Commit 48dfcde4 authored by Stephen Hemminger's avatar Stephen Hemminger Committed by David S. Miller

8139: convert to net_device_ops

Convert to new network device ops interface.
Signed-off-by: default avatarStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 8b4ab28d
......@@ -1817,6 +1817,25 @@ static void cp_set_d3_state (struct cp_private *cp)
pci_set_power_state (cp->pdev, PCI_D3hot);
}
static const struct net_device_ops cp_netdev_ops = {
.ndo_open = cp_open,
.ndo_stop = cp_close,
.ndo_validate_addr = eth_validate_addr,
.ndo_set_multicast_list = cp_set_rx_mode,
.ndo_get_stats = cp_get_stats,
.ndo_do_ioctl = cp_ioctl,
.ndo_tx_timeout = cp_tx_timeout,
#if CP_VLAN_TAG_USED
.ndo_vlan_rx_register = cp_vlan_rx_register,
#endif
#ifdef BROKEN
.ndo_change_mtu = cp_change_mtu,
#endif
#ifdef CONFIG_NET_POLL_CONTROLLER
.ndo_poll_controller = cp_poll_controller,
#endif
};
static int cp_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
{
struct net_device *dev;
......@@ -1929,26 +1948,14 @@ static int cp_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
cpu_to_le16(read_eeprom (regs, i + 7, addr_len));
memcpy(dev->perm_addr, dev->dev_addr, dev->addr_len);
dev->open = cp_open;
dev->stop = cp_close;
dev->set_multicast_list = cp_set_rx_mode;
dev->netdev_ops = &cp_netdev_ops;
dev->hard_start_xmit = cp_start_xmit;
dev->get_stats = cp_get_stats;
dev->do_ioctl = cp_ioctl;
#ifdef CONFIG_NET_POLL_CONTROLLER
dev->poll_controller = cp_poll_controller;
#endif
netif_napi_add(dev, &cp->napi, cp_rx_poll, 16);
#ifdef BROKEN
dev->change_mtu = cp_change_mtu;
#endif
dev->ethtool_ops = &cp_ethtool_ops;
dev->tx_timeout = cp_tx_timeout;
dev->watchdog_timeo = TX_TIMEOUT;
#if CP_VLAN_TAG_USED
dev->features |= NETIF_F_HW_VLAN_TX | NETIF_F_HW_VLAN_RX;
dev->vlan_rx_register = cp_vlan_rx_register;
#endif
if (pci_using_dac)
......
......@@ -916,6 +916,19 @@ static int __devinit rtl8139_init_board (struct pci_dev *pdev,
return rc;
}
static const struct net_device_ops rtl8139_netdev_ops = {
.ndo_open = rtl8139_open,
.ndo_stop = rtl8139_close,
.ndo_get_stats = rtl8139_get_stats,
.ndo_validate_addr = eth_validate_addr,
.ndo_set_multicast_list = rtl8139_set_rx_mode,
.ndo_do_ioctl = netdev_ioctl,
.ndo_tx_timeout = rtl8139_tx_timeout,
#ifdef CONFIG_NET_POLL_CONTROLLER
.ndo_poll_controller = rtl8139_poll_controller,
#endif
};
static int __devinit rtl8139_init_one (struct pci_dev *pdev,
const struct pci_device_id *ent)
......@@ -976,19 +989,11 @@ static int __devinit rtl8139_init_one (struct pci_dev *pdev,
memcpy(dev->perm_addr, dev->dev_addr, dev->addr_len);
/* The Rtl8139-specific entries in the device structure. */
dev->open = rtl8139_open;
dev->hard_start_xmit = rtl8139_start_xmit;
netif_napi_add(dev, &tp->napi, rtl8139_poll, 64);
dev->stop = rtl8139_close;
dev->get_stats = rtl8139_get_stats;
dev->set_multicast_list = rtl8139_set_rx_mode;
dev->do_ioctl = netdev_ioctl;
dev->netdev_ops = &rtl8139_netdev_ops;
dev->ethtool_ops = &rtl8139_ethtool_ops;
dev->tx_timeout = rtl8139_tx_timeout;
dev->watchdog_timeo = TX_TIMEOUT;
#ifdef CONFIG_NET_POLL_CONTROLLER
dev->poll_controller = rtl8139_poll_controller;
#endif
dev->hard_start_xmit = rtl8139_start_xmit;
netif_napi_add(dev, &tp->napi, rtl8139_poll, 64);
/* note: the hardware is not capable of sg/csum/highdma, however
* through the use of skb_copy_and_csum_dev we enable these
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment