-
Jan Remmet authored
commit 8f9165c9 upstream. http://www.ti.com/lit/pdf/SWCZ010: DCDC o/p voltage can go higher than programmed value Impact: VDDI, VDD2, and VIO output programmed voltage level can go higher than expected or crash, when coming out of PFM to PWM mode or using DVFS. Description: When DCDC CLK SYNC bits are 11/01: * VIO 3-MHz oscillator is the source clock of the digital core and input clock of VDD1 and VDD2 * Turn-on of VDD1 and VDD2 HSD PFETis synchronized or at a constant phase shift * Current pulled though VCC1+VCC2 is Iload(VDD1) + Iload(VDD2) * The 3 HSD PFET will be turned-on at the same time, causing the highest possible switching noise on the application. This noise level depends on the layout, the VBAT level, and the load current. The noise level increases with improper layout. When DCDC CLK SYNC bits are 00: * VIO 3-MHz oscillator is the source clock of digital core * VDD1 and VDD2 are running on their own 3-MHz oscillator * Current pulled though VCC1+VCC2 average of Iload(VDD1) + Iload(VDD2) * The switching noise of the 3 SMPS will be randomly spread over time, causing lower overall switching noise. Workaround: Set DCDCCTRL_REG[1:0]= 00. Signed-off-by:
Jan Remmet <j.remmet@phytec.de> Signed-off-by:
Mark Brown <broonie@kernel.org> [bwh: Backported to 3.2: use tps65910_clear_bits()] Signed-off-by:
Ben Hutchings <ben@decadent.org.uk>
c2933e8c