• Joe Eykholt's avatar
    [SCSI] fnic: Add FIP support to the fnic driver · 78112e55
    Joe Eykholt authored
    Use libfcoe as a common FIP implementation with fcoe.
    FIP or non-FIP mode is fully automatic if the firmware
    supports and enables it.
    
    Even if FIP is not supported, this uses libfcoe for the non-FIP
    handling of FLOGI and its response.
    
    Use the new lport_set_port_id() notification to capture
    successful FLOGI responses and port_id resets.
    
    While transitioning between Ethernet and FC mode, all rx and
    tx FC frames are queued.  In Ethernet mode, all frames are
    passed to the exchange manager to capture FLOGI responses.
    
    Change to set data_src_addr to the ctl_src_addr whenever it
    would have previously been zero because we're not logged in.
    This seems safer so we'll never send a frame with a 0 source MAC.
    This also eliminates a special case for sending FLOGI frames.
    Signed-off-by: default avatarJoe Eykholt <jeykholt@cisco.com>
    Signed-off-by: default avatarRobert Love <robert.w.love@intel.com>
    Signed-off-by: default avatarJames Bottomley <James.Bottomley@suse.de>
    78112e55
Kconfig 68 KB