mtd: mxc_nand: move ecc strengh setup before nand_scan_tail

commit 4a43faf5 upstream.

Since commit 6a918bad, the mxc_nand driver
fails with:

Driver must set ecc.strength when using hardware ECC

This is because nand_scan_tail checks for correct ecc strength
settings, so we must set them up before nand_scan_tail.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/mtd/nand/mxc_nand.c

@@ -1219,12 +1219,6 @@ static int __init mxcnd_probe(struct platform_device *pdev)
 	if (nfc_is_v21() && mtd->writesize == 4096)
 		this->ecc.layout = &nandv2_hw_eccoob_4k;
 
-	/* second phase scan */
-	if (nand_scan_tail(mtd)) {
-		err = -ENXIO;
-		goto escan;
-	}
-
 	if (this->ecc.mode == NAND_ECC_HW) {
 		if (nfc_is_v1())
 			this->ecc.strength = 1;
@@ -1232,6 +1226,12 @@ static int __init mxcnd_probe(struct platform_device *pdev)
 			this->ecc.strength = (host->eccsize == 4) ? 4 : 8;
 	}
 
+	/* second phase scan */
+	if (nand_scan_tail(mtd)) {
+		err = -ENXIO;
+		goto escan;
+	}
+
 	/* Register the partitions */
 	mtd_device_parse_register(mtd, part_probes, NULL, pdata->parts,
 				  pdata->nr_parts);