RDMA/cxgb3: Program hardware IRD with correct value

Because of a typo in iwch_accept_cr(), the cxgb3 connection handling
code programs the hardware IRD (incoming RDMA read queue depth) with
the value that is passed in for the ORD (outgoing RDMA read queue
depth).  In particular this means that if an application passes in IRD
> 0 and ORD = 0 (which is a completely sane and valid thing to do for
an app that expects only incoming RDMA read requests), then the
hardware will end up programmed with IRD = 0 and the app will fail in
a mysterious way.

Fix this by using "ep->ird" instead of "ep->ord" in the intended place.
Signed-off-by: Roland Dreier <rolandd@cisco.com>
Acked-by: Steve Wise <swise@opengridcomputing.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

drivers/infiniband/hw/cxgb3/iwch_cm.c

@@ -1745,7 +1745,7 @@ int iwch_accept_cr(struct iw_cm_id *cm_id, struct iw_cm_conn_param *conn_param)
 
 	/* bind QP to EP and move to RTS */
 	attrs.mpa_attr = ep->mpa_attr;
-	attrs.max_ird = ep->ord;
+	attrs.max_ird = ep->ird;
 	attrs.max_ord = ep->ord;
 	attrs.llp_stream_handle = ep;
 	attrs.next_state = IWCH_QP_STATE_RTS;