[PATCH] depca update

I finally found some time to hack the depca driver, in basically the
same way I did with the de4x5 driver. The patch is quite big (shuffles
a lot of code around, removes lots of global variables), mainly in
order to use the driver model on every bus supported by this driver.

I also removed the probing from Space.c, so the usual warning about
device renumbering applies.

Tested on alpha (DE422, EISA) and i386 (two DE201, ISA), built-in and
modular. The MCA part is completly untested, since I lack the hardware
(no, I do not own every single piece of junk hardware out
there... ;-).

drivers/net/Space.c

@@ -58,7 +58,6 @@ extern int at1500_probe(struct net_device *);
 extern int at1700_probe(struct net_device *);
 extern int fmv18x_probe(struct net_device *);
 extern int eth16i_probe(struct net_device *);
-extern int depca_probe(struct net_device *);
 extern int i82596_probe(struct net_device *);
 extern int ewrk3_probe(struct net_device *);
 extern int el1_probe(struct net_device *);
@@ -252,9 +251,6 @@ static struct devprobe isa_probes[] __initdata = {
 #ifdef CONFIG_EEXPRESS_PRO	/* Intel EtherExpress Pro/10 */
 	{eepro_probe, 0},
 #endif
-#ifdef CONFIG_DEPCA		/* DEC DEPCA */
-	{depca_probe, 0},
-#endif
 #ifdef CONFIG_EWRK3             /* DEC EtherWORKS 3 */
     	{ewrk3_probe, 0},
 #endif