Commit 0dafdd16 authored by Laxman Dewangan's avatar Laxman Dewangan Committed by Thierry Reding

pwm: tegra: Add DT binding details to configure pin in suspends/resume

In some of NVIDIA Tegra's platform, PWM controller is used to
control the PWM controlled regulators. PWM signal is connected to
the VID pin of the regulator where duty cycle of PWM signal decide
the voltage level of the regulator output.

When system enters suspend, some PWM client/slave regulator devices
require the PWM output to be tristated.

Add DT binding details to provide the pin configuration state
from PWM and pinctrl DT node in suspend and active state of
the system.
Signed-off-by: default avatarLaxman Dewangan <ldewangan@nvidia.com>
Acked-by: default avatarJon Hunter <jonathanh@nvidia.com>
Acked-by: default avatarRob Herring <robh@kernel.org>
Signed-off-by: default avatarThierry Reding <thierry.reding@gmail.com>
parent 250b76f4
...@@ -19,6 +19,19 @@ Required properties: ...@@ -19,6 +19,19 @@ Required properties:
- reset-names: Must include the following entries: - reset-names: Must include the following entries:
- pwm - pwm
Optional properties:
============================
In some of the interface like PWM based regulator device, it is required
to configure the pins differently in different states, especially in suspend
state of the system. The configuration of pin is provided via the pinctrl
DT node as detailed in the pinctrl DT binding document
Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt
The PWM node will have following optional properties.
pinctrl-names: Pin state names. Must be "default" and "sleep".
pinctrl-0: phandle for the default/active state of pin configurations.
pinctrl-1: phandle for the sleep state of pin configurations.
Example: Example:
pwm: pwm@7000a000 { pwm: pwm@7000a000 {
...@@ -29,3 +42,35 @@ Example: ...@@ -29,3 +42,35 @@ Example:
resets = <&tegra_car 17>; resets = <&tegra_car 17>;
reset-names = "pwm"; reset-names = "pwm";
}; };
Example with the pin configuration for suspend and resume:
=========================================================
Suppose pin PE7 (On Tegra210) interfaced with the regulator device and
it requires PWM output to be tristated when system enters suspend.
Following will be DT binding to achieve this:
#include <dt-bindings/pinctrl/pinctrl-tegra.h>
pinmux@700008d4 {
pwm_active_state: pwm_active_state {
pe7 {
nvidia,pins = "pe7";
nvidia,tristate = <TEGRA_PIN_DISABLE>;
};
};
pwm_sleep_state: pwm_sleep_state {
pe7 {
nvidia,pins = "pe7";
nvidia,tristate = <TEGRA_PIN_ENABLE>;
};
};
};
pwm@7000a000 {
/* Mandatory PWM properties */
pinctrl-names = "default", "sleep";
pinctrl-0 = <&pwm_active_state>;
pinctrl-1 = <&pwm_sleep_state>;
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment