ARM: tegra: Add reset GPIO information to PHY DT node

As reset GPIO information is PHY specific detail, adding
it to PHY DT node.
Signed-off-by: Venu Byravarasu <vbyravarasu@nvidia.com>
Signed-off-by: Stephen Warren <swarren@nvidia.com>

Documentation/devicetree/bindings/usb/nvidia,tegra20-usb-phy.txt

@@ -7,6 +7,9 @@ Required properties :
  - reg : Address and length of the register set for the USB PHY interface.
  - phy_type : Should be one of "ulpi" or "utmi".
 
+Required properties for phy_type == ulpi:
+  - nvidia,phy-reset-gpio : The GPIO used to reset the PHY.
+
 Optional properties:
   - nvidia,has-legacy-mode : boolean indicates whether this controller can
     operate in legacy mode (as APX 2500 / 2600). In legacy mode some

arch/arm/boot/dts/tegra20-harmony.dts

@@ -432,6 +432,10 @@ usb@c5008000 {
 		status = "okay";
 	};
 
+	usb-phy@c5004400 {
+		nvidia,phy-reset-gpio = <&gpio 169 0>; /* gpio PV1 */
+	};
+
 	sdhci@c8000200 {
 		status = "okay";
 		cd-gpios = <&gpio 69 0>; /* gpio PI5 */

arch/arm/boot/dts/tegra20-paz00.dts

@@ -420,6 +420,10 @@ usb@c5008000 {
 		status = "okay";
 	};
 
+	usb-phy@c5004400 {
+		nvidia,phy-reset-gpio = <&gpio 168 0>; /* gpio PV0 */
+	};
+
 	sdhci@c8000000 {
 		status = "okay";
 		cd-gpios = <&gpio 173 0>; /* gpio PV5 */

arch/arm/boot/dts/tegra20-seaboard.dts

@@ -561,6 +561,10 @@ usb@c5008000 {
 		status = "okay";
 	};
 
+	usb-phy@c5004400 {
+		nvidia,phy-reset-gpio = <&gpio 169 0>; /* gpio PV1 */
+	};
+
 	sdhci@c8000000 {
 		status = "okay";
 		power-gpios = <&gpio 86 0>; /* gpio PK6 */

arch/arm/boot/dts/tegra20-trimslice.dts

@@ -310,6 +310,10 @@ usb@c5008000 {
 		status = "okay";
 	};
 
+	usb-phy@c5004400 {
+		nvidia,phy-reset-gpio = <&gpio 168 0>; /* gpio PV0 */
+	};
+
 	sdhci@c8000000 {
 		status = "okay";
 		bus-width = <4>;

arch/arm/boot/dts/tegra20-ventana.dts

@@ -497,6 +497,10 @@ usb@c5008000 {
 		status = "okay";
 	};
 
+	usb-phy@c5004400 {
+		nvidia,phy-reset-gpio = <&gpio 169 0>; /* gpio PV1 */
+	};
+
 	sdhci@c8000000 {
 		status = "okay";
 		power-gpios = <&gpio 86 0>; /* gpio PK6 */