Commit 2e84d8db authored by Marcel Holtmann's avatar Marcel Holtmann Committed by Johan Hedberg

Bluetooth: Mark controller is down when HCI_AUTO_OFF is set

During the initial setup phase, the controller is powered on and will
be powered off again if it is not used within the auto-off timeout.

Userspace using ioctl does not know about the difference between the
initial setup phase and a controller being present. It is a bad idea
to keep the controller powered by just looking at the device list or
device information. Instead just tell userspace that the controller
is still down.
Signed-off-by: default avatarMarcel Holtmann <marcel@holtmann.org>
Signed-off-by: default avatarJohan Hedberg <johan.hedberg@intel.com>
parent 13a779e4
......@@ -2817,14 +2817,20 @@ int hci_get_dev_list(void __user *arg)
read_lock(&hci_dev_list_lock);
list_for_each_entry(hdev, &hci_dev_list, list) {
if (test_and_clear_bit(HCI_AUTO_OFF, &hdev->dev_flags))
cancel_delayed_work(&hdev->power_off);
unsigned long flags = hdev->flags;
/* When the auto-off is configured it means the transport
* is running, but in that case still indicate that the
* device is actually down.
*/
if (test_bit(HCI_AUTO_OFF, &hdev->dev_flags))
flags &= ~BIT(HCI_UP);
if (!test_bit(HCI_MGMT, &hdev->dev_flags))
set_bit(HCI_PAIRABLE, &hdev->dev_flags);
(dr + n)->dev_id = hdev->id;
(dr + n)->dev_opt = hdev->flags;
(dr + n)->dev_opt = flags;
if (++n >= dev_num)
break;
......@@ -2844,6 +2850,7 @@ int hci_get_dev_info(void __user *arg)
{
struct hci_dev *hdev;
struct hci_dev_info di;
unsigned long flags;
int err = 0;
if (copy_from_user(&di, arg, sizeof(di)))
......@@ -2853,8 +2860,14 @@ int hci_get_dev_info(void __user *arg)
if (!hdev)
return -ENODEV;
if (test_and_clear_bit(HCI_AUTO_OFF, &hdev->dev_flags))
cancel_delayed_work_sync(&hdev->power_off);
/* When the auto-off is configured it means the transport
* is running, but in that case still indicate that the
* device is actually down.
*/
if (test_bit(HCI_AUTO_OFF, &hdev->dev_flags))
flags = hdev->flags & ~BIT(HCI_UP);
else
flags = hdev->flags;
if (!test_bit(HCI_MGMT, &hdev->dev_flags))
set_bit(HCI_PAIRABLE, &hdev->dev_flags);
......@@ -2862,7 +2875,7 @@ int hci_get_dev_info(void __user *arg)
strcpy(di.name, hdev->name);
di.bdaddr = hdev->bdaddr;
di.type = (hdev->bus & 0x0f) | ((hdev->dev_type & 0x03) << 4);
di.flags = hdev->flags;
di.flags = flags;
di.pkt_type = hdev->pkt_type;
if (lmp_bredr_capable(hdev)) {
di.acl_mtu = hdev->acl_mtu;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment