Commit 0881841f authored by Daniel Lezcano's avatar Daniel Lezcano

clocksource/drivers/tango-xtal: Replace code by clocksource_mmio_init

The current code to initialize, register and read the clocksource is
already factored out in mmio.c via the clocksource_mmio_init function.

Factor out the code with the clocksource_mmio_init function.
Signed-off-by: default avatarDaniel Lezcano <daniel.lezcano@linaro.org>
parent 46e7c3c6
...@@ -351,6 +351,7 @@ config CLKSRC_TANGO_XTAL ...@@ -351,6 +351,7 @@ config CLKSRC_TANGO_XTAL
bool "Clocksource for Tango SoC" if COMPILE_TEST bool "Clocksource for Tango SoC" if COMPILE_TEST
depends on ARM depends on ARM
select CLKSRC_OF select CLKSRC_OF
select CLKSRC_MMIO
help help
This enables the clocksource for Tango SoC This enables the clocksource for Tango SoC
......
...@@ -19,19 +19,6 @@ static u64 notrace read_sched_clock(void) ...@@ -19,19 +19,6 @@ static u64 notrace read_sched_clock(void)
return read_xtal_counter(); return read_xtal_counter();
} }
static cycle_t read_clocksource(struct clocksource *cs)
{
return read_xtal_counter();
}
static struct clocksource tango_xtal = {
.name = "tango-xtal",
.rating = 350,
.read = read_clocksource,
.mask = CLOCKSOURCE_MASK(32),
.flags = CLOCK_SOURCE_IS_CONTINUOUS,
};
static void __init tango_clocksource_init(struct device_node *np) static void __init tango_clocksource_init(struct device_node *np)
{ {
struct clk *clk; struct clk *clk;
...@@ -53,8 +40,9 @@ static void __init tango_clocksource_init(struct device_node *np) ...@@ -53,8 +40,9 @@ static void __init tango_clocksource_init(struct device_node *np)
delay_timer.freq = xtal_freq; delay_timer.freq = xtal_freq;
delay_timer.read_current_timer = read_xtal_counter; delay_timer.read_current_timer = read_xtal_counter;
ret = clocksource_register_hz(&tango_xtal, xtal_freq); ret = clocksource_mmio_init(xtal_in_cnt, "tango-xtal", xtal_freq, 350,
if (ret != 0) { 32, clocksource_mmio_readl_up);
if (!ret) {
pr_err("%s: registration failed\n", np->full_name); pr_err("%s: registration failed\n", np->full_name);
return; return;
} }
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment