arm64: dts: qcom: sdm845: Use UFS reset gpio instead of pinctrl

We use a pinctrl "workaround" to toggle the UFS reset line. Now that UFS
controller can issue the reset, just specify the line as a GPIO and let
it be reset that way.
Signed-off-by: Stephen Boyd <swboyd@chromium.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>

arch/arm64/boot/dts/qcom/sdm845-cheza.dtsi

@@ -701,9 +701,8 @@ &uart9 {
 
 &ufs_mem_hc {
 	status = "okay";
-	pinctrl-names = "init", "default";
-	pinctrl-0 = <&ufs_dev_reset_assert>;
-	pinctrl-1 = <&ufs_dev_reset_deassert>;
+
+	reset-gpios = <&tlmm 150 GPIO_ACTIVE_LOW>;
 
 	vcc-supply = <&src_pp2950_l20a>;
 	vcc-max-microamp = <600000>;
@@ -1258,52 +1257,6 @@ pinconf {
 		};
 	};
 
-	ufs_dev_reset_assert: ufs_dev_reset_assert {
-		config {
-			pins = "ufs_reset";
-			bias-pull-down;		/* default: pull down */
-			/*
-			 * UFS_RESET driver strengths are having
-			 * different values/steps compared to typical
-			 * GPIO drive strengths.
-			 *
-			 * Following table clarifies:
-			 *
-			 * HDRV value | UFS_RESET | Typical GPIO
-			 *   (dec)    |   (mA)    |    (mA)
-			 *     0      |   0.8     |    2
-			 *     1      |   1.55    |    4
-			 *     2      |   2.35    |    6
-			 *     3      |   3.1     |    8
-			 *     4      |   3.9     |    10
-			 *     5      |   4.65    |    12
-			 *     6      |   5.4     |    14
-			 *     7      |   6.15    |    16
-			 *
-			 * POR value for UFS_RESET HDRV is 3 which means
-			 * 3.1mA and we want to use that. Hence just
-			 * specify 8mA to "drive-strength" binding and
-			 * that should result into writing 3 to HDRV
-			 * field.
-			 */
-			drive-strength = <8>;	/* default: 3.1 mA */
-			output-low; /* active low reset */
-		};
-	};
-
-	ufs_dev_reset_deassert: ufs_dev_reset_deassert {
-		config {
-			pins = "ufs_reset";
-			bias-pull-down;		/* default: pull down */
-			/*
-			 * default: 3.1 mA
-			 * check comments under ufs_dev_reset_assert
-			 */
-			drive-strength = <8>;
-			output-high; /* active low reset */
-		};
-	};
-
 	ap_suspend_l_assert: ap_suspend_l_assert {
 		config {
 			pins = "gpio126";