• Yan-Hsuan Chuang's avatar
    rtw88: configure firmware after HCI started · 0b8dc6ab
    Yan-Hsuan Chuang authored
    After firmware has been downloaded, driver should send
    some information to it through H2C commands. Those H2C
    commands are transmitted through TX path.
    
    But before HCI has been started, the TX path is not
    working completely. Such as PCI interfaces, the interrupts
    are not enabled, hence TX interrupts will not be issued
    after H2C skb has been DMAed to the device. And the H2C
    skbs will not be released until the device is powered off.
    Signed-off-by: default avatarYan-Hsuan Chuang <yhchuang@realtek.com>
    Signed-off-by: default avatarKalle Valo <kvalo@codeaurora.org>
    0b8dc6ab
mac.c 23.6 KB