- 10 Feb, 2021 37 commits
-
-
Johannes Berg authored
This is not (or no longer) used, so remove it. Signed-off-by:
Johannes Berg <johannes.berg@intel.com> Signed-off-by:
Luca Coelho <luciano.coelho@intel.com> Link: https://lore.kernel.org/r/iwlwifi.20210210171218.ed18d7c8e7b8.Ic3fdf7c8636f332e3d5ee5841b03bf85e3bc4855@changeidSigned-off-by:
-
Abhishek Naik authored
Return value of the iwl_mvm_load_nvm_to_nic func is not analyzed. If load NVM to nic func fails and NVM is not loaded to fw properly, then fw may behave badly and lead to some strange issue. This commit will analyze return value and if load NVM to nic has failed, then the error code is sent to the previous func, which will trigger WRT log collection. iwl_fw_dbg_error_collect() func collects dump only if tri type is FW_DBG_TRIGGER_ALIVE_TIMEOUT. But when Load NVM to nic function fails trig_type is FW_DBG_TRIGGER_DRIVER. This commit also has code changes to collect dump when trig_type is FW_DBG_TRIGGER_DRIVER. Signed-off-by:
Abhishek Naik <abhishek.naik@intel.com> Signed-off-by:
-
Sara Sharon authored
We may want to remove it before it started (i.e. before the actual switch time). Signed-off-by:
Sara Sharon <sara.sharon@intel.com> Fixes: 58ddd9b6 ("iwlwifi: mvm: don't send a CSA command the firmware doesn't know") Signed-off-by:
-
Ilan Peer authored
Since the firmware support for internal station for auxiliary activities, there is no need to configure an auxiliary station as part of SCAN_CFG_CMD. Thus, this configuration was removed from the corresponding structure. Align the code accordingly. Signed-off-by:
Ilan Peer <ilan.peer@intel.com> Signed-off-by:
-
Emmanuel Grumbach authored
This will soon be a bit more complicated. Take it out to a function. Signed-off-by:
Emmanuel Grumbach <emmanuel.grumbach@intel.com> Signed-off-by:
-
Emmanuel Grumbach authored
No need to pass the dbgfs_dir just to assign it to mvm. Assign to mvm and then call iwl_mvm_dbgfs_register. This is a preparation towards the addition of a delayed op_mode_start flow. This will allow to split the op_mode_start flow. Registration to debugfs must happen after we register to mac80211 and the registration to mac80211 will soon be delayed in certain cases. In order not to have to remember the debugfs_dir in a separate variable, just set it into the mvm structure so that it can be usable later. Declare mvm->debugfs_dir in the iwl_mvm structure even when IWLWIFI_DEBUGFS isn't enabled to simplify the source code. Signed-off-by:
-
Emmanuel Grumbach authored
All the actions that were taken after the registration can be taken before the registration to mac80211. This will help to defer part of the op_mode_mvm_start function to a later stage in case the device is not available. Signed-off-by:
-
Gregory Greenman authored
BIOS provides RFI feature enable/disable state via WiFi DSM ACPI object. By default the feature should be disabled. The GUID for this feature is different from the one driver currently uses, so need to provide a set of new definitions. Signed-off-by:
Gregory Greenman <gregory.greenman@intel.com> Signed-off-by:
-
Gregory Greenman authored
RF Interference Mitigation is a new feature targeted to handle the problem of interference between DDR memory and WiFi. The role of the driver is to configure FW with the table holding a mapping between problematic channels/bands and the corresponding frequencies. This patch adds RFI infrastructure and adds two debugfs hooks: - send RFI configuration command (currently with a default table) which will reset feature in the FW - read the table, used by the FW (which can be a subset of the table that driver sent). Signed-off-by:
-
Miri Korenblit authored
Add support for version 2 of the LARI_CONFIG_CHANGE command. this is needed to support UHB enable/disable from BIOS Signed-off-by:
Miri Korenblit <miriam.rachel.korenblit@intel.com> Signed-off-by:
-
Emmanuel Grumbach authored
WARNING is better than crashing. Since this happened to me, be on the safe side. Signed-off-by:
-
Mukesh Sisodiya authored
Once sending the REPLY_ERROR group ID is not set and this lead to get it set to wrong value LONG_GROUP later in default handling Fix this by checking the REPLY_ERROR and avoid changing the Group ID Signed-off-by:
Mukesh Sisodiya <mukesh.sisodiya@intel.com> Signed-off-by:
-
Matti Gottlieb authored
Add support for AX201 and AX211 radio modules, which we call HR2 and GF, respectively. These modules can be used with the Ma family of devices and above. Signed-off-by:
Matti Gottlieb <matti.gottlieb@intel.com> Signed-off-by:
-
Matti Gottlieb authored
Some new devices contain an extra bit in the CRF ID register to denote that they support CDB. Add definitions and macros to be able to support it and add the "NO_CDB" to all existing entired. Signed-off-by:
-
Haim Dreyfuss authored
iwl_acpi_get_wifi_pkg() may return a valid pointer (meaning success), while `tbl_rev` is invalid (equel to 1). In this case, we will treat that as an error. Subsequent "users" of this "error code" may either check for nonzero (good; pointers are never zero) or negative (bad; pointers may be "positive") fix that by splitting the if statement. First check if IS_ERR(wifi_pkg) and then if tbl_rev != 0. Signed-off-by:
Haim Dreyfuss <haim.dreyfuss@intel.com> Signed-off-by:
-
Mordechay Goodstein authored
In case we get TX sequence number out of range, trigger fake tx time point to collect FW debug data. Signed-off-by:
Mordechay Goodstein <mordechay.goodstein@intel.com> Signed-off-by:
-
Johannes Berg authored
Since we no longer save interrupts, we no longer need the flags argument here, remove it throughout. Signed-off-by:
-
Naftali Goldstein authored
The NIC supports this, so set the relevant bits in the HE PHY capabilities. Signed-off-by:
Naftali Goldstein <naftali.goldstein@intel.com> Signed-off-by:
-
Mordechay Goodstein authored
The first use is collecting debug data when transport stops the device. Signed-off-by:
-
Johannes Berg authored
Clean up some documentation references and some bits in the enums to make the documentation more useful. Signed-off-by:
-
Mordechay Goodstein authored
In case user requested to register an unsupported regions, remove it from active list and trigger list, this saves operational driver memory and run time at collecting debug data. Signed-off-by:
-
Matti Gottlieb authored
The Ma device ID needs to be 0x7E40 instead of 0x7E80. Signed-off-by:
-
Mordechay Goodstein authored
Control field is set by mac80211 only if case rate is not offloaded to hw. Signed-off-by:
-
Emmanuel Grumbach authored
Remember that those pointers have been freed by setting them to NULL. Otherwise, we'd keep rxq pointing to random memory which would prevent us from trying to re-allocate the Rx resources if we call rx_alloc again. Also, propagate the allocation failure to the caller of iwl_pcie_nic_init so that we won't go further in the start flow. Signed-off-by:
-
Luca Coelho authored
The call to iwl_sar_geo_init() was moved to the end of the iwl_mvm_sar_geo_init() function, after the table revision is assigned to the FW command. But the revision is only known after iwl_sar_geo_init() is called, so we were always assigning zero to it. Fix that by moving the assignment code after the iwl_sar_geo_init() function is called. Signed-off-by:
-
Johannes Berg authored
This is called exactly once, a few lines down, so there's no point in having the extra function. Signed-off-by:
-
Emmanuel Grumbach authored
Add the count and the mode to the modify CSA flow. Signed-off-by:
-
Luca Coelho authored
Some change conflicts apparently cause a confusion between a local variable being used to send the PPAG command and the introduction of a union for this command. Most parts of the local command were never copied from the stored data, so the FW was getting garbage in the tables instead of getting valid values. Fix this by completely removing the local and using only the union that we have stored in fwrt. Signed-off-by:
-
Luca Coelho authored
When reading the PPAG table from ACPI, we should store everything in our fwrt structure, so it can be accessed later. But we had a local ppag_table variable in the function and were erroneously storing the enabled/disabled flag in it instead of storing it in the fwrt. Fix this by removing the local variable and storing everything directly in fwrt. Signed-off-by:
-
Luca Coelho authored
The value we receive from ACPI is a long long unsigned integer but the values should be treated as signed char. When comparing the received value with ACPI_PPAG_MIN_LB/HB, we were doing an unsigned comparison, so the negative value would actually be treated as a very high number. To solve this issue, assign the value to our table of s8's before making the comparison, so the value is already converted when we do so. Signed-off-by:
-
Luca Coelho authored
We were erroneously adding 3 extra values to the table size calculation, when we should actually add only a 2 (one for the domain type and one for the enabled/disabled flag). Fix this for both revisions we support. Signed-off-by:
-
Johannes Berg authored
The only thing we do touching the device in hard interrupt context is, at most, writing an interrupt ACK register, which isn't racing in with anything protected by the reg_lock. Thus, avoid disabling interrupts here for potentially long periods of time, particularly long periods have been observed with dumping of firmware memory (leading to lockup warnings on some devices.) Signed-off-by:
-
Luca Coelho authored
Some devices were missing from the So with Hr section. Signed-off-by:
-
Takashi Iwai authored
The ucode TLV data may be read-only and should be treated as const pointers, but currently a few code forcibly cast to the writable pointer unnecessarily. This gave developers a wrong impression as if it can be modified, resulting in crashing regressions already a couple of times. This patch adds the const prefix to those cast pointers, so that such attempt can be caught more easily in future. Signed-off-by:
Takashi Iwai <tiwai@suse.de> Acked-by:
-
Ihab Zhaika authored
add few PCI ID'S for So with Hr and Qu with Hr in AX family. Cc: stable@vger.kernel.org Signed-off-by:
Ihab Zhaika <ihab.zhaika@intel.com> Signed-off-by:
-
Jiapeng Chong authored
Fix the following coccicheck warning: ./drivers/net/wireless/realtek/rtlwifi/rtl8821ae/phy.c:3853:7-17: WARNING: Comparison of 0/1 to bool variable. Reported-by:
Abaci Robot <abaci@linux.alibaba.com> Signed-off-by:
Jiapeng Chong <jiapeng.chong@linux.alibaba.com> Signed-off-by:
Kalle Valo <kvalo@codeaurora.org> Link: https://lore.kernel.org/r/1612840381-109714-1-git-send-email-jiapeng.chong@linux.alibaba.com
-
Jiapeng Chong authored
Fix the follow coccicheck warnings: ./drivers/net/wireless/realtek/rtlwifi/rtl8192se/hw.c:2305:6-27: WARNING: Comparison of 0/1 to bool variable. ./drivers/net/wireless/realtek/rtlwifi/rtl8192se/hw.c:1376:5-26: WARNING: Comparison of 0/1 to bool variable. Reported-by:
-
- 09 Feb, 2021 1 commit
-
-
Alvin Šipraga authored
Add support for CQM RSSI measurement reporting and advertise the NL80211_EXT_FEATURE_CQM_RSSI_LIST feature. This enables a userspace supplicant such as iwd to be notified of changes in the RSSI for roaming and signal monitoring purposes. Signed-off-by:
Alvin Šipraga <alsi@bang-olufsen.dk> Reviewed-by:
Arend van Spriel <arend.vanspriel@broadcom.com> Signed-off-by:
-
- 08 Feb, 2021 2 commits
-
-
https://github.com/nbd168/wirelessKalle Valo authored
mt76 patches for 5.12 * add new mt7921e driver * factor out common code shared between 7615/7663 and 7921 * performance optimizations * 7915 dbdc fixes * 802.11 encap offload support * support for multiple pcie gen1 host interfaces on 7915 * 7915 testmode support * bugfixes * testmode support enhancements * endian fixes * 7915 txbf support
-
Kalle Valo authored
Merge tag 'iwlwifi-next-for-kalle-2021-02-05' of git://git.kernel.org/pub/scm/linux/kernel/git/iwlwifi/iwlwifi-next iwlwifi patches intended for v5.12 * Check FW notification sizes for robustness; * Improvements in the NAPI implementation; * Implement a workaround for CCA-EXT; * Add new FW API support; * Fix a CSA bug; * Implement PHY integration version parsing; * A bit of refactoring; * One more CSA bug fix, this time in the AP side; * Support for new So devices and a bit of reorg; * Per Platform Antenna Gain (PPAG) fixes and improvements; * Improvements in the debug framework; * Some other clean-ups and small fixes. # gpg: Signature made Fri 05 Feb 2021 12:04:21 PM EET using RSA key ID 1A3CC5FA # gpg: Good signature from "Luciano Roth Coelho (Luca) <luca@coelho.fi>" # gpg: aka "Luciano Roth Coelho (Intel) <luciano.coelho@intel.com>"
-
