Commit 0f00a206 authored by Lalit Chandivade's avatar Lalit Chandivade Committed by James Bottomley

[SCSI] qla2xxx: Properly handle UNDERRUN completion statuses.

Correct issues where the lower scsi-status would be improperly
cleared, instead, allow the midlayer to process the status after
the proper residual-count checks are performed.  Finally,
validate firmware status flags prior to assigning values from the
FCP_RSP frame.
Signed-off-by: default avatarLalit Chandivade <lalit.chandivade@qlogic.com>
Signed-off-by: default avatarMichael Hernandez <michael.hernandez@qlogic.com>
Signed-off-by: default avatarRavi Anand <ravi.anand@qlogic.com>
Signed-off-by: default avatarAndrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: default avatarGiridhar Malavali <giridhar.malavali@qlogic.com>
Signed-off-by: default avatarJames Bottomley <James.Bottomley@suse.de>
parent 531a82d1
......@@ -1353,16 +1353,22 @@ qla2x00_status_entry(scsi_qla_host_t *vha, struct rsp_que *rsp, void *pkt)
sense_len = rsp_info_len = resid_len = fw_resid_len = 0;
if (IS_FWI2_CAPABLE(ha)) {
sense_len = le32_to_cpu(sts24->sense_len);
rsp_info_len = le32_to_cpu(sts24->rsp_data_len);
resid_len = le32_to_cpu(sts24->rsp_residual_count);
fw_resid_len = le32_to_cpu(sts24->residual_len);
if (scsi_status & SS_SENSE_LEN_VALID)
sense_len = le32_to_cpu(sts24->sense_len);
if (scsi_status & SS_RESPONSE_INFO_LEN_VALID)
rsp_info_len = le32_to_cpu(sts24->rsp_data_len);
if (scsi_status & (SS_RESIDUAL_UNDER | SS_RESIDUAL_OVER))
resid_len = le32_to_cpu(sts24->rsp_residual_count);
if (comp_status == CS_DATA_UNDERRUN)
fw_resid_len = le32_to_cpu(sts24->residual_len);
rsp_info = sts24->data;
sense_data = sts24->data;
host_to_fcp_swap(sts24->data, sizeof(sts24->data));
} else {
sense_len = le16_to_cpu(sts->req_sense_length);
rsp_info_len = le16_to_cpu(sts->rsp_info_len);
if (scsi_status & SS_SENSE_LEN_VALID)
sense_len = le16_to_cpu(sts->req_sense_length);
if (scsi_status & SS_RESPONSE_INFO_LEN_VALID)
rsp_info_len = le16_to_cpu(sts->rsp_info_len);
resid_len = le32_to_cpu(sts->residual_length);
rsp_info = sts->rsp_info;
sense_data = sts->req_sense_data;
......@@ -1449,38 +1455,62 @@ qla2x00_status_entry(scsi_qla_host_t *vha, struct rsp_que *rsp, void *pkt)
break;
case CS_DATA_UNDERRUN:
resid = resid_len;
DEBUG2(printk(KERN_INFO
"scsi(%ld:%d:%d) UNDERRUN status detected 0x%x-0x%x. "
"resid=0x%x fw_resid=0x%x cdb=0x%x os_underflow=0x%x\n",
vha->host_no, cp->device->id, cp->device->lun, comp_status,
scsi_status, resid_len, fw_resid_len, cp->cmnd[0],
cp->underflow));
/* Use F/W calculated residual length. */
if (IS_FWI2_CAPABLE(ha)) {
if (!(scsi_status & SS_RESIDUAL_UNDER)) {
lscsi_status = 0;
} else if (resid != fw_resid_len) {
scsi_status &= ~SS_RESIDUAL_UNDER;
lscsi_status = 0;
resid = IS_FWI2_CAPABLE(ha) ? fw_resid_len : resid_len;
scsi_set_resid(cp, resid);
if (scsi_status & SS_RESIDUAL_UNDER) {
if (IS_FWI2_CAPABLE(ha) && fw_resid_len != resid_len) {
DEBUG2(printk(
"scsi(%ld:%d:%d:%d) Dropped frame(s) "
"detected (%x of %x bytes)...residual "
"length mismatch...retrying command.\n",
vha->host_no, cp->device->channel,
cp->device->id, cp->device->lun, resid,
scsi_bufflen(cp)));
cp->result = DID_ERROR << 16 | lscsi_status;
break;
}
resid = fw_resid_len;
}
if (scsi_status & SS_RESIDUAL_UNDER) {
scsi_set_resid(cp, resid);
} else {
DEBUG2(printk(KERN_INFO
"scsi(%ld:%d:%d) UNDERRUN status detected "
"0x%x-0x%x. resid=0x%x fw_resid=0x%x cdb=0x%x "
"os_underflow=0x%x\n", vha->host_no,
cp->device->id, cp->device->lun, comp_status,
scsi_status, resid_len, resid, cp->cmnd[0],
cp->underflow));
if (!lscsi_status &&
((unsigned)(scsi_bufflen(cp) - resid) <
cp->underflow)) {
qla_printk(KERN_INFO, ha,
"scsi(%ld:%d:%d:%d): Mid-layer underflow "
"detected (%x of %x bytes)...returning "
"error status.\n", vha->host_no,
cp->device->channel, cp->device->id,
cp->device->lun, resid, scsi_bufflen(cp));
cp->result = DID_ERROR << 16;
break;
}
} else if (!lscsi_status) {
DEBUG2(printk(
"scsi(%ld:%d:%d:%d) Dropped frame(s) detected "
"(%x of %x bytes)...firmware reported underrun..."
"retrying command.\n", vha->host_no,
cp->device->channel, cp->device->id,
cp->device->lun, resid, scsi_bufflen(cp)));
cp->result = DID_ERROR << 16;
break;
}
cp->result = DID_OK << 16 | lscsi_status;
/*
* Check to see if SCSI Status is non zero. If so report SCSI
* Status.
*/
if (lscsi_status != 0) {
cp->result = DID_OK << 16 | lscsi_status;
if (lscsi_status == SAM_STAT_TASK_SET_FULL) {
DEBUG2(printk(KERN_INFO
"scsi(%ld): QUEUE FULL status detected "
......@@ -1507,42 +1537,6 @@ qla2x00_status_entry(scsi_qla_host_t *vha, struct rsp_que *rsp, void *pkt)
break;
qla2x00_handle_sense(sp, sense_data, sense_len, rsp);
} else {
/*
* If RISC reports underrun and target does not report
* it then we must have a lost frame, so tell upper
* layer to retry it by reporting an error.
*/
if (!(scsi_status & SS_RESIDUAL_UNDER)) {
DEBUG2(printk("scsi(%ld:%d:%d:%d) Dropped "
"frame(s) detected (%x of %x bytes)..."
"retrying command.\n",
vha->host_no, cp->device->channel,
cp->device->id, cp->device->lun, resid,
scsi_bufflen(cp)));
scsi_set_resid(cp, resid);
cp->result = DID_ERROR << 16;
break;
}
/* Handle mid-layer underflow */
if ((unsigned)(scsi_bufflen(cp) - resid) <
cp->underflow) {
qla_printk(KERN_INFO, ha,
"scsi(%ld:%d:%d:%d): Mid-layer underflow "
"detected (%x of %x bytes)...returning "
"error status.\n", vha->host_no,
cp->device->channel, cp->device->id,
cp->device->lun, resid,
scsi_bufflen(cp));
cp->result = DID_ERROR << 16;
break;
}
/* Everybody online, looking good... */
cp->result = DID_OK << 16;
}
break;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment