octeon_mgmt: Fix MIX registers configuration on MTU setup

octeon_mgmt driver doesn't drop RX frames that are 1-4 bytes bigger than
MTU set for the corresponding interface. The problem is in the
AGL_GMX_RX0/1_FRM_MAX register setting, which should not account for VLAN
tagging.

According to Octeon HW manual:
"For tagged frames, MAX increases by four bytes for each VLAN found up to a
maximum of two VLANs, or MAX + 8 bytes."

OCTEON_FRAME_HEADER_LEN "define" is fine for ring buffer management, but
should not be used for AGL_GMX_RX0/1_FRM_MAX.

The problem could be easily reproduced using "ping" command. If affected
system has default MTU 1500, other host (having MTU >= 1504) can
successfully "ping" the affected system with payload size 1473-1476,
resulting in IP packets of size 1501-1504 accepted by the mgmt driver.
Fixed system still accepts IP packets of 1500 bytes even with VLAN tagging,
because the limits are lifted in HW as expected, for every VLAN tag.
Signed-off-by: Alexander Sverdlin <alexander.sverdlin@nokia.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/cavium/octeon/octeon_mgmt.c

@@ -643,13 +643,21 @@ static int octeon_mgmt_set_mac_address(struct net_device *netdev, void *addr)
 static int octeon_mgmt_change_mtu(struct net_device *netdev, int new_mtu)
 {
 	struct octeon_mgmt *p = netdev_priv(netdev);
-	int size_without_fcs = new_mtu + OCTEON_MGMT_RX_HEADROOM;
+	int max_packet = new_mtu + ETH_HLEN + ETH_FCS_LEN;
 
 	netdev->mtu = new_mtu;
 
-	cvmx_write_csr(p->agl + AGL_GMX_RX_FRM_MAX, size_without_fcs);
+	/* HW lifts the limit if the frame is VLAN tagged
+	 * (+4 bytes per each tag, up to two tags)
+	 */
+	cvmx_write_csr(p->agl + AGL_GMX_RX_FRM_MAX, max_packet);
+	/* Set the hardware to truncate packets larger than the MTU. The jabber
+	 * register must be set to a multiple of 8 bytes, so round up. JABBER is
+	 * an unconditional limit, so we need to account for two possible VLAN
+	 * tags.
+	 */
 	cvmx_write_csr(p->agl + AGL_GMX_RX_JABBER,
-		       (size_without_fcs + 7) & 0xfff8);
+		       (max_packet + 7 + VLAN_HLEN * 2) & 0xfff8);
 
 	return 0;
 }