mmc: sdhci: do not try to use 3.3V signaling if not supported

For eMMC devices it is valid to only support 1.8V signaling. When
vqmmc is set to a fixed 1.8V regulator the stack tries to set 3.3V
initially and prints the following warning:
   mmc1: Switching to 3.3V signalling voltage failed

Clear the MMC_SIGNAL_VOLTAGE_330 flag in case 3.3V is signaling is
not available. This prevents the stack from even trying to use
3.3V signaling and avoids the above warning.
Signed-off-by: Stefan Agner <stefan@agner.ch>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

drivers/mmc/host/sdhci.c

@@ -3734,14 +3734,21 @@ int sdhci_setup_host(struct sdhci_host *host)
 	    mmc_gpio_get_cd(host->mmc) < 0)
 		mmc->caps |= MMC_CAP_NEEDS_POLL;
 
-	/* If vqmmc regulator and no 1.8V signalling, then there's no UHS */
 	if (!IS_ERR(mmc->supply.vqmmc)) {
 		ret = regulator_enable(mmc->supply.vqmmc);
+
+		/* If vqmmc provides no 1.8V signalling, then there's no UHS */
 		if (!regulator_is_supported_voltage(mmc->supply.vqmmc, 1700000,
 						    1950000))
 			host->caps1 &= ~(SDHCI_SUPPORT_SDR104 |
 					 SDHCI_SUPPORT_SDR50 |
 					 SDHCI_SUPPORT_DDR50);
+
+		/* In eMMC case vqmmc might be a fixed 1.8V regulator */
+		if (!regulator_is_supported_voltage(mmc->supply.vqmmc, 2700000,
+						    3600000))
+			host->flags &= ~SDHCI_SIGNALING_330;
+
 		if (ret) {
 			pr_warn("%s: Failed to enable vqmmc regulator: %d\n",
 				mmc_hostname(mmc), ret);