[ Upstream commit b389f173 ]

When using RS485 in half duplex, RX should be enabled when TX is
finished, and stopped when TX starts.

Before commit 0058f087 ("tty/serial: atmel: fix RS485 half
duplex with DMA"), RX was not disabled in atmel_start_tx() if the DMA
was used. So, collisions could happened.

But disabling RX in atmel_start_tx() uncovered another bug:
RX was enabled again in the wrong place (in atmel_tx_dma) instead of
being enabled when TX is finished (in atmel_complete_tx_dma), so the
transmission simply stopped.

This bug was not triggered before commit 0058f087
("tty/serial: atmel: fix RS485 half duplex with DMA") because RX was
never disabled before.

Moving atmel_start_rx() in atmel_complete_tx_dma() corrects the problem.

Cc: stable@vger.kernel.org
Reported-by: Gil Weber <webergil@gmail.com>
Fixes: 0058f087Tested-by: Gil Weber <webergil@gmail.com>
Signed-off-by: Richard Genoud <richard.genoud@gmail.com>
Acked-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Signed-off-by: Sasha Levin <alexander.levin@verizon.com>