arm64: dts: imx8mq-evk: Add remote control

Add remote control to i.MX8M EVK device tree.

The rc protocol must be selected by writing to:
/sys/devices/platform/ir-receiver/rc/rc0/protocols

On my tests, I used "nec" rc protocol:
echo nec > protocols

Tested using evetest:
evtest /dev/input/event0

Output log for each key pressed:
Event:
time 1568122608.267845, -------------- SYN_REPORT ------------
Event:
time 1568122610.503835, type 4 (EV_MSC), code 4 (MSC_SCAN), value 440
Signed-off-by: Rogerio Pimentel da Silva <rpimentel.silva@gmail.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

arch/arm64/boot/dts/freescale/imx8mq-evk.dts

@@ -52,6 +52,13 @@ buck2_reg: regulator-buck2 {
 		regulator-always-on;
 	};
 
+	ir-receiver {
+		compatible = "gpio-ir-receiver";
+		gpios = <&gpio1 12 GPIO_ACTIVE_LOW>;
+		pinctrl-names = "default";
+		pinctrl-0 = <&pinctrl_ir>;
+	};
+
 	wm8524: audio-codec {
 		#sound-dai-cells = <0>;
 		compatible = "wlf,wm8524";
@@ -346,6 +353,12 @@ MX8MQ_IOMUXC_I2C1_SDA_I2C1_SDA			0x4000007f
 		>;
 	};
 
+	pinctrl_ir: irgrp {
+		fsl,pins = <
+			MX8MQ_IOMUXC_GPIO1_IO12_GPIO1_IO12		0x4f
+		>;
+	};
+
 	pinctrl_pcie0: pcie0grp {
 		fsl,pins = <
 			MX8MQ_IOMUXC_I2C4_SCL_PCIE1_CLKREQ_B		0x76