[media] af9035: use default i2c slave address for af9035 too

Some device vendors has forgotten set correct slave demod I2C address
to eeprom. Use default I2C address when eeprom has no address at all.
Signed-off-by: Antti Palosaari <crope@iki.fi>
Signed-off-by: Mauro Carvalho Chehab <m.chehab@samsung.com>

drivers/media/usb/dvb-usb-v2/af9035.c

@@ -575,11 +575,11 @@ static int af9035_download_firmware(struct dvb_usb_device *d,
 		if (ret < 0)
 			goto err;
 
-		if (state->chip_type == 0x9135) {
-			if (!tmp)
-				/* default 0x9135 slave I2C address */
-				tmp = 0x3a;
+		/* use default I2C address if eeprom has no address set */
+		if (!tmp)
+			tmp = 0x3a;
 
+		if (state->chip_type == 0x9135) {
 			ret = af9035_wr_reg(d, 0x004bfb, tmp);
 			if (ret < 0)
 				goto err;
@@ -641,6 +641,7 @@ static int af9035_read_config(struct dvb_usb_device *d)
 
 	/* demod I2C "address" */
 	state->af9033_config[0].i2c_addr = 0x38;
+	state->af9033_config[1].i2c_addr = 0x3a;
 	state->af9033_config[0].adc_multiplier = AF9033_ADC_MULTIPLIER_2X;
 	state->af9033_config[1].adc_multiplier = AF9033_ADC_MULTIPLIER_2X;
 	state->af9033_config[0].ts_mode = AF9033_TS_MODE_USB;
@@ -688,11 +689,9 @@ static int af9035_read_config(struct dvb_usb_device *d)
 		if (ret < 0)
 			goto err;
 
-		if (!tmp && state->chip_type == 0x9135)
-			/* default 0x9135 slave I2C address */
-			tmp = 0x3a;
+		if (tmp)
+			state->af9033_config[1].i2c_addr = tmp;
 
-		state->af9033_config[1].i2c_addr = tmp;
 		dev_dbg(&d->udev->dev, "%s: 2nd demod I2C addr=%02x\n",
 				__func__, tmp);
 	}