• Eliad Peller's avatar
    wlcore: add p2p device support · 7845af35
    Eliad Peller authored
    When starting a p2p mgmt interface, enable its device role. This
    allows us to keep the sta role disabled and scan on the dev role.
    
    In general, p2p management interfaces cannot send vif-specific commands
    to FW, as the vif role id is invalid. Only off-channel data and scans
    happen on this vif, so most ops are not relevant.
    
    If the vif is a p2p mgmt vif, block some mac80211 ops.
    
    Configure rate policies for p2p mgmt interface, as
    otherwise p2p packets come out with arbitrary rates.
    
    Since wpa_supplicant currently doesn't support standalone
    p2p device mode (without another attached managed interface),
    add p2p device to the allowed interface combinations without
    decreasing the allowed station count.
    
    Moreover, increase the station count in some cases, as AP
    mode usually starts as station interface, and the AP interface
    is now different from the p2p management one).
    Signed-off-by: default avatarArik Nemtsov <arik@wizery.com>
    Signed-off-by: default avatarEliad Peller <eliad@wizery.com>
    Signed-off-by: default avatarKalle Valo <kvalo@codeaurora.org>
    7845af35
scan.c 13.3 KB