Commit 33b9108f authored by Linus Torvalds's avatar Linus Torvalds

Merge tag 'spi-fix-v5.8-rc5' of...

Merge tag 'spi-fix-v5.8-rc5' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi into master

Pull spi fixes from Mark Brown:
 "A couple of small driver specific fixes for fairly minor issues"

* tag 'spi-fix-v5.8-rc5' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi:
  spi: spi-sun6i: sun6i_spi_transfer_one(): fix setting of clock rate
  spi: mediatek: use correct SPI_CFG2_REG MACRO
parents 8da822e8 ed7815db
......@@ -36,7 +36,6 @@
#define SPI_CFG0_SCK_LOW_OFFSET 8
#define SPI_CFG0_CS_HOLD_OFFSET 16
#define SPI_CFG0_CS_SETUP_OFFSET 24
#define SPI_ADJUST_CFG0_SCK_LOW_OFFSET 16
#define SPI_ADJUST_CFG0_CS_HOLD_OFFSET 0
#define SPI_ADJUST_CFG0_CS_SETUP_OFFSET 16
......@@ -48,6 +47,8 @@
#define SPI_CFG1_CS_IDLE_MASK 0xff
#define SPI_CFG1_PACKET_LOOP_MASK 0xff00
#define SPI_CFG1_PACKET_LENGTH_MASK 0x3ff0000
#define SPI_CFG2_SCK_HIGH_OFFSET 0
#define SPI_CFG2_SCK_LOW_OFFSET 16
#define SPI_CMD_ACT BIT(0)
#define SPI_CMD_RESUME BIT(1)
......@@ -283,7 +284,7 @@ static void mtk_spi_set_cs(struct spi_device *spi, bool enable)
static void mtk_spi_prepare_transfer(struct spi_master *master,
struct spi_transfer *xfer)
{
u32 spi_clk_hz, div, sck_time, cs_time, reg_val = 0;
u32 spi_clk_hz, div, sck_time, cs_time, reg_val;
struct mtk_spi *mdata = spi_master_get_devdata(master);
spi_clk_hz = clk_get_rate(mdata->spi_clk);
......@@ -296,18 +297,18 @@ static void mtk_spi_prepare_transfer(struct spi_master *master,
cs_time = sck_time * 2;
if (mdata->dev_comp->enhance_timing) {
reg_val = (((sck_time - 1) & 0xffff)
<< SPI_CFG2_SCK_HIGH_OFFSET);
reg_val |= (((sck_time - 1) & 0xffff)
<< SPI_CFG0_SCK_HIGH_OFFSET);
reg_val |= (((sck_time - 1) & 0xffff)
<< SPI_ADJUST_CFG0_SCK_LOW_OFFSET);
<< SPI_CFG2_SCK_LOW_OFFSET);
writel(reg_val, mdata->base + SPI_CFG2_REG);
reg_val |= (((cs_time - 1) & 0xffff)
reg_val = (((cs_time - 1) & 0xffff)
<< SPI_ADJUST_CFG0_CS_HOLD_OFFSET);
reg_val |= (((cs_time - 1) & 0xffff)
<< SPI_ADJUST_CFG0_CS_SETUP_OFFSET);
writel(reg_val, mdata->base + SPI_CFG0_REG);
} else {
reg_val |= (((sck_time - 1) & 0xff)
reg_val = (((sck_time - 1) & 0xff)
<< SPI_CFG0_SCK_HIGH_OFFSET);
reg_val |= (((sck_time - 1) & 0xff) << SPI_CFG0_SCK_LOW_OFFSET);
reg_val |= (((cs_time - 1) & 0xff) << SPI_CFG0_CS_HOLD_OFFSET);
......
......@@ -198,7 +198,7 @@ static int sun6i_spi_transfer_one(struct spi_master *master,
struct spi_transfer *tfr)
{
struct sun6i_spi *sspi = spi_master_get_devdata(master);
unsigned int mclk_rate, div, timeout;
unsigned int mclk_rate, div, div_cdr1, div_cdr2, timeout;
unsigned int start, end, tx_time;
unsigned int trig_level;
unsigned int tx_len = 0;
......@@ -287,14 +287,12 @@ static int sun6i_spi_transfer_one(struct spi_master *master,
* First try CDR2, and if we can't reach the expected
* frequency, fall back to CDR1.
*/
div = mclk_rate / (2 * tfr->speed_hz);
if (div <= (SUN6I_CLK_CTL_CDR2_MASK + 1)) {
if (div > 0)
div--;
reg = SUN6I_CLK_CTL_CDR2(div) | SUN6I_CLK_CTL_DRS;
div_cdr1 = DIV_ROUND_UP(mclk_rate, tfr->speed_hz);
div_cdr2 = DIV_ROUND_UP(div_cdr1, 2);
if (div_cdr2 <= (SUN6I_CLK_CTL_CDR2_MASK + 1)) {
reg = SUN6I_CLK_CTL_CDR2(div_cdr2 - 1) | SUN6I_CLK_CTL_DRS;
} else {
div = ilog2(mclk_rate) - ilog2(tfr->speed_hz);
div = min(SUN6I_CLK_CTL_CDR1_MASK, order_base_2(div_cdr1));
reg = SUN6I_CLK_CTL_CDR1(div);
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment