Commit 20e5c748 authored by Mark Brown's avatar Mark Brown

Merge remote-tracking branches 'spi/fix/atmel', 'spi/fix/bcm63xx',...

Merge remote-tracking branches 'spi/fix/atmel', 'spi/fix/bcm63xx', 'spi/fix/doc', 'spi/fix/fsl-dspi' and 'spi/fix/ti-qspi' into spi-linus
......@@ -457,6 +457,7 @@ config SPI_OMAP24XX
config SPI_TI_QSPI
tristate "DRA7xxx QSPI controller support"
depends on HAS_DMA
depends on ARCH_OMAP2PLUS || COMPILE_TEST
help
QSPI master controller for DRA7xxx used for flash devices.
......
......@@ -269,6 +269,7 @@ struct atmel_spi_caps {
bool is_spi2;
bool has_wdrbt;
bool has_dma_support;
bool has_pdc_support;
};
/*
......@@ -1426,7 +1427,28 @@ static void atmel_get_caps(struct atmel_spi *as)
as->caps.is_spi2 = version > 0x121;
as->caps.has_wdrbt = version >= 0x210;
#ifdef CONFIG_SOC_SAM_V4_V5
/*
* Atmel SoCs based on ARM9 (SAM9x) cores should not use spi_map_buf()
* since this later function tries to map buffers with dma_map_sg()
* even if they have not been allocated inside DMA-safe areas.
* On SoCs based on Cortex A5 (SAMA5Dx), it works anyway because for
* those ARM cores, the data cache follows the PIPT model.
* Also the L2 cache controller of SAMA5D2 uses the PIPT model too.
* In case of PIPT caches, there cannot be cache aliases.
* However on ARM9 cores, the data cache follows the VIVT model, hence
* the cache aliases issue can occur when buffers are allocated from
* DMA-unsafe areas, by vmalloc() for instance, where cache coherency is
* not taken into account or at least not handled completely (cache
* lines of aliases are not invalidated).
* This is not a theorical issue: it was reproduced when trying to mount
* a UBI file-system on a at91sam9g35ek board.
*/
as->caps.has_dma_support = false;
#else
as->caps.has_dma_support = version >= 0x212;
#endif
as->caps.has_pdc_support = version < 0x212;
}
/*-------------------------------------------------------------------------*/
......@@ -1567,7 +1589,7 @@ static int atmel_spi_probe(struct platform_device *pdev)
} else if (ret == -EPROBE_DEFER) {
return ret;
}
} else {
} else if (as->caps.has_pdc_support) {
as->use_pdc = true;
}
......
......@@ -484,6 +484,7 @@ static const struct of_device_id bcm63xx_hsspi_of_match[] = {
{ .compatible = "brcm,bcm6328-hsspi", },
{ },
};
MODULE_DEVICE_TABLE(of, bcm63xx_hsspi_of_match);
static struct platform_driver bcm63xx_hsspi_driver = {
.driver = {
......
......@@ -1032,7 +1032,8 @@ static int dspi_probe(struct platform_device *pdev)
goto out_master_put;
if (dspi->devtype_data->trans_mode == DSPI_DMA_MODE) {
if (dspi_request_dma(dspi, res->start)) {
ret = dspi_request_dma(dspi, res->start);
if (ret < 0) {
dev_err(&pdev->dev, "can't get dma channels\n");
goto out_clk_put;
}
......
......@@ -2021,7 +2021,7 @@ static void devm_spi_unregister(struct device *dev, void *res)
}
/**
* dev_spi_register_master - register managed SPI master controller
* devm_spi_register_master - register managed SPI master controller
* @dev: device managing SPI master
* @master: initialized master, originally from spi_alloc_master()
* Context: can sleep
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment