Commit 0dedf901 authored by Vladimir Oltean's avatar Vladimir Oltean Committed by Mark Brown

spi: spi-fsl-dspi: Protect against races on dspi->words_in_flight

dspi->words_in_flight is a variable populated in the *_write functions
and used in the dspi_fifo_read function. It is also used in
dspi_fifo_write, immediately after transmission, to update the
message->actual_length variable used by higher layers such as spi-mem
for integrity checking.

But it may happen that the IRQ which calls dspi_fifo_read to be
triggered before the updating of message->actual_length takes place. In
that case, dspi_fifo_read will decrement dspi->words_in_flight to -1,
and that will cause an invalid modification of message->actual_length.

For that, we make the simplest fix possible: to not decrement the actual
shared variable in dspi->words_in_flight from dspi_fifo_read, but
actually a copy of it which is on stack.

But even if dspi_fifo_read from the next IRQ does not interfere with the
dspi_fifo_write of the current chunk, the *next* dspi_fifo_write still
can. So we must assume that everything after the last write to the TX
FIFO can be preempted by the "TX complete" IRQ, and the dspi_fifo_write
function must be safe against that. This means refactoring the 2
flavours of FIFO writes (for EOQ and XSPI) such that the calculation of
the number of words to be written is common and happens a priori. This
way, the code for updating the message->actual_length variable works
with a copy and not with the volatile dspi->words_in_flight.

After some interior debate, the dspi->progress variable used for
software timestamping was *not* backed up against preemption in a copy
on stack. Because if preemption does occur between
spi_take_timestamp_pre and spi_take_timestamp_post, there's really no
point in trying to save anything. The first-in-time
spi_take_timestamp_post call with a dspi->progress higher than the
requested xfer->ptp_sts_word_post will trigger xfer->timestamped = true
anyway and will close the deal.

To understand the above a bit better, consider a transfer with
xfer->ptp_sts_word_pre = xfer->ptp_sts_word_post = 3, and
xfer->bits_per_words = 8 (so byte 3 needs to be timestamped). The DSPI
controller timestamps in chunks of 4 bytes at a time, and preemption
occurs in the middle of timestamping the first chunk:

  spi_take_timestamp_pre(0)
    .
    . (preemption)
    .
    . spi_take_timestamp_pre(4)
    .
    . spi_take_timestamp_post(7)
    .
  spi_take_timestamp_post(3)

So the reason I'm not bothering to back up dspi->progress for that
spi_take_timestamp_post(3) is that spi_take_timestamp_post(7) is going
to (a) be more honest, (b) provide better accuracy and (c) already
render the spi_take_timestamp_post(3) into a noop by setting
xfer->timestamped = true anyway.

Fixes: d59c90a2 ("spi: spi-fsl-dspi: Convert TCFQ users to XSPI FIFO mode")
Reported-by: default avatarMichael Walle <michael@walle.cc>
Signed-off-by: default avatarVladimir Oltean <vladimir.oltean@nxp.com>
Tested-by: default avatarMichael Walle <michael@walle.cc>
Link: https://lore.kernel.org/r/20200318001603.9650-6-olteanv@gmail.comSigned-off-by: default avatarMark Brown <broonie@kernel.org>
parent c6c1e30a
......@@ -669,17 +669,26 @@ static void dspi_pushr_txdata_write(struct fsl_dspi *dspi, u16 txdata)
regmap_write(dspi->regmap_pushr, dspi->pushr_tx, txdata);
}
static void dspi_xspi_write(struct fsl_dspi *dspi, int cnt, bool eoq)
static void dspi_xspi_fifo_write(struct fsl_dspi *dspi, int num_words)
{
int num_bytes = num_words * dspi->oper_word_size;
u16 tx_cmd = dspi->tx_cmd;
if (eoq)
/*
* If the PCS needs to de-assert (i.e. we're at the end of the buffer
* and cs_change does not want the PCS to stay on), then we need a new
* PUSHR command, since this one (for the body of the buffer)
* necessarily has the CONT bit set.
* So send one word less during this go, to force a split and a command
* with a single word next time, when CONT will be unset.
*/
if (!(dspi->tx_cmd & SPI_PUSHR_CMD_CONT) && num_bytes == dspi->len)
tx_cmd |= SPI_PUSHR_CMD_EOQ;
/* Update CTARE */
regmap_write(dspi->regmap, SPI_CTARE(0),
SPI_FRAME_EBITS(dspi->oper_bits_per_word) |
SPI_CTARE_DTCP(cnt));
SPI_CTARE_DTCP(num_words));
/*
* Write the CMD FIFO entry first, and then the two
......@@ -688,7 +697,7 @@ static void dspi_xspi_write(struct fsl_dspi *dspi, int cnt, bool eoq)
dspi_pushr_cmd_write(dspi, tx_cmd);
/* Fill TX FIFO with as many transfers as possible */
while (cnt--) {
while (num_words--) {
u32 data = dspi_pop_tx(dspi);
dspi_pushr_txdata_write(dspi, data & 0xFFFF);
......@@ -697,58 +706,15 @@ static void dspi_xspi_write(struct fsl_dspi *dspi, int cnt, bool eoq)
}
}
static void dspi_xspi_fifo_write(struct fsl_dspi *dspi)
{
int num_fifo_entries = dspi->devtype_data->fifo_size;
int bytes_in_flight;
bool eoq = false;
/* In XSPI mode each 32-bit word occupies 2 TX FIFO entries */
if (dspi->oper_word_size == 4)
num_fifo_entries /= 2;
/*
* Integer division intentionally trims off odd (or non-multiple of 4)
* numbers of bytes at the end of the buffer, which will be sent next
* time using a smaller oper_word_size.
*/
dspi->words_in_flight = dspi->len / dspi->oper_word_size;
if (dspi->words_in_flight > num_fifo_entries)
dspi->words_in_flight = num_fifo_entries;
bytes_in_flight = dspi->words_in_flight * dspi->oper_word_size;
/*
* If the PCS needs to de-assert (i.e. we're at the end of the buffer
* and cs_change does not want the PCS to stay on), then we need a new
* PUSHR command, since this one (for the body of the buffer)
* necessarily has the CONT bit set.
* So send one word less during this go, to force a split and a command
* with a single word next time, when CONT will be unset.
*/
if (!(dspi->tx_cmd & SPI_PUSHR_CMD_CONT) &&
bytes_in_flight == dspi->len)
eoq = true;
dspi_xspi_write(dspi, dspi->words_in_flight, eoq);
}
static void dspi_eoq_fifo_write(struct fsl_dspi *dspi)
static void dspi_eoq_fifo_write(struct fsl_dspi *dspi, int num_words)
{
int num_fifo_entries = dspi->devtype_data->fifo_size;
u16 xfer_cmd = dspi->tx_cmd;
if (num_fifo_entries * dspi->oper_word_size > dspi->len)
num_fifo_entries = dspi->len / dspi->oper_word_size;
dspi->words_in_flight = num_fifo_entries;
/* Fill TX FIFO with as many transfers as possible */
while (num_fifo_entries--) {
while (num_words--) {
dspi->tx_cmd = xfer_cmd;
/* Request EOQF for last transfer in FIFO */
if (num_fifo_entries == 0)
if (num_words == 0)
dspi->tx_cmd |= SPI_PUSHR_CMD_EOQ;
/* Write combined TX FIFO and CMD FIFO entry */
dspi_pushr_write(dspi);
......@@ -765,8 +731,10 @@ static u32 dspi_popr_read(struct fsl_dspi *dspi)
static void dspi_fifo_read(struct fsl_dspi *dspi)
{
int num_fifo_entries = dspi->words_in_flight;
/* Read one FIFO entry and push to rx buffer */
while (dspi->words_in_flight--)
while (num_fifo_entries--)
dspi_push_rx(dspi, dspi_popr_read(dspi));
}
......@@ -832,23 +800,48 @@ static void dspi_setup_accel(struct fsl_dspi *dspi)
static void dspi_fifo_write(struct fsl_dspi *dspi)
{
int num_fifo_entries = dspi->devtype_data->fifo_size;
struct spi_transfer *xfer = dspi->cur_transfer;
struct spi_message *msg = dspi->cur_msg;
int bytes_sent;
int num_words, num_bytes;
dspi_setup_accel(dspi);
/* In XSPI mode each 32-bit word occupies 2 TX FIFO entries */
if (dspi->oper_word_size == 4)
num_fifo_entries /= 2;
/*
* Integer division intentionally trims off odd (or non-multiple of 4)
* numbers of bytes at the end of the buffer, which will be sent next
* time using a smaller oper_word_size.
*/
num_words = dspi->len / dspi->oper_word_size;
if (num_words > num_fifo_entries)
num_words = num_fifo_entries;
/* Update total number of bytes that were transferred */
num_bytes = num_words * dspi->oper_word_size;
msg->actual_length += num_bytes;
dspi->progress += num_bytes / DIV_ROUND_UP(xfer->bits_per_word, 8);
/*
* Update shared variable for use in the next interrupt (both in
* dspi_fifo_read and in dspi_fifo_write).
*/
dspi->words_in_flight = num_words;
spi_take_timestamp_pre(dspi->ctlr, xfer, dspi->progress, !dspi->irq);
if (dspi->devtype_data->trans_mode == DSPI_EOQ_MODE)
dspi_eoq_fifo_write(dspi);
dspi_eoq_fifo_write(dspi, num_words);
else
dspi_xspi_fifo_write(dspi);
/* Update total number of bytes that were transferred */
bytes_sent = dspi->words_in_flight * dspi->oper_word_size;
msg->actual_length += bytes_sent;
dspi->progress += bytes_sent / DIV_ROUND_UP(xfer->bits_per_word, 8);
dspi_xspi_fifo_write(dspi, num_words);
/*
* Everything after this point is in a potential race with the next
* interrupt, so we must never use dspi->words_in_flight again since it
* might already be modified by the next dspi_fifo_write.
*/
spi_take_timestamp_post(dspi->ctlr, dspi->cur_transfer,
dspi->progress, !dspi->irq);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment