Commit 02785b1f authored by Liu Gang's avatar Liu Gang Committed by Greg Kroah-Hartman

gpio: mpc8xxx: Correct irq handler function

commit d71cf15b upstream.

From the beginning of the gpio-mpc8xxx.c, the "handle_level_irq"
has being used to handle GPIO interrupts in the PowerPC/Layerscape
platforms. But actually, almost all PowerPC/Layerscape platforms
assert an interrupt request upon either a high-to-low change or
any change on the state of the signal.

So the "handle_level_irq" is not reasonable for PowerPC/Layerscape
GPIO interrupt, it should be "handle_edge_irq". Otherwise the system
may lost some interrupts from the PIN's state changes.
Signed-off-by: default avatarLiu Gang <Gang.Liu@nxp.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 3afd8362
......@@ -329,7 +329,7 @@ static int mpc8xxx_gpio_irq_map(struct irq_domain *h, unsigned int irq,
irq_hw_number_t hwirq)
{
irq_set_chip_data(irq, h->host_data);
irq_set_chip_and_handler(irq, &mpc8xxx_irq_chip, handle_level_irq);
irq_set_chip_and_handler(irq, &mpc8xxx_irq_chip, handle_edge_irq);
return 0;
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment