnaud.patard@rtp-net.org> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Arnaud Patard (Rtp) authored
The efika mx is using a esdhc host for mmc support. Now that the sdhci has support for it, enable it. Signed-off-by: Arnaud Patard <arnaud.patard@rtp-net.org> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Arnaud Patard (Rtp) authored
- add definition to configure pads as ESDHC{1,2} WP and CD Signed-off-by: Arnaud Patard <arnaud.patard@rtp-net.org> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Arnaud Patard (Rtp) authored
- ALT0 is used to set GPIO mode of GPIO_1_{2,3,4,5,6,7,8,9} but it's ALT1 for GPIO_1_{0,1}. Signed-off-by: Arnaud Patard <arnaud.patard@rtp-net.org> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Arnaud Patard (Rtp) authored
read board id value from the GPIO3_16/17/11 Signed-off-by: Arnaud Patard <arnaud.patard@rtp-net.org> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Fabio Estevam authored
On the mx31_3ds board the touchscreen feature is provided by MC13783 PMIC. Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
Lothar Waßmann authored
The following patch is a first step to convert the 'struct pad_desc' to a bitmapped cookie to facilitate adding platform specific pullup or drive strength definitions to existing pad definitions without need to rewrite the complete pad def. The patch wraps 'struct pad_desc' in an opaque data type and introduces macros to access the individual members. This patch does not constitute any functional change! Signed-off-by: Lothar Waßmann <LW@KARO-electronics.de> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
-
-
- 21 Nov, 2010 1 commit
-
-
Linus Torvalds authored
-
- 20 Nov, 2010 3 commits
-
-
git://git.kernel.org/pub/scm/linux/kernel/git/tytso/ext4Linus Torvalds authored
* 'for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tytso/ext4: ext4: Add EXT4_IOC_TRIM ioctl to handle batched discard fs: Do not dispatch FITRIM through separate super_operation ext4: ext4_fill_super shouldn't return 0 on corruption jbd2: fix /proc/fs/jbd2/<dev> when using an external journal ext4: missing unlock in ext4_clear_request_list() ext4: fix setting random pages PageUptodate
-
Lukas Czerner authored
Filesystem independent ioctl was rejected as not common enough to be in core vfs ioctl. Since we still need to access to this functionality this commit adds ext4 specific ioctl EXT4_IOC_TRIM to dispatch ext4_trim_fs(). It takes fstrim_range structure as an argument. fstrim_range is definec in the include/linux/fs.h and its definition is as follows. struct fstrim_range { __u64 start; __u64 len; __u64 minlen; } start - first Byte to trim len - number of Bytes to trim from start minlen - minimum extent length to trim, free extents shorter than this number of Bytes will be ignored. This will be rounded up to fs block size. After the FITRIM is done, the number of actually discarded Bytes is stored in fstrim_range.len to give the user better insight on how much storage space has been really released for wear-leveling. Signed-off-by: Lukas Czerner <lczerner@redhat.com> Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
-
Lukas Czerner authored
There was concern that FITRIM ioctl is not common enough to be included in core vfs ioctl, as Christoph Hellwig pointed out there's no real point in dispatching this out to a separate vector instead of just through ->ioctl. So this commit removes ioctl_fstrim() from vfs ioctl and trim_fs from super_operation structure. Signed-off-by: Lukas Czerner <lczerner@redhat.com> Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
-
- 19 Nov, 2010 18 commits
-
-
git://git.kernel.org/pub/scm/linux/kernel/git/sage/ceph-clientLinus Torvalds authored
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/sage/ceph-client: ceph: fix readdir EOVERFLOW on 32-bit archs ceph: fix frag offset for non-leftmost frags ceph: fix dangling pointer ceph: explicitly specify page alignment in network messages ceph: make page alignment explicit in osd interface ceph: fix comment, remove extraneous args ceph: fix update of ctime from MDS ceph: fix version check on racing inode updates ceph: fix uid/gid on resent mds requests ceph: fix rdcache_gen usage and invalidate ceph: re-request max_size if cap auth changes ceph: only let auth caps update max_size ceph: fix open for write on clustered mds ceph: fix bad pointer dereference in ceph_fill_trace ceph: fix small seq message skipping Revert "ceph: update issue_seq on cap grant"
-
git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6Linus Torvalds authored
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6: (31 commits) net: fix kernel-doc for sk_filter_rcu_release be2net: Fix to avoid firmware update when interface is not open. netfilter: fix IP_VS dependencies net: irda: irttp: sync error paths of data- and udata-requests ipv6: Expose reachable and retrans timer values as msecs ipv6: Expose IFLA_PROTINFO timer values in msecs instead of jiffies 3c59x: fix build failure on !CONFIG_PCI ipg.c: remove id [SUNDANCE, 0x1021] net: caif: spi: fix potential NULL dereference ath9k_htc: Avoid setting QoS control for non-QoS frames net: zero kobject in rx_queue_release net: Fix duplicate volatile warning. MAINTAINERS: Add stmmac maintainer bonding: fix a race in IGMP handling cfg80211: fix can_beacon_sec_chan, reenable HT40 gianfar: fix signedness issue net: bnx2x: fix error value sign 8139cp: fix checksum broken r8169: fix checksum broken rds: Integer overflow in RDS cmsg handling ...
-
Uwe Kleine-König authored
and restore alphabetic ordering. Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
This bases on a patch by Fabio Estevam who added the device before it was allocated dynamically. Cc: Fabio Estevam <fabio.estevam@freescale.com> Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
While adapting the #defines for this I noticed that the offset used for USB HS on i.MX35 differs from the documented offset. I kept the working offset and commented that the documentation differs. Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
Compared to the static devices the dynamic have a DMA resource. This should be save as it seems unused in the driver. Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
Additionally convert some known to be good usages to the new names. Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
... instead of MX3x Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
Some usages of ARCH_MX25 are assuming that if it is defined the other SoCs are undefined. Use SOC_IMX25 for the save places. Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
This prepares multi-SoC kernel support. Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
This way FB_IMX can just depend on HAVE_FB_IMX and machines just need to select IMX_HAVE_PLATFORM_IMX_FB without bothering about HAVE_FB_IMX. Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-
Uwe Kleine-König authored
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
-