gpio: mpc8xxx: Correct irq handler function

commit d71cf15b upstream.

From the beginning of the gpio-mpc8xxx.c, the "handle_level_irq"
has being used to handle GPIO interrupts in the PowerPC/Layerscape
platforms. But actually, almost all PowerPC/Layerscape platforms
assert an interrupt request upon either a high-to-low change or
any change on the state of the signal.

So the "handle_level_irq" is not reasonable for PowerPC/Layerscape
GPIO interrupt, it should be "handle_edge_irq". Otherwise the system
may lost some interrupts from the PIN's state changes.
Signed-off-by: Liu Gang <Gang.Liu@nxp.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Willy Tarreau <w@1wt.eu>

drivers/gpio/gpio-mpc8xxx.c

@@ -295,7 +295,7 @@ static int mpc8xxx_gpio_irq_map(struct irq_domain *h, unsigned int virq,
 		mpc8xxx_irq_chip.irq_set_type = mpc8xxx_gc->of_dev_id_data;
 
 	irq_set_chip_data(virq, h->host_data);
-	irq_set_chip_and_handler(virq, &mpc8xxx_irq_chip, handle_level_irq);
+	irq_set_chip_and_handler(virq, &mpc8xxx_irq_chip, handle_edge_irq);
 
 	return 0;
 }