• Russell Currey's avatar
    powerpc/pci: Always print PHB and PE numbers as hexadecimal · 1f52f176
    Russell Currey authored
    PHB, PE (and by association MVE) numbers are printed as a mix of decimal
    and hexadecimal throughout the kernel.  This can be misleading, so make
    them all hexadecimal.
    
    Standardising on hex instead of dec because:
    
     - PHB numbers are presented in hex in sysfs/debugfs (and lspci, etc)
     - PE numbers are presented as hex in sysfs and parsed in hex in debugfs
    
    The only place I think this could cause confusing are the messages during
    boot, i.e.
    
    	pci 000a:01     : [PE# 000] Secondary bus 1 associated with PE#0
    
    which can be a quick way to check PE numbers.  pe_level_printk() will
    only print two characters instead of three, so the above would be
    
    	pci 000a:01     : [PE# 00] Secondary bus 1 associated with PE#0
    
    which gives a hint it's in hex.
    Signed-off-by: default avatarRussell Currey <ruscur@russell.cc>
    Signed-off-by: default avatarMichael Ellerman <mpe@ellerman.id.au>
    1f52f176
eeh.c 46.4 KB