• Linus Torvalds's avatar
    Merge tag 'regulator-v4.18' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator · 68cc38ff
    Linus Torvalds authored
    Pull regulator updates from Mark Brown:
     "Quite a lot of core work this time around, though not 100% successful.
    
      We gained support for runtime mode changes thanks to David Collins and
      improved support for write only regulators (ones where we can't read
      back the configuration) from Douglas Anderson.
    
      There's been quite a bit of work from Linus Walleij on converting from
      specfying GPIOs by numbers to descriptors. Sadly the testing turned
      out to be less good than we had hoped and so a lot of this had to be
      reverted.
    
      We also have the start of updates to use coupled regulators from
      Maciej Purski, unfortunately there are further problems there so the
      last couple of patches have been reverted.
    
      We also have new drivers for BD71837 and SY8106A devices, SAW
      regulators on Qualcomm SPMI and dropped support for some preproduction
      chips that never made it to market from the AB8500 driver"
    
    * tag 'regulator-v4.18' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator: (57 commits)
      regulator: gpio: Revert
      ARM: pxa, regulator: fix building ezx e680
      regulator: Revert coupled regulator support again
      regulator: wm8994: Fix shared GPIOs
      regulator: max77686: Fix shared GPIOs
      regulator: bd71837: BD71837 PMIC regulator driver
      regulator: bd71837: Devicetree bindings for BD71837 regulators
      regulator: gpio: Get enable GPIO using GPIO descriptor
      regulator: fixed: Convert to use GPIO descriptor only
      regulator: s2mps11: Fix boot on Odroid XU3
      dt-bindings: qcom_spmi: Document SAW support
      regulator: qcom_spmi: Add support for SAW
      regulator: tps65090: Pass descriptor instead of GPIO number
      regulator: s5m8767: Pass descriptor instead of GPIO number
      regulator: pfuze100: Delete reference to ena_gpio
      regulator: max8952: Pass descriptor instead of GPIO number
      regulator: lp8788-ldo: Pass descriptor instead of GPIO number
      regulator: lm363x: Pass descriptor instead of GPIO number
      regulator: max8973: Pass descriptor instead of GPIO number
      regulator: mc13xxx-core: Switch to SPDX identifier
      ...
    68cc38ff
mc13783-regulator.c 15.4 KB