Commit 4353318e authored by Steve Glendinning's avatar Steve Glendinning

arm: convert pcm037 platform to use smsc911x

Updated to also specify SMSC911X_FORCE_INTERNAL_PHY, as the external phy
detection hardware strap is incorrectly pulled high on this platform.
Signed-off-by: default avatarSteve Glendinning <steve.glendinning@smsc.com>
Acked-by: default avatarSascha Hauer <s.hauer@pengutronix.de>
Tested-by: default avatarSascha Hauer <s.hauer@pengutronix.de>
parent 833bb304
......@@ -24,7 +24,7 @@
#include <linux/mtd/plat-ram.h>
#include <linux/memory.h>
#include <linux/gpio.h>
#include <linux/smc911x.h>
#include <linux/smsc911x.h>
#include <linux/interrupt.h>
#include <linux/i2c.h>
#include <linux/i2c/at24.h>
......@@ -70,7 +70,7 @@ static struct imxuart_platform_data uart_pdata = {
.flags = IMXUART_HAVE_RTSCTS,
};
static struct resource smc911x_resources[] = {
static struct resource smsc911x_resources[] = {
[0] = {
.start = CS1_BASE_ADDR + 0x300,
.end = CS1_BASE_ADDR + 0x300 + SZ_64K - 1,
......@@ -79,22 +79,25 @@ static struct resource smc911x_resources[] = {
[1] = {
.start = IOMUX_TO_IRQ(MX31_PIN_GPIO3_1),
.end = IOMUX_TO_IRQ(MX31_PIN_GPIO3_1),
.flags = IORESOURCE_IRQ,
.flags = IORESOURCE_IRQ | IORESOURCE_IRQ_LOWLEVEL,
},
};
static struct smc911x_platdata smc911x_info = {
.flags = SMC911X_USE_32BIT,
.irq_flags = IRQF_SHARED | IRQF_TRIGGER_LOW,
static struct smsc911x_platform_config smsc911x_info = {
.flags = SMSC911X_USE_32BIT | SMSC911X_FORCE_INTERNAL_PHY |
SMSC911X_SAVE_MAC_ADDRESS,
.irq_polarity = SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
.irq_type = SMSC911X_IRQ_TYPE_OPEN_DRAIN,
.phy_interface = PHY_INTERFACE_MODE_MII,
};
static struct platform_device pcm037_eth = {
.name = "smc911x",
.name = "smsc911x",
.id = -1,
.num_resources = ARRAY_SIZE(smc911x_resources),
.resource = smc911x_resources,
.num_resources = ARRAY_SIZE(smsc911x_resources),
.resource = smsc911x_resources,
.dev = {
.platform_data = &smc911x_info,
.platform_data = &smsc911x_info,
},
};
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment