Commit 00c698e0 authored by Sricharan R's avatar Sricharan R Committed by Joerg Roedel

documentation: iommu: Add bindings for msm,iommu-v0 ip

The MSM IOMMU is an implementation compatible with the ARM VMSA short
descriptor page tables. It provides address translation for bus masters outside
of the CPU, each connected to the IOMMU through a port called micro-TLB.
Adding the DT bindings for the same.
Signed-off-by: default avatarSricharan R <sricharan@codeaurora.org>
Acked-by: default avatarRob Herring <robh@kernel.org>
Signed-off-by: default avatarJoerg Roedel <jroedel@suse.de>
parent 109bd48e
* QCOM IOMMU
The MSM IOMMU is an implementation compatible with the ARM VMSA short
descriptor page tables. It provides address translation for bus masters outside
of the CPU, each connected to the IOMMU through a port called micro-TLB.
Required Properties:
- compatible: Must contain "qcom,apq8064-iommu".
- reg: Base address and size of the IOMMU registers.
- interrupts: Specifiers for the MMU fault interrupts. For instances that
support secure mode two interrupts must be specified, for non-secure and
secure mode, in that order. For instances that don't support secure mode a
single interrupt must be specified.
- #iommu-cells: The number of cells needed to specify the stream id. This
is always 1.
- qcom,ncb: The total number of context banks in the IOMMU.
- clocks : List of clocks to be used during SMMU register access. See
Documentation/devicetree/bindings/clock/clock-bindings.txt
for information about the format. For each clock specified
here, there must be a corresponding entry in clock-names
(see below).
- clock-names : List of clock names corresponding to the clocks specified in
the "clocks" property (above).
Should be "smmu_pclk" for specifying the interface clock
required for iommu's register accesses.
Should be "smmu_clk" for specifying the functional clock
required by iommu for bus accesses.
Each bus master connected to an IOMMU must reference the IOMMU in its device
node with the following property:
- iommus: A reference to the IOMMU in multiple cells. The first cell is a
phandle to the IOMMU and the second cell is the stream id.
A single master device can be connected to more than one iommu
and multiple contexts in each of the iommu. So multiple entries
are required to list all the iommus and the stream ids that the
master is connected to.
Example: mdp iommu and its bus master
mdp_port0: iommu@7500000 {
compatible = "qcom,apq8064-iommu";
#iommu-cells = <1>;
clock-names =
"smmu_pclk",
"smmu_clk";
clocks =
<&mmcc SMMU_AHB_CLK>,
<&mmcc MDP_AXI_CLK>;
reg = <0x07500000 0x100000>;
interrupts =
<GIC_SPI 63 0>,
<GIC_SPI 64 0>;
qcom,ncb = <2>;
};
mdp: qcom,mdp@5100000 {
compatible = "qcom,mdp";
...
iommus = <&mdp_port0 0
&mdp_port0 2>;
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment