[PATCH] libata: Marvell SATA support (PIO mode)

This is my libata compatible low level driver for the Marvell SATA
family.  Currently it successfully runs in PIO mode on a 6081 chip.
EDMA support is in the works and should be done shortly.  Review,
testing (especially on other flavors of Marvell), comments welcome.
Signed-off-by: Brett Russ <russb@emc.com>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

drivers/scsi/Kconfig

@@ -459,6 +459,15 @@ config SCSI_ATA_PIIX
 
 	  If unsure, say N.
 
+config SCSI_SATA_MV
+	tristate "Marvell SATA support"
+	depends on SCSI_SATA && PCI && EXPERIMENTAL
+	help
+	  This option enables support for the Marvell Serial ATA family.
+	  Currently supports 88SX[56]0[48][01] chips.
+
+	  If unsure, say N.
+
 config SCSI_SATA_NV
 	tristate "NVIDIA SATA support"
 	depends on SCSI_SATA && PCI && EXPERIMENTAL

drivers/scsi/Makefile

@@ -132,6 +132,7 @@ obj-$(CONFIG_SCSI_SATA_SIS)	+= libata.o sata_sis.o
 obj-$(CONFIG_SCSI_SATA_SX4)	+= libata.o sata_sx4.o
 obj-$(CONFIG_SCSI_SATA_NV)	+= libata.o sata_nv.o
 obj-$(CONFIG_SCSI_SATA_ULI)	+= libata.o sata_uli.o
+obj-$(CONFIG_SCSI_SATA_MV)	+= libata.o sata_mv.o
 
 obj-$(CONFIG_ARM)		+= arm/