-
Lars-Peter Clausen authored
The adv7604 driver platform data contains fields for configuring the drive strength of the output pins. When probing the driver through DT these fields are not explicitly initialized, which means they are left at 0. This is a reserved setting for the drive strength configuration though and can cause signal integrity issues. Whether these signal integrity issues are visible depends on the PCB specifics (e.g. the higher the load capacitance for the output the more visible the issue). But it has been observed on existing solutions at high pixel clock rates. Initialize the drive strength settings to the power-on-reset value of the device when probing through devicetree to avoid this issue. Fixes: 0e158be0162b ("adv7604: Add DT support") Signed-off-by:
Lars-Peter Clausen <lars@metafoo.de> Reviewed-by:
Laurent Pinchart <laurent.pinchart@ideasonboard.com> Tested-by:
Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se> Signed-off-by:
Hans Verkuil <hans.verkuil@cisco.com> Signed-off-by:
Mauro Carvalho Chehab <mchehab@s-opensource.com>
da8892d4