Correct race condition where ioaccel is re-enabled before the raid_map is
updated. For RAID_1, RAID_1ADM, and RAID 5/6 there is a BUG_ON called which
is bad.

 - Change event thread to disable ioaccel only. Send all requests down the
   RAID path instead.

 - Have rescan thread handle offload_enable.

 - Since there is only one rescan allowed at a time, turning
   offload_enabled on/off should not be racy. Each handler queues up a
   rescan if one is already in progress.

  - For timing diagram, offload_enabled is initially off due to a change
    (transformation: splitmirror/remirror), ...

  otbe = offload_to_be_enabled
  oe   = offload_enabled

  Time Event         Rescan              Completion     Request
       Worker        Worker              Thread         Thread
  ---- ------        ------              ----------     -------
   T0   |             |                       + UA      |
   T1   |             + rescan started        | 0x3f    |
   T2   + Event       |                       | 0x0e    |
   T3   + Ack msg     |                       |         |
   T4   |             + if (!dev[i]->oe &&    |         |
   T5   |             |     dev[i]->otbe)     |         |
   T6   |             |      get_raid_map     |         |
   T7   + otbe = 1    |                       |         |
   T8   |             |                       |         |
   T9   |             + oe = otbe             |         |
   T10  |             |                       |         + ioaccel request
   T11                                                  * BUG_ON

  T0 - I/O completion with UA 0x3f 0x0e sets rescan flag.
  T1 - rescan worker thread starts a rescan.
  T2 - event comes in
  T3 - event thread starts and issues "Acknowledge" message
  ...
  T6 - rescan thread has bypassed code to reload new raid map.
  ...
  T7 - event thread runs and sets offload_to_be_enabled
  ...
  T9 - rescan thread turns on offload_enabled.
  T10- request comes in and goes down ioaccel path.
  T11- BUG_ON.

 - After the patch is applied, ioaccel_enabled can only be re-enabled in
   the re-scan thread.

Link: https://lore.kernel.org/r/158472877894.14200.7077843399036368335.stgit@brunhildaReviewed-by: Scott Teel <scott.teel@microsemi.com>
Reviewed-by: Matt Perricone <matt.perricone@microsemi.com>
Reviewed-by: Scott Benesh <scott.benesh@microsemi.com>
Signed-off-by: Don Brace <don.brace@microsemi.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>